Source author record

John S. McCloy

John S. McCloy appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

2works
2topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2022arXiv

Alloyed B-(AlxGa1-x)2O3 bulk Czochralski single B-(Al0.1Ga0.9)2O3 and polycrystals B-(Al0.33Ga0.66)2O3, B-(Al0.5Ga0.5)2O3), and property trends

In this work, bulk Czochralski-grown single crystals of 10 mol. % Al2O3 alloyed B-Ga2O3 - monoclinic 10% AGO or B-(Al0.1Ga0.9)2O3 - are obtained, which show +0.20 eV increase in the bandgap compared with unintentionally doped B-Ga2O3. Further, growths of 33% AGO - B-(Al0.33Ga0.67)2O3 - and 50% AGO - B-(Al0.5Ga0.5)2O3 or B-AlGaO3 - produce polycrystalline single-phase monoclinic material (B-AGO). All three compositions are investigated by x-ray diffraction, Raman spectroscopy, optical absorption, and 27Al nuclear magnetic resonance (NMR). By investigating single phase B-AGO over a large range of Al2O3 concentrations (10 - 50 mol. %), broad trends in the lattice parameter, vibrational modes, optical bandgap, and crystallographic site preference are determined. All lattice parameters show a linear trend with Al incorporation. According to NMR, aluminum incorporates on both crystallographic sites of B-Ga2O3, with a slight preference for the octahedral (GaII) site, which becomes more disordered with increasing Al. Single crystals of 10% AGO were also characterized by x-ray rocking curve, transmission electron microscopy, purity (glow discharge mass spectroscopy and x-ray fluorescence), optical transmission (200 nm - 20 um wavelengths), and resistivity. These measurements suggest that electrical compensation by impurity acceptor doping is not the likely explanation for high resistivity, but rather the shift of a hydrogen level from a shallow donor to a deep acceptor due to Al alloying. .. Cont. This article may be downloaded for personal use only. Any other use requires prior permission of the author and AIP Publishing. This article appeared in Journal of Applied Physics 131 155702.

preprint2013arXiv

Ion irradiation of Fe-Fe oxide core-shell nanocluster films: Effect of interface on stability of magnetic properties

A cluster deposition method was used to produce films of loosely aggregated nanoclusters (NC) of Fe core-Fe3O4 shell or fully oxidized Fe3O4. Films of these NC on Si(100) or MgO(100)/Fe3O4(100) were irradiated to 10^16 Si2+/cm2 near room temperature using an ion accelerator. Ion irradiation creates structural change in the NC film with corresponding chemical and magnetic changes which depend on the initial oxidation state of the cluster. Films were characterized using magnetometry (hysteresis, first order reversal curves), microscopy (transmission electron, helium ion), and x-ray diffraction. In all cases, the particle sizes increased due to ion irradiation, and when a core of Fe is present, irradiation reduces the oxide shells to lower valent Fe species. These results show that ion irradiated behavior of the nanocluster films depends strongly on the initial nanostructure and chemistry, but in general saturation magnetization decreases slightly.