Source author record

Jinsong Huang

Jinsong Huang appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci physics.app-ph physics.chem-ph

Catalog footprint

What is connected

3works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

Response to comment on "Resolving spatial and energetic distributions of trap states in metal halide perovskite solar cells"

Ravishankar et al. claimed the drive-level capacitance profiling (DLCP) method cannot resolve trap density along depth direction in perovskites with given thickness, and explained the measured charges to be a consequence of geometrical capacitance and diffusion capacitance. We point out that the trap densities in DLCP method are derived from the differential capacitance at different frequencies, and thus the background charges caused by diffusion and geometry capacitance has been subtracted. Even for the non-differential doping analysis by DLCP, the contribution from diffusion capacitance is shown to be negligible and contribution from geometry capacitance is excluded. Additional experiment results further support the measured trap density represents the actual trap distribution in perovskite solar cells.

preprint2019arXiv

Comparative studies of optoelectrical properties of prominent PV materials: Halide Perovskite, CdTe, and GaAs

We compare three representative high performance PV materials: halide perovskite MAPbI3, CdTe, and GaAs, in terms of photoluminescence (PL) efficiency, PL lineshape, carrier diffusion, and surface recombination, over multiple orders of photo-excitation density. An analytic model is used to describe the excitation density dependence of PL intensity and extract the internal PL efficiency and multiple pertinent recombination parameters. A PL imaging technique is used to obtain carrier diffusion length without using a PL quencher, thus, free of unintended influence beyond pure diffusion. Our results show that perovskite samples tend to exhibit lower Shockley-Read-Hall (SRH) recombination rate in both bulk and surface, thus higher PL efficiency than the inorganic counterparts, particularly under low excitation density, even with no or preliminary surface passivation. PL lineshape and diffusion analysis indicate that there is considerable structural disordering in the perovskite materials, and thus photo-generated carriers are not in global thermal equilibrium, which in turn suppresses the nonradiative recombination. This study suggests that relatively low point-defect density, less detrimental surface recombination, and moderate structural disordering contribute to the high PV efficiency in the perovskite. This comparative photovoltaics study provides more insights into the fundamental material science and the search for optimal device designs by learning from different technologies.

preprint2016arXiv

Light Induced Degradation of CH_3NH_3PbI_3 Thin Film

The stability of CH3NH3PbI3 was investigated by observing the damage on a co-evaporated film irradiated by a blue laser in ultrahigh vacuum. X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) were employed to investigate the irradiation effects on the surface. The core levels of perovskite were observed to shift toward higher binding energy (BE) during the irradiation, suggesting that surface became more n-type. Metallic Pb appeared after 120 minutes of irradiation, indicating that the film has started to decompose. The decomposition saturated after about 480 minutes of irradiation when the ratio of metallic Pb to total Pb was about 33%. Furthermore, the film was no longer continuous after irradiation because of the stress change after irradiation, as the substrate Au and oxygen were detected by XPS. SEM images also show a roughened surface after irradiation. The results strongly indicate that the perovskite is sensitive to the laser irradiation, and the decomposition is a self-limiting process.