Source author record

Jason Pitters

Jason Pitters appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

6works
5topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

6 published item(s)

preprint2020arXiv

Ionic Charge Distributions in Silicon Atomic Wires

Using a non-contact atomic force microscope (nc-AFM), we examine continuous DB wire structures on the hydrogen-terminated silicon (100) 2x1 surface. By probing the DB structures at varying energies, we identify the formation of previously unobserved ionic charge distributions correlated to the net charge of DB wires and their predicted lattice distortion. Performing spectroscopic analysis, we identify higher energy configurations corresponding to alternative lattice distortions as well as tip-induced charging effects. By varying the length and orientation of these DB structures, we further highlight key features in the formation of these ionic surface phases.

preprint2015arXiv

New fabrication technique for highly sensitive qPlus sensor with well-defined spring constant

A new technique for the fabrication of highly sensitive qPlus sensor for atomic force microscopy (AFM) is described. Focused ion beam was used to cut then weld onto a bare quartz tuning fork a sharp micro-tip from an electrochemically etched tungsten wire. The resulting qPlus sensor exhibits high resonance frequency and quality factor allowing increased force gradient sensitivity. Its spring constant can be determined precisely which allows accurate quantitative AFM measurements. The sensor is shown to be very stable and could undergo usual UHV tip cleaning including e-beam and field evaporation as well as in-situ STM tip treatment. Preliminary results with STM and AFM atomic resolution imaging at $4.5\,K$ of the silicon $Si(111)-7\times 7$ surface are presented.

preprint2015arXiv

Scanning tunneling spectroscopy reveals a silicon dangling bond charge state transition

We report the study of single dangling bonds (DB) on the hydrogen terminated silicon (100) surface using a low temperature scanning tunneling microscope (LT-STM). By investigating samples prepared with different annealing temperatures, we establish the critical role of subsurface arsenic dopants on the DB electronic properties. We show that when the near surface concentration of dopants is depleted as a result of $1250°C$ flash anneals, a single DB exhibits a sharp conduction step in its I(V) spectroscopy that is not due to a density of states effect but rather corresponds to a DB charge state transition. The voltage position of this transition is perfectly correlated with bias dependent changes in STM images of the DB at different charge states. Density functional theory (DFT) calculations further highlight the role of subsurface dopants on DB properties by showing the influence of the DB-dopant distance on the DB state. We discuss possible theoretical models of electronic transport through the DB that could account for our experimental observations.

preprint2014arXiv

Characterizing the rate and coherence of single-electron tunneling between two dangling bonds on the surface of silicon

We devise a scheme to characterize tunneling of an excess electron shared by a pair of tunnel-coupled dangling bonds on a silicon surface -- effectively a two-level system. Theoretical estimates show that the tunneling should be highly coherent but too fast to be measured by any conventional techniques. Our approach is instead to measure the time-averaged charge distribution of our dangling-bond pair by a capacitively coupled atomic-force-microscope tip in the presence of both a surface-parallel electrostatic potential bias between the two dangling bonds and a tunable midinfrared laser capable of inducing Rabi oscillations in the system. With a nonresonant laser, the time-averaged charge distribution in the dangling-bond pair is asymmetric as imposed by the bias. However, as the laser becomes resonant with the coherent electron tunneling in the biased pair the theory predicts that the time-averaged charge distribution becomes symmetric. This resonant symmetry effect should not only reveal the tunneling rate, but also the nature and rate of decoherence of single-electron dynamics in our system.

preprint2013arXiv

Nanoscale structuring of tungsten tip yields most coherent electron point-source

This report demonstrates the most spatially-coherent electron source ever reported. A coherence angle of 14.3 +/- 0.5 degrees was measured, indicating a virtual source size of 1.7 +/-0.6 Angstrom using an extraction voltage of 89.5 V. The nanotips under study were crafted using a spatially-confined, field-assisted nitrogen etch which removes material from the periphery of the tip apex resulting in a sharp, tungsten-nitride stabilized, high-aspect ratio source. The coherence properties are deduced from holographic measurements in a low-energy electron point source microscope with a carbon nanotube bundle as sample. Using the virtual source size and emission current the brightness normalized to 100 kV is found to be 7.9x10^8 A/sr cm^2.

preprint2011arXiv

Theory of Non-equilibrium Single Electron Dynamics in STM Imaging of Dangling Bonds on a Hydrogenated Silicon Surface

During fabrication and scanning-tunneling-microscope (STM) imaging of dangling bonds (DBs) on a hydrogenated silicon surface, we consistently observed halo-like features around isolated DBs for specific imaging conditions. These surround individual or small groups of DBs, have abnormally sharp edges, and cannot be explained by conventional STM theory. Here we investigate the nature of these features by a comprehensive 3-dimensional model of elastic and inelastic charge transfer in the vicinity of a DB. Our essential finding is that non-equilibrium current through the localized electronic state of a DB determines the charging state of the DB. This localized charge distorts the electronic bands of the silicon sample, which in turn affects the STM current in that vicinity causing the halo effect. The influence of various imaging conditions and characteristics of the sample on STM images of DBs is also investigated.