Source author record

Jaakko Sulkko

Jaakko Sulkko appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.mtrl-sci

Catalog footprint

What is connected

3works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2013arXiv

Micromanipulation transfer of membrane resonators for circuit optomechanics

A capacitive coupling between mechanical resonator and a microwave cavity enables readout and manipulation of the vibrations. We present a setup to carry out such experiments with aluminum membranes fabricated as stamps and transferred in place with micromanipulation. The membrane is held in place by van der Waals forces, and is supported by three microscopic points. We measure the lowest mechanical modes, and conclude the membrane vibrates as an essentially free-free resonator. Sliding clamping conditions are identified via a softening Duffing nonlinearity. The method will enable reduction of clamping losses, while maintaining a narrow vacuum gap for strong capacitive coupling.

preprint2010arXiv

Strong gate coupling of high-Q nanomechanical resonators

The detection of mechanical vibrations near the quantum limit is a formidable challenge since the displacement becomes vanishingly small when the number of phonon quanta tends towards zero. An interesting setup for on-chip nanomechanical resonators is that of coupling them to electrical microwave cavities for detection and manipulation. Here we show how to achieve a large cavity coupling energy of up to (2 π) 1 MHz/nm for metallic beam resonators at tens of MHz. We used focused ion beam (FIB) cutting to produce uniform slits down to 10 nm, separating patterned resonators from their gate electrodes, in suspended aluminum films. We measured the thermomechanical vibrations down to a temperature of 25 mK, and we obtained a low number of about twenty phonons at the equilibrium bath temperature. The mechanical properties of Al were excellent after FIB cutting and we recorded a quality factor of Q ~ 3 x 10^5 for a 67 MHz resonator at a temperature of 25 mK. Between 0.2K and 2K we find that the dissipation is linearly proportional to the temperature.

preprint2008arXiv

Accessing nanomechanical resonators via a fast microwave circuit

The measurement of micron-sized mechanical resonators by electrical techniques is difficult, because of the combination of a high frequency and a small mechanical displacement which together suppress the electromechanical coupling. The only electromagnetic technique proven up to the range of several hundred MHz requires the usage of heavy magnetic fields and cryogenic conditions. Here we show how, without the need of either of them, to fully electrically detect the vibrations of conductive nanomechanical resonators up to the microwave regime. We use the electrically actuated vibrations to modulate an LC tank circuit which blocks the stray capacitance, and detect the created sideband voltage by a microwave analyzer. We show the novel technique up to mechanical frequencies of 200 MHz. Finally, we estimate how one could approach the quantum limit of mechanical systems.