Source author record

J. S. Bobowski

J. S. Bobowski appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.supr-con physics.app-ph cond-mat.stat-mech physics.ed-ph physics.ins-det

Catalog footprint

What is connected

7works

5topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

Permittivity measurements of biological samples by an open-ended coaxial line

We previously reported on the complex permittivity and dc conductivity of waste-activated sludge. The measurements, spanning a frequency range of 3 MHz to 40 GHz, were made using an open-ended coaxial transmission line. Although this technique is well established in the literature, we found that it was necessary to combine methods from several papers to use the open-ended coaxial probe to reliably characterize biological samples having a high dc conductivity. Here, we provide a set of detailed and practical guidelines that can be used to determine the permittivity and conductivity of biological samples over a broad frequency range. Due to the electrode polarization effect, low frequency measurements of conducting samples require corrections to extract the intrinsic electrical properties. We describe one practical correction scheme and verify its reliability using a control sample.

preprint2020arXiv

Permittivity of waste-activated sludge by an open-ended coaxial line

The complex permittivity of thickened waste activated sludge (WAS) was measured from 3 MHz to 40 GHz. The solid content of the thickened WAS sample was varied from 4.5% to 18% by weight. The permittivity spectra exhibit features typical of biological tissues that have a high water content. At high frequencies, a Debye-type dispersion is observed with a relaxation rate of 19 GHz characteristic of the bulk water in the sample ($γ$-dispersion). At lower frequencies, the solid content of the samples determines the properties of the permittivity. The onset of the so-called $β$-dispersion, attributed to the charging of cell membranes, occurs between 10-100 MHz. For samples with higher solid concentrations, a weak dispersion of the real part of the permittivity, characteristic of bound water, was observed at intermediate frequencies ($δ$-dispersion).

preprint2018arXiv

Quantitative Stirling Cycle Measurements: P-V Diagram and Refrigeration

This paper describes simple modifications to a demonstration Stirling engine that allows one to make quantitative measurements of the Stirling cycle. First, we describe measurements of the $P$-$V$ diagram using an inexpensive pressure sensor and a common photogate. Then, as a supplement, the engine was run as a refrigerator by using a rotary tool to turn the flywheel of the engine. A small, but measurable, temperature difference developed across the body of the engine.

preprint2010arXiv

Precision Microwave Electrodynamic Measurements of K- and Co-doped BaFe$_2$As$_2$

We have studied the microwave electrodynamics of single crystal iron-based superconductors Ba$_{0.72}$K$_{0.28}$Fe$_2$As$_2$ (hole-doped, $T_\mathrm{c}$ $\approx $30 K) and Ba(Fe$_{0.95}$Co$_{0.05}$)$_2$As$_2$ (electron-doped, $T_\mathrm{c}$ $\approx$20 K), by cavity perturbation and broadband spectroscopy. SQUID magnetometry was used to confirm the quality and homogeneity of the samples under study. Through cavity perturbation techniques, the temperature dependence of the in-plane London penetration depth $Δλ(T)$, and therefore the superfluid phase stiffness $λ^2(0)/λ^2(T)$ was measured. Down to 0.4 K, the data do not show the exponential saturation at low temperatures expected from a singly-, fully-gapped superconductor. Rather, both the electron- and the hole-doped systems seem to be best described by a power law behavior, with $λ^2(0)/λ^2(T)$ $\sim$ $T^n$ and \emph{n} $\approx$ 2.5. In the three samples we studied, a weak feature near the sensitivity limit of our measurements appears near $T/T_\mathrm{c}$ =~0.04, hinting at a corresponding low energy feature in the superconducting density of states. The data can also be relatively well-described by a simple two-gap s-wave model of the order parameter, but this yields parameters which seem unrealistic and dependent on the fit range. Broadband surface resistance measurements reveal a sample dependent residual loss whose origin is unclear. The data from the \FeAs samples can be made to scale as $ω^2$ if the extrinsic loss is treated as an additive component, indicating large scattering rates. Finally, the temperature dependence of the surface resistance at 13 GHz obeys a power law very similar to those observed for $Δλ(T)$.

preprint2008arXiv

Stability of nodal quasiparticles in underdoped YBa2Cu3O6+y probed by penetration depth and microwave spectroscopy

High resolution measurements of superfluid density and broadband quasiparticle conductivity have been used to probe the low energy excitation spectrum of nodal quasiparticles in underdoped YBCO. Penetration depth is measured to temperatures as low as 0.05 K. Microwave conductivity is measured from 0.1 to 20 GHz and is a direct probe of zero-energy quasiparticles. The data are compared with predictions for a number of theoretical scenarios that compete with or otherwise modify pure d-wave superconductivity, in particular commensurate and incommensurate spin and charge density waves; d + i s and d + i d superconductivity; circulating current phases; and the BCS--BEC crossover. We conclude that the data are consistent with a pure d-wave state in the presence of a small amount of strong scattering disorder, and are able to rule out most candidate competing states either completely, or to a level set by the energy scale of the disorder, ~ 4 K. Commensurate spin and charge density orders, however, are not expected to alter the nodal spectrum and therefore cannot be excluded.

preprint2006arXiv

Oxygen Chain Disorder as the Weak Scattering Source in YBa$_2$Cu$_3$O$_{6.50}$

The microwave conductivity of an ultra-pure single crystal of YBa$_2$Cu$_3$O$_{6.50}$ has been measured deep in the superconducting state as a continuous function of frequency from $0.5\to20$ GHz. Conductivity spectra were first measured at four temperatures below 10 K after having prepared the crystal in the so called ortho-II phase in which the CuO chain oxygen are ordered into alternating full and empty chains. These spectra exhibit features expected for quasiparticle scattering from dilute weak impurities (small scattering phaseshift) in an otherwise clean d-wave superconductor. The measurements were repeated on the same crystal after heating and then rapidly quenching the sample to reduce the degree of oxygen order in the CuO chains. With the increased disorder, the conductivity spectra retain the distinctive weak-limit scattering features, but have increased widths reflecting an increase in quasiparticle scattering. These measurements unambiguously establish that CuO chain oxygen disorder is the dominant source of in-plane quasiparticle scattering in high purity YBCO.

preprint2003arXiv

Bolometric technique for high-resolution broadband microwave spectroscopy of ultra-low-loss samples

A novel low temperature bolometric method has been devised and implemented for high-precision measurements of the microwave surface resistance of small single-crystal platelet samples having very low absorption, as a continuous function of frequency. The key to the success of this non-resonant method is the in-situ use of a normal metal reference sample that calibrates the absolute rf field strength. The sample temperature can be controlled independently of the 1.2 K liquid helium bath, allowing for measurements of the temperature evolution of the absorption. However, the instrument's sensitivity decreases at higher temperatures, placing a limit on the useful temperature range. Using this method, the minimum detectable power at 1.3 K is 1.5 pW, corresponding to a surface resistance sensitivity of $\approx$1 $μΩ$ for a typical 1 mm$\times$1 mm platelet sample.