Source author record

J. L. Mohr

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

Catalog footprint

Research overview

2works
3topics
4close collaborators

Published work

2 publications

preprint2013arXiv

Reducing beam hardening effects and metal artefacts using Medipix3RX: With applications from biomaterial science

This paper discusses methods for reducing beam hardening effects using spectral data for biomaterial applications. A small-animal spectral scanner operating in the diagnostic energy range was used. We investigate the use of photon-processing features of the Medipix3RX ASIC in reducing beam hardening and associated artefacts. A fully operational charge summing mode was used during the imaging routine. We present spectral data collected for metal alloy samples, its analysis using algebraic 3D reconstruction software and volume visualisation using a custom volume rendering software. Narrow high energy acquisition using the photon-processing detector revealed substantial reduction in beam hardening effects and metal artefacts.

preprint2010arXiv

Optical Turbulence Measurements and Models for Mount John University Observatory

Site measurements were collected at Mount John University Observatory in 2005 and 2007 using a purpose-built scintillation detection and ranging system. Cn2(h)C_n^2(h) profiling indicates a weak layer located at 12 - 14 km above sea level and strong low altitude turbulence extending up to 5 km. During calm weather conditions, an additional layer was detected at 6 - 8 km above sea level. V(h)V(h) profiling suggests that tropopause layer velocities are nominally 12 - 30 m/s, and near-ground velocities range between 2 -- 20 m/s, dependent on weather. Little seasonal variation was detected in either Cn2(h)C_n^2(h) and V(h)V(h) profiles. The average coherence length, r0r_0, was found to be 7±17 \pm 1 cm for the full profile at a wavelength of 589 nm. The average isoplanatic angle, θ0θ_0, was 1.0±0.11.0 \pm 0.1 arcsec. The mean turbulence altitude, h0ˉ\bar{h_0}, was found to be 2.0±0.72.0\pm0.7 km above sea level. No average in the Greenwood frequency, fGf_G, could be established due to the gaps present in the \vw\s profiles obtained. A modified Hufnagel-Valley model was developed to describe the Cn2(h)C_n^2(h) profiles at Mount John, which estimates r0r_0 at 6 cm and θ0θ_0 at 0.9 arcsec. A series of V(h)V(h) models were developed, based on the Greenwood wind model with an additional peak located at low altitudes. Using the Cn2(h)C_n^2(h) model and the suggested V(h)V(h) model for moderate ground wind speeds, fGf_G is estimated at 79 Hz.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.