Researcher profile

J. D. D. Martin

J. D. D. Martin contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 21 - Emerging
9works
0followers
4topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

9 published item(s)

preprint2019arXiv

On the validity of many-mode Floquet theory with commensurate frequencies

Many-mode Floquet theory [T.-S. Ho, S.-I. Chu, and J. V. Tietz, Chem. Phys. Lett., v. 96, 464 (1983)] is a technique for solving the time-dependent Schrödinger equation in the special case of multiple periodic fields, but its limitations are not well understood. We show that for a Hamiltonian consisting of two time-periodic couplings of commensurate frequencies (integer multiples of a common frequency), many-mode Floquet theory provides a correct expression for unitary time evolution. However, caution must be taken in the interpretation of the eigenvalues and eigenvectors of the corresponding many-mode Floquet Hamiltonian, as only part of its spectrum is directly relevant to time evolution. We give a physical interpretation for the remainder of the spectrum of the Hamiltonian. These results are relevant to the engineering of quantum systems using multiple controllable periodic fields.

preprint2015arXiv

Reduction of the dc electric field sensitivity of circular Rydberg states using non-resonant dressing fields

Non-resonant dressing fields can make the transition frequency between two circular Rydberg states insensitive to second order variations in the dc electric field. Perturbation theory can be used to establish the required dressing field amplitude and frequency. The same perturbative approach may be used to understand removal of the first order dependence of the transition frequency on electric field about a bias dc electric field [Hyafil et al. Phys. Rev. Lett., v. 93, 103001 (2004)]. The directional alignment of the dressing and dc fields is critical in determining the electric field sensitivity of the dressed transition frequencies. This sensitivity is significantly larger for circular Rydberg states compared to low-angular momentum Rydberg states of Rb.

preprint2013arXiv

Coherent manipulation of cold Rydberg atoms near the surface of an atom chip

Coherent superpositions of the 49s and 48s Rydberg states of cold Rb atoms were studied near the surface of an atom chip. The superpositions were created and manipulated using microwaves resonant with the two-photon 49s-48s transition. Coherent behavior was observed using Rabi flopping, Ramsey sequences, spin-echo and spin-locking. These results are discussed in the context of Rydberg atoms as electric field noise sensors. We consider the coherence of systems quadratically coupled to noise fields with 1/f^k power spectral densities (k \approx 1).

preprint2013arXiv

Rydberg atoms with a reduced sensitivity to dc and low-frequency electric fields

A non-resonant microwave dressing field at 38.465 GHz was used to eliminate the static electric dipole moment difference between the $49s_{1/2}$ and $48s_{1/2}$ Rydberg states of $^{87}$Rb in dc fields of approximately 1 V/cm. The reduced susceptibility to electric field fluctuations was measured using 2-photon microwave spectroscopy. An anomalous spectral doublet is attributed to polarization ellipticity in the dressing field. The demonstrated ability to inhibit static dipole moment differences --- while retaining sensitivity to high frequency fields --- is applicable to sensors and/or quantum devices using Rydberg atoms.

preprint2012arXiv

Electric field sensing near the surface microstructure of an atom chip using cold Rydberg atoms

The electric fields near the heterogeneous metal/dielectric surface of an atom chip were measured using cold atoms. The atomic sensitivity to electric fields was enhanced by exciting the atoms to Rydberg states that are 10^8 times more polarizable than the ground state. We attribute the measured fields to charging of the insulators between the atom chip wires. Surprisingly, it is observed that these fields may be dramatically lowered with appropriate voltage biasing, suggesting configurations for the future development of hybrid quantum systems.

preprint2011arXiv

Energy shifts of Rydberg atoms due to patch fields near metal surfaces

The statistical properties of patch electric fields due to a polycrystalline metal surface are calculated. The fluctuations in the electric field scale like 1/z^2, when z >> w, where z is the distance to the surface, and w is the characteristic length scale of the surface patches. For typical thermally evaporated gold surfaces these field fluctuations are comparable to the image field of an elementary charge, and scale in the same way with distance to the surface. Expressions for calculating the statistics of the inhomogeneous broadening of Rydberg atom energies due to patch electric fields are presented. Spatial variations in the patch fields over the Rydberg orbit are found to be insignificant.

preprint2011arXiv

Injection-locked diode laser current modulation for Pound-Drever-Hall frequency stabilization using transfer cavities

A phase modulated RF current source is applied to an injection locked diode laser operating at $780\unit{nm}$. This produces tunable phase modulated sidebands of the laser suitable for stabilizing the length of an optical transfer cavity using the Pound-Drever-Hall technique. The Pound-Drever-Hall signal is anti-symmetric about the lock point, despite the presence of significant diode laser amplitude modulation. The stabilized optical transfer cavity is used to frequency stabilize a 776 nm external cavity diode laser. The stability and tunability of this transfer cavity locked laser is established by observation of the hyperfine components of the $^{87}$Rb $5P_{3/2}-5D_{5/2}$ transition in a vapor cell.

preprint2011arXiv

Understanding Pound-Drever-Hall locking using voltage controlled radio-frequency oscillators: An undergraduate experiment

We have developed a senior undergraduate experiment that illustrates frequency stabilization techniques using radio-frequency electronics. The primary objective is to frequency stabilize a voltage controlled oscillator to a cavity resonance at 800 MHz using the Pound-Drever-Hall method. This technique is commonly applied to stabilize lasers at optical frequencies. By using only radio-frequency equipment it is possible to systematically study aspects of the technique more thoroughly, inexpensively, and free from eye hazards. Students also learn about modular radio-frequency electronics and basic feedback control loops. By varying the temperature of the resonator, students can determine the thermal expansion coefficients of copper, aluminum, and super invar.

preprint2006arXiv

Enhancement of Rydberg atom interactions using ac Stark shifts

The ac Stark effect was used to induce resonant energy transfer between translationally cold Rydberg atoms. The Rb Rydberg atoms were obtained by laser excitation of cold atoms from a magneto-optical trap. Using two-photon microwave spectroscopy of the 49s_{1/2}-50s_{1/2} transition, the field strength of a 28.5 GHz dressing field was calibrated. When this dressing field was set at specific field strengths, the two-atom dipole-dipole process 43d_{5/2} + 43d_{5/2} -> 45p_{3/2} + 41f was dramatically enhanced, due to induced degeneracy of the initial and final states. A series of observed resonant field strengths correspond to different magnetic sublevel possibilities for the initial and final states. These agree well with calculated resonance fields based on a perturbative ac Stark shift formula. This method for enhancing interactions is complementary to dc electric-field-induced resonant energy transfer, but has more flexibility due to the possibility of varying the applied frequency.