Source author record

Ingo Deppner

Ingo Deppner appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

hep-ex physics.ins-det

Catalog footprint

What is connected

2works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

mTOF performance during mCBM beam time at GSI

The future Facility for Anti-proton and Ion Research (FAIR), currently in construction in Darmstadt, Germany, is one of the largest research projects worldwide. The Compressed Baryonic Matter (CBM) experiment is one of the main pillars at FAIR, studying the quantum chromodynamics (QCD) phase diagram at high baryon densities with unprecedented interaction rate in heavy ion collisions up to 10 MHz. This requires new data-driven readout chain, new data analysis methods and high-rate capable detector systems. The task of the CBM Time of Flight wall (CBM-TOF) is the charged particle identification. Multi-gap Resistive Plate Chambers (MRPCs) with different rate capabilities will be used at CBM-TOF corresponding regions. To reduce the commissioning time for CBM, a CBM full system test-setup called mini-CBM (mCBM) had been installed and tested with beams at GSI SIS18 facility in 2019. The high-rate MRPC prototypes developed at Tsinghua University, called MRPC2, were selected to be implemented in mTOF modules for mCBM. Additional thin float glass MRPCs from USTC called MRPC3, foreseen for the CBM lower rate region, were also tested in the mCBM experiment. Performance results of the two kinds of MRPCs analyzed by the so called tracking method will be shown.

preprint2016arXiv

Development and test of a real-size MRPC for CBM-TOF

In the CBM (Compressed Baryonic Matter) experiment constructed at the Facility for Anti-proton and Ion Research (Fair) at GSI, Darmstadt, Germany, MRPC(Multi-gap Resistive Plate Chamber) is adopted to construct the large TOF (Time-of-Flight) system to achieve an unprecedented precision of hadron identification, benefiting from its good time resolution, relatively high efficiency and low building price. We have developed a kind of double-ended readout strip MRPC. It uses low resistive glass to keep good performance of time resolution under high-rate condition. The differential double stack structure of 2x4 gas gaps help to reduce the required high voltage to half. There are 24 strips on one counter, and each is 270mm long, 7mm wide and the interval is 3mm. Ground is placed onto the MRPC electrode and feed through is carefully designed to match the 100 Ohm impedance of PADI electronics. The prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency and 60ps time resolution is gotten. In order to further examine the performance of the detector working under higher particle flux rate, the prototype has been tested in the 2014 October GSI beam time and 2015 February CERN beam time. In both beam times a relatively high rate of 1 kHz/cm2 was obtained. The calibration is done with CBM ROOT. A couple of corrections has been considered in the calibration and analysis process (including time-walk correction, gain correction, strip alignment correction and velocity correction) to access actual counter performances such as efficiency and time resolution. An efficiency of 97% and time resolution of 48ps are obtained. All these results show that the real-size prototype is fully capable of the requirement of the CBM-TOF, and new designs such as self-sealing are modified into the strip counter prototype to obtain even better performance.