Researcher profile

Hiroyuki Kitahata

Hiroyuki Kitahata contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 21 - EmergingVerification L1Unclaimed author
10works
0followers
6topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Identity and collaboration

How to connect with this researcher

Claiming links this public author record to a researcher profile and unlocks direct collaboration workflows.

Log in to claim

Direct collaboration

Open a focused conversation when the fit is right

Claim this author entity first to unlock direct invitations.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

10 published item(s)

preprint2022arXiv

Anomalous diffusion and transport by a reciprocal convective flow

Under low-Reynolds-number conditions, dynamics of convection and diffusion are usually considered separately because their dominant spatial and temporal scales are different, but cooperative effects of convection and diffusion can cause diffusion enhancement [Koyano et al., Phys. Rev. E, 102, 033109 (2020)]. In this study, such cooperative effects are investigated in detail. Numerical simulations based on the convection-diffusion equation revealed that anisotropic diffusion and net shift as well as diffusion enhancement occur under a reciprocal flow. Such anomalous diffusion and transport are theoretically derived by the analyses of the Langevin dynamics.

preprint2022arXiv

Bifurcation structure of the flame oscillation

A flame exhibits a limit-cycle oscillation, which is called "flame flickering" or "puffing", in a certain condition. We investigated the bifurcation structure of the flame oscillation in both simulation and experiment. We performed a two-dimensional hydrodynamic simulation by employing the flame sheet model. We reproduced the flame oscillation and investigated the parameter dependences of the amplitude and frequency on the fuel-inlet diameter. We also constructed an experimental system, in which we could finely vary the fuel-inlet diameter, and we investigated the diameter-dependences of the amplitude and frequency. In our simulation, we observed the hysteresis and bistability of the stationary and oscillatory states. In our experiments, we observed the switching between the stationary and oscillatory states. As fluctuations can induce the switching in the bistable system, switching observed in our experiments suggested the bistability of the two states. Therefore, we concluded that the oscillatory state appeared from the stationary state through the subcritical Andronov-Hopf bifurcation in both the simulation and experiment. The amplitude was increased and the frequency was decreased as the fuel-inlet diameter was increased. In addition, we visualized the vortex structure in our simulation and discussed the effect of the vortex on the flame dynamics.

preprint2021arXiv

Imperfect bifurcation in the rotation of a propeller-shaped camphor rotor

We investigated the bifurcation structure on the self-propelled motion of a camphor rotor at a water surface. The center of the camphor rotor was fixed by the axis, and it showed rotational motion around it. Due to the chiral asymmetry of its shape, the absolute values of the angular velocities in clockwise and counterclockwise directions were different. This asymmetry in the angular velocities implies an imperfect bifurcation. From the numerical simulation results, we discuss the condition for the occurrence of the imperfect bifurcation.

preprint2020arXiv

Bifurcation analysis of a density oscillator using two-dimensional hydrodynamic simulation

A density oscillator exhibits limit-cycle oscillations driven by the density difference of the two fluids. We performed two-dimensional hydrodynamic simulations with a simple model, and reproduced the oscillatory flow observed in experiments. As the density difference is increased as a bifurcation parameter, a damped oscillation changes to a limit-cycle oscillation through a supercritical Hopf bifurcation. We estimated the critical density difference at the bifurcation point and confirmed that the period of the oscillation remains finite even around the bifurcation point.

preprint2020arXiv

Diffusion in crowded colloids of particles cyclically changing their shapes

A simple model of an active colloid consisting of dumbbell-shaped particles that cyclically change their length without propelling themselves is proposed and analyzed. At nanoscales, it represents an idealization for bacterial cytoplasm or for a biomembrane with active protein inclusions. Our numerical simulations demonstrate that non-equilibrium conformational activity of particles can strongly affect diffusion and structural relaxation: while a passive colloid behaves as a glass, it gets progressively fluidized when the activity is turned on. Qualitatively, this agrees with experimental results on optical tracking of probe particles in bacterial and yeast cells where metabolism-induced fluidization of cytoplasm was observed.

preprint2020arXiv

Experimental study on the bifurcation of a density oscillator depending on density difference

Hydrodynamic instabilities often cause spatio-temporal pattern formations and transitions between them. We investigate a model experimental system, a density oscillator, where the bifurcation from a resting state to an oscillatory state is triggered by the increase in the density difference of the two fluids. Our results show that the oscillation amplitude increases from zero and the period decreases above a critical density difference. The detailed data close to the bifurcation point provide a critical exponent consistent with the supercritical Hopf bifurcation.

preprint2020arXiv

Local bifurcation structure of a bouncing ball system with a piecewise polynomial function for table displacement

The system in which a small rigid ball is bouncing repeatedly on a massive at table vibrating vertically, so-called the bouncing ball system, has been widely studied. Under the assumption that the table is vibrating with a piecewise polynomial function of time, the bifurcation diagram changes qualitatively depending on the order of the polynomial function. We elucidate the mechanism of the difference in the bifurcation diagrams by focusing on the two-period solution. In addition, we derive the approximate curve of the branch close to the period-doubling bifurcation point in the case of the piecewise cubic function of time for the table vibration. We also performed numerical calculation, and we demonstrate that the approximations well reproduce the numerical results.

preprint2020arXiv

On a simple model that explains inversion of a self-propelled rotor under periodic stop and release operations

We propose a simple mathematical model that describes the time evolution of a self-propelled object on a liquid surface using such variables as the object location, the surface concentration of active molecules and the hydrodynamic surface flow. The model is applied to simulate the time evolution of a rotor composed of a polygonal plate with camphor pills at its corners. We have qualitatively reproduced results of experiments, in which the inversion of rotational direction under periodic stop-and-release operations was investigated. The model correctly describes the probability of the inversion as a function of the duration of the phase when the rotor is stopped. Moreover, the model allows to introduce the rotor asymmetry unavoidable in real experiments and study its influence on the studied phenomenon. Our numerical simulations have revealed that the probability of the inversion of rotational direction is determined by the competition among the transport of the camphor molecules by the flow, the intrinsic asymmetry of the rotor, and the noise amplitude.

preprint2020arXiv

Spontaneous motion of a camphor particle with a triangular modification from a circle

The spontaneous motion of a camphor particle with a slight modification from a circle is investigated. The effect of the shape on the motion is examined by the perturbation method. We introduce a slight $n$-mode modification from a circle, where the profile is described by $r = R(1 + ε\cos nθ)$ in polar coordinates. The results predict that a camphor particle with an $n=3$ mode modification from a circle, i.e., a triangular modification, moves in the direction of a corner for a small particle, while it moves in the direction of a side for a large particle. The numerical simulation results well reproduce the theoretical prediction. The present study will help understand the effect of the particle shape on spontaneous motion.

preprint2020arXiv

Star shaped patterns caused by colloidal aggregation during the spreading process of a droplet

This research found that when an acidic solution with a low surface tension spread on the surface of a glycerol solution mixed with milk, a star shaped pattern was spontaneously formed on the surface in the horizontal plane during the spreading process. We investigated the emergence of the star shaped pattern owing to an interfacial instability in experiments using glycerol solutions with several viscosities and 2-methoxyethanol aqueous solutions, which are acidic solutions, with several concentrations. This result demonstrated that the star shaped pattern emerged in the high concentration of 2-methoxyethanol. We proposed a phenomenological model, based on our experimental results, which explains three points as follows; the spreading of the 2-methoxyethanol aqueous solution on the surface of the glycerol solution, the colloidal aggregation of the milk protein colloids caused by the denaturation that occurs when mixed with 2-methoxyethanol, and the accumulation of the aggregates toward the dent regions of the moving interface by a sweeping effect. The model reproduces the formation of the star shaped pattern which was similar to the experimental one. Furthermore, the model provided a phase diagram against the concentration of the 2-methoxyethanol solution and the viscosity of the glycerol solution as control parameters in our experiments. The phase diagram was close to that obtained from our experiments. The results suggest that the above three points are important for the formation of the star shaped pattern.