Source author record

Dulce M. Morales

Dulce M. Morales appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.chem-ph cond-mat.mtrl-sci physics.data-an physics.ed-ph

Catalog footprint

What is connected

3works

4topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Stabilization of Co oxide during oxygen evolution in alkaline media by the introduction of Mn oxide

Improving the stability of electrocatalysts for the oxygen evolution reaction (OER) through materials design has received less attention than improving their catalytic activity. We explored the effect of Mn addition to a cobalt oxide for stabilizing the catalyst by comparing Na-containing CoOx and (Co0.7Mn0.3)Ox films electrodeposited in alkaline solution. The obtained disordered films were classified as layered oxides using X-ray absorption spectroscopy (XAS). The CoOx films showed a constant decrease in the catalytic activity during cycling, confirmed by oxygen detection, while that of (Co0.7Mn0.3)Ox slightly increased as measured by electrochemical metrics. These trends were rationalized based on XAS analysis of the metal oxidation states, which were Co2.8+ and Mn3.7+ near the surface after cycling. Thus, adding Mn to CoOx successfully stabilized the catalyst material and its activity during OER cycling. The development of stabilization approaches is essential to extend the durability of OER catalysts.

preprint2022arXiv

What X-ray absorption spectroscopy can tell us about the active state of earth-abundant electrocatalysts for the oxygen evolution reaction

Chemical energy storage is an attractive solution to secure a sustainable energy supply. It requires an electrocatalyst to be implemented efficiently. In order to rationally improve the electrocatalyst materials and thereby the reaction efficiency, one must reveal the nature of the electrocatalyst under reaction conditions, i.e., its active state. For a better understanding of earth-abundant metal oxides as electrocatalysts for the oxygen evolution reaction (OER), the combination of electrochemical (EC) methods and X-ray absorption spectroscopy (XAS) has been very insightful and still holds untapped potential. Herein, we concisely introduce the basics of EC and XAS and provide the necessary framework to discuss changes that electrocatalytic materials undergo, presenting manganese oxides as examples. Such changes may occur during preparation and storage, during immersion in an electrolyte, as well as during application of potentials without or with catalytic reactions. We conclude with a concise summary of how EC and XAS are currently combined to elucidate the active state as well as an outlook on future opportunities to understand the mechanisms of electrocatalysis using combined operando EC-XAS experiments.

preprint2021arXiv

Seven steps to reliable cyclic voltammetry measurements for the determination of double layer capacitance

Discovery of electrocatalytic materials for high-performance energy conversion and storage applications relies on the adequate characterization of their intrinsic activity, which is currently hindered by the dearth of a protocol for consistent and precise determination of double layer capacitance (CDL). Herein, we propose a seven-step method that aims to determine CDL reliably by scan rate-dependent cyclic voltammetry. The method considers three aspects that strongly influence the outcome of the analysis: measurement settings, data collection, and data processing. To illustrate the proposed method, two systems were studied: a resistor-capacitor electric circuit and a glassy carbon disk in an electrochemical cell. With these studies it is demonstrated that when any of the mentioned aspects of the procedure are neglected, substantial deviations of the results are observed with misestimations as large as 61% in the case of the investigated electrochemical system. Moreover, we propose allometric regression as a more suitable model than linear regression for the determination of CDL for both the ideal and the non-ideal systems investigated. We stress the importance of assessing the accuracy of not only highly specialized electrochemical methods, but also of those that are well-known and commonly used as it is the case of the voltammetric methods. The methodology proposed herein is not limited to the determination of CDL, but can be effectively applied to any other voltammetry-based analysis that aims to deliver quantitative results.