Source author record

Defu Bu

Defu Bu appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

10works
4topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

10 published item(s)

preprint2025arXiv

Detection of disk-jet co-precession in a tidal disruption event

Theories and simulations predict that intense spacetime curvature near black holes bends the trajectories of light and matter, driving disk and jet precession under relativistic torques. However, direct observational evidence of disk-jet co-precession remains elusive. Here, we report the most compelling case to date: a tidal disruption event (TDE) exhibiting unprecedented 19.6-day quasi-periodic variations in both X-rays and radio, with X-ray amplitudes exceeding an order of magnitude. The nearly synchronized X-ray and radio variations suggest a shared mechanism regulating the emission regions. We demonstrate that a disk-jet Lense-Thirring precession model successfully reproduces these variations while requiring a low-spin black hole. This study uncovers previously uncharted short-term radio variability in TDEs, highlights the transformative potential of high-cadence radio monitoring, and offers profound insights into disk-jet physics.

preprint2021arXiv

The detections of inflowing gas from narrow absorption lines at the parsec scale

Inflows at the dusty torus and smaller scales is crucial to investigate the process of supermassive black hole accretion. However, only few cases of inflowing gas at small scales have been reported through redshifted broad absorption lines so far. Here we report 9 redshifted narrow absorption lines (NALs) of $\rm Mg^+$ ions with inflowing speeds of 1071 -- 1979 km/s, which are likely along the directions close to the axes of accretion disks. The quasars showing inflowing Mg II NALs have on average slightly smaller Eddington ratios when compared to the sources with outflow Mg II NALs. The upper limits of locations of the detected NALs are at parsec scale, around the distances of dusty tori to central SMBHs. The one possible origin of these infalling NALs is from dusty tori. Of course, these infalling NALs can also be naturally explained by chaotic cold accretion resulted from the nonlinear interaction of active galactic nucleus (AGN) jets with the interstellar medium, and these cold gaseous blobs may originally precipitate in metal-rich trailing outflows uplifted by AGN jet ejecta. The infalling NALs may thus provide direct evidence for cold gas precipitation and accretion in AGN feedback processes, and provide the direct evidence of inflowing gas along the directions close to quasar jets and at parsec scale. It does not matter whether these infalling NALs are from the dusty tori or the interaction of AGN jets with the ISM, the infalling NALs cannot provide sufficient fuels to power the quasars.

preprint2015arXiv

Numerical Simulation of Hot Accretion Flows (III): Revisiting wind properties using trajectory approach

Previous MHD simulations have shown that wind must exist in black hole hot accretion flows. In this paper, we continue our study by investigating the detailed properties of wind, such as mass flux and poloidal speed, and the mechanism of wind production. For this aim, we make use of a three dimensional GRMHD simulation of hot accretion flows around a Schwarzschild black hole. The simulation is designed so that the magnetic flux is not accumulated significantly around the black hole. To distinguish real wind from turbulent outflows, we track the trajectories of the virtual Largrangian particles from simulation data. We find two types of real outflows, i.e., a quasi-relativistic jet close to the axis and a sub-relativistic wind subtending a much larger solid angle. Most of the wind originates from the surface layer of the accretion flow. The poloidal wind speed almost remains constant once they are produced, but the flux-weighted wind speed roughly follows $v_{\rm p, wind}(r)\approx 0.25 v_k(r)$. The mass flux of jet is much lower but the speed is much higher, $v_{\rm p,jet}\sim (0.3-0.4) c$. Consequently, both the energy and momentum fluxes of the wind are much larger than those of the jet. We find that the wind is produced and accelerated primarily by the combination of centrifugal force and magnetic pressure gradient, while the jet is mainly accelerated by magnetic pressure gradient. Finally, we find that the wind production efficiency $ε_{\rm wind}\equiv\dot{E}_{\rm wind}/\dot{M}_{\rm BH}c^2\sim 1/1000$, in good agreement with the value required from large-scale galaxy simulations with AGN feedback.

preprint2014arXiv

Fermi Bubbles Inflated by Winds Launched from the Hot Accretion Flow in Sgr A*

A pair of giant gamma-ray bubbles have been revealed by the {\it Fermi} LAT. In this paper we investigate their formation mechanism. Observations have indicated that the activity of the supermassive black hole located at the Galactic center, Sgr A*, was much stronger than the present time. Specifically, one possibility is that while Sgr A* was also in the hot accretion regime, the accretion rate should be $10^3-10^4$ times higher during the past $\sim 10^7$ yr. On the other hand, recent MHD numerical simulations of hot accretion flows have unambiguously shown the existence of strong winds and obtained their properties. Based on these knowledge, by performing three-dimensional hydrodynamical simulations, we show in this paper that the Fermi bubbles could be inflated by winds launched from the ``past' hot accretion flow in Sgr A*. In our model, the active phase of Sgr A* is required to last for about 10 million years and it was quenched no more than 0.2 million years ago. The Central Molecular Zone (CMZ) is included and it collimates the wind orientation towards the Galactic poles. Viscosity suppresses the Rayleigh-Taylor and Kelvin-Helmholtz instabilities and results in the smoothness of the bubble edge. The main observational features of the bubbles can be well explained. Specifically, the {\it ROSAT} X-ray features are interpreted by the shocked interstellar medium and the interaction region between winds and CMZ gas. The thermal pressure and temperature obtained in our model are in good consistency with the recent {\it Suzaku} observations.

preprint2014arXiv

Formation of Isothermal Disks around Protoplanets. I. Introductory Three-Dimensional Global Simulations for Sub-Neptune-Mass Protoplanets

The regular satellites found around Neptune ($\approx 17~M_{\Earth}$) and Uranus ($\approx 14.5~M_{\Earth}$) suggest that past gaseous circumplanetary disks may have co-existed with solids around sub-Neptune-mass protoplanets ($< 17~M_{\Earth}$). These disks have been shown to be cool, optically thin, quiescent, with low surface density and low viscosity. Numerical studies of the formation are difficult and technically challenging. As an introductory attempt, three-dimensional global simulations are performed to explore the formation of circumplanetary disks around sub-Neptune-mass protoplanets embedded within an isothermal protoplanetary disk at the inviscid limit of the fluid in the absence of self-gravity. Under such conditions, a sub-Neptune-mass protoplanet can reasonably have a rotationally supported circumplanetary disk. The size of the circumplanetary disk is found to be roughly one-tenth of the corresponding Hill radius, which is consistent with the orbital radii of irregular satellites found for Uranus. The protoplanetary gas accretes onto the circumplanetary disk vertically from high altitude and returns to the protoplanetary disk again near the midplane. This implies an open system in which the circumplanetary disk constantly exchanges angular momentum and material with its surrounding prenatal protoplanetary gas.

preprint2012arXiv

Numerical Simulation of Hot Accretion Flows (I): A Large Radial Dynamical Range and the Density Profile of Accretion Flow

Numerical simulations of hot accretion flow have shown that the mass accretion rate decreases with decreasing radius; consequently the density profile of accretion flow becomes flatter compared to the case of a constant accretion rate. This result has important theoretical and observational implications. However, because of technical difficulties, the radial dynamic range in almost all previous simulations usually spans at most two orders of magnitude. This small dynamical range, combined with the effects of boundary conditions, makes the simulation results suspectable. Especially, the radial profiles of density and accretion rate may not be precise enough to be used to compare with observations. In this paper we present a "two-zone" approach to expand the radial dynamical range from two to four orders of magnitude. We confirm previous results and find that from $r_s$ to $ 10^4r_s$ the radial profiles of accretion rate and density can be well described by $\dot{M}(r)\propto r^s$ and $ρ\propto r^{-p}$. The values of (s, p) are (0.48, 0.65) and (0.4, 0.85), for viscous parameter $α=0.001$ and 0.01, respectively. We have looked up numerical simulation works in the literature and found that the values of $s$ and $p$ are all similar, no matter a magnetic field is included or not and what kind of initial conditions are adopted. The density profile we obtain is in good quantitative agreement with that obtained from the detailed observations and modeling to Sgr A* and NGC 3115. The origin of such a accretion rate profile will be investigated in a subsequent paper.

preprint2012arXiv

Numerical Simulation of Hot Accretion Flows (II): Nature, Origin, and Properties of Outflow and Their Possible Observational Applications

Previous hydrodynamical (HD) and magnetohydrodynamical (MHD) numerical simulations of hot accretion flows have shown that the mass accretion rate decreases with decreasing radius. Two models have been proposed to explain this result. In the ADIOS model, the inward decrease of accretion rate is because of the loss of gas in the outflow. In the CDAF model, the gas is assumed to be locked in convective eddies, which results in the inward decrease of the accretion rate. We investigate the nature of inward decrease of accretion rate using HD and MHD simulations. We calculate various properties of inflow and outflow, including the mass flux, radial and rotational velocities, temperature, and the Bernoulli parameter ($Be$). Systematic and significant differences between inflow and outflow are found. These results suggest that the inflow and outflow are not dominated by convective turbulence, but are systematic inward and outward motion. We have also analyzed the convective stability of MHD accretion flow and found that they are convectively stable. These results indicate that the ADIOS scenario is favored. The different properties of inflow and outflow also suggest that the mechanisms of producing outflow in HD and MHD flows are buoyancy and centrifugal force associated with the magnetic field, respectively. The latter mechanism is similar to the Blandford & Payne mechanism. We also study the effect of initial conditions in the simulations. We find that the value of $Be$ is mainly determined by the value of $Be$ of the initial condition. We discuss some possible observational applications of our outflow model. These observations include the Fermi bubble observed in the Galaxy center, and winds widely observed in AGNs and black hole X-ray binaries.

preprint2012arXiv

Outflow from Hot Accretion Flows

Numerical simulations of hot accretion flows have shown that the mass accretion rate decreases with decreasing radius. Two models have been proposed to explain this result. In the adiabatic inflow-outflow solution (ADIOS), it is thought to be due to the loss of gas in outflows. In the convection-dominated accretion flow (CDAF) model, it is explained as because that the gas is locked in convective eddies. In this paper we use hydrodynamical (HD) and magnetohydrodynamical (MHD) simulations to investigate which one is physical. We calculate and compare various properties of inflow (gas with an inward velocity) and outflow (gas with an outward velocity). Systematic and significant differences are found. For example, for HD flows, the temperature of outflow is higher than inflow; while for MHD flows, the specific angular momentum of outflow is much higher than inflow. We have also analyzed the convective stability of MHD accretion flow and found that they are stable. These results suggest that systematic inward and outward motion must exist, i.e., the ADIOS model is favored. The different properties of inflow and outflow also suggest that the mechanisms of producing outflow in HD and MHD flows are buoyancy associated with the convection and the centrifugal force associated with the angular momentum transport mediated by the magnetic field, respectively. The latter mechanism is similar to the Blandford & Payne mechanism but no large-scale open magnetic field is required here. Possible observational applications are briefly discussed.

preprint2012arXiv

The effects of viscosity on the circumplanetary disks

The effects of viscosity on the circumplanetary disks residing in the vicinity of protoplanets are investigated through two-dimensional hydrodynamical simulations with the shearing sheet model. We find that viscosity can affect properties of the circumplanetary disk considerably when the mass of the protoplanet is $M_p \lesssim 33M_\oplus$, where $M_\oplus$ is the Earth mass. However, effects of viscosity on the circumplanetary disk are negligibly small when the mass of the protoplanet $M_p \gtrsim 33M_\oplus$. We find that when $M_p \lesssim 33M_\oplus$, viscosity can disrupt the spiral structure of the gas around the planet considerably and make the gas smoothly distributed, which makes the torques exerted on the protoplanet weaker. Thus, viscosity can make the migration speed of a protoplanet lower. After including viscosity, size of the circumplanetary disk can be decreased by a factor of $\gtrsim 20%$. Viscosity helps to transport gas into the circumplanetary disk from the differentially rotating circumstellar disk. The mass of the circumplanetary disk can be increased by a factor of 50% after viscosity is taken into account when $M_p \lesssim 33M_\oplus$. Effects of viscosity on the formation of planets and satellites are briefly discussed.

preprint2010arXiv

On the convective instability of hot radiative accretion flows

How many fraction of gas available at the outer boundary can finally fall onto the black hole is an important question. It determines the observational appearance of accretion flows, and is also related with the evolution of black hole mass and spin. Previous two-dimensional hydrodynamical simulations of hot accretion flows find that the flow is convectively unstable because of its inward increase of entropy. As a result, the mass accretion rate decreases inward, i.e., only a small fraction of accretion gas can fall onto the black hole, while the rest circulates in the convective eddies or lost in convective outflows. Radiation is usually neglected in these simulations. In many cases, however, radiative cooling is important. In the regime of the luminous hot accretion flow (LHAF), radiative cooling is even stronger than the viscous dissipation. In the one dimensional case, this implies that the inward increase of entropy will become slower or the entropy even decreases inward in the case of an LHAF. We therefore expect that convective instability becomes weaker or completely disappears when radiative cooling is important. To examine the validity of this expectation, in this paper we perform two-dimensional hydrodynamical simulations of hot accretion flows with strong radiative cooling. We find that compared to the case of negligible radiation, convection only becomes slightly weaker. Even an LHAF is still strongly convectively unstable, its radial profile of accretion rate correspondingly changes little. We find the reason is that the entropy still increases inward in the two-dimensional case.