Source author record

David P. Lake

David P. Lake appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.optics quant-ph cond-mat.mes-hall

Catalog footprint

What is connected

6works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Nonlinear optics in gallium phosphide cavities: simultaneous second and third harmonic generation

We demonstrate the simultaneous generation of second and third harmonic signals from a telecom wavelength pump in a gallium phosphide (GaP) microdisk. Using analysis of the power scaling of both the second and third harmonic outputs and calculations of nonlinear cavity mode coupling factors, we study contributions to the third harmonic signal from direct and cascaded sum frequency generation processes. We find that despite the relatively high material absorption in gallium phosphide at the third harmonic wavelength, both of these processes can be significant, with relative magnitudes that depend closely on the detuning between the second harmonic wavelength of the cavity modes.

preprint2020arXiv

Two-colour interferometry and switching through optomechanical dark mode excitation

Efficient switching and routing of photons of different wavelengths is a requirement for realizing a quantum internet. Multimode optomechanical systems can solve this technological challenge and enable studies of fundamental science involving widely separated wavelengths that are inaccessible to single-mode optomechanical systems. To this end, we demonstrate interference between two optomechanically induced transparency processes in a diamond on-chip cavity. This system allows us to directly observe the dynamics of an optomechanical dark mode that interferes photons at different wavelengths via their mutual coupling to a common mechanical resonance. This dark mode does not transfer energy to the dissipative mechanical reservoir and is predicted to enable quantum information processing applications that are insensitive to mechanical decoherence. Control of the dark mode is also utilized to demonstrate all-optical, two-colour switching and interference with light separated by over 5 THz in frequency.

preprint2016arXiv

Efficient telecom to visible wavelength conversion in doubly resonant GaP microdisks

Resonant second harmonic generation between 1550 nm and 775 nm with outside efficiency $> 4.4\times10^{-4}\, \text{mW}^{-1}$ is demonstrated in a gallium phosphide microdisk cavity supporting high-$Q$ modes at visible ($Q \sim 10^4$) and infrared ($Q \sim 10^5$) wavelengths. The double resonance condition was satisfied through intracavity photothermal temperature tuning using $\sim 360\,μ$W of 1550 nm light input to a fiber taper and resonantly coupled to the microdisk. Above this pump power efficiency was observed to decrease. The observed behavior is consistent with a simple model for thermal tuning of the double resonance condition.

preprint2016arXiv

Single-crystal diamond low-dissipation cavity optomechanics

Single-crystal diamond cavity optomechanical devices are a promising example of a hybrid quantum system: by coupling mechanical resonances to both light and electron spins, they can enable new ways for photons to control solid state qubits. However, realizing cavity optomechanical devices from high quality diamond chips has been an outstanding challenge. Here we demonstrate single-crystal diamond cavity optomechanical devices that can enable photon-phonon-spin coupling. Cavity optomechanical coupling to $2\,\text{GHz}$ frequency ($f_\text{m}$) mechanical resonances is observed. In room temperature ambient conditions, these resonances have a record combination of low dissipation (mechanical quality factor, $Q_\text{m} > 9000$) and high frequency, with $Q_\text{m}\cdot f_\text{m} \sim 1.9\times10^{13}$ sufficient for room temperature single phonon coherence. The system exhibits high optical quality factor ($Q_\text{o} > 10^4$) resonances at infrared and visible wavelengths, is nearly sideband resolved, and exhibits optomechanical cooperativity $C\sim 3$. The devices' potential for optomechanical control of diamond electron spins is demonstrated through radiation pressure excitation of mechanical self-oscillations whose 31 pm amplitude is predicted to provide 0.6 MHz coupling rates to diamond nitrogen vacancy center ground state transitions (6 Hz / phonon), and $\sim10^5$ stronger coupling rates to excited state transitions.

preprint2015arXiv

Single crystal diamond nanobeam waveguide optomechanics

Optomechanical devices sensitively transduce and actuate motion of nanomechanical structures using light. Single--crystal diamond promises to improve the performance of optomechanical devices, while also providing opportunities to interface nanomechanics with diamond color center spins and related quantum technologies. Here we demonstrate dissipative waveguide--optomechanical coupling exceeding 35 GHz/nm to diamond nanobeams supporting both optical waveguide modes and mechanical resonances, and use this optomechanical coupling to measure nanobeam displacement with a sensitivity of $9.5$ fm/$\sqrt{\text{Hz}}$ and optical bandwidth $>150$nm. The nanobeams are fabricated from bulk optical grade single--crystal diamond using a scalable undercut etching process, and support mechanical resonances with quality factor $2.5 \times 10^5$ at room temperature, and $7.2 \times 10^5$ in cryogenic conditions (5K). Mechanical self--oscillations, resulting from interplay between photothermal and optomechanical effects, are observed with amplitude exceeding 200 nm for sub-$μ$W absorbed optical power, demonstrating the potential for optomechanical excitation and manipulation of diamond nanomechanical structures.

preprint2014arXiv

Dissipative and Dispersive Optomechanics in a Nanocavity Torque Sensor

Dissipative and dispersive optomechanical couplings are experimentally observed in a photonic crystal split-beam nanocavity optimized for detecting nanoscale sources of torque. Dissipative coupling of up to approximately $500$ MHz/nm and dispersive coupling of $2$ GHz/nm enable measurements of sub-pg torsional and cantilever-like mechanical resonances with a thermally-limited torque detection sensitivity of 1.2$\times 10^{-20} \text{N} \, \text{m}/\sqrt{\text{Hz}}$ in ambient conditions and 1.3$\times 10^{-21} \text{N} \, \text{m}/\sqrt{\text{Hz}}$ in low vacuum. Interference between optomechanical coupling mechanisms is observed to enhance detection sensitivity and generate a mechanical-mode-dependent optomechanical wavelength response.