Researcher profile

Akira Endo

Akira Endo contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 17 - UnverifiedVerification L1Unclaimed author
4works
0followers
3topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Identity and collaboration

How to connect with this researcher

Claiming links this public author record to a researcher profile and unlocks direct collaboration workflows.

Log in to claim

Direct collaboration

Open a focused conversation when the fit is right

Claim this author entity first to unlock direct invitations.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2022arXiv

Joule heating and the thermal conductivity of a two-dimensional electron gas at cryogenic temperatures studied by modified 3$ω$ method

During the standard ac lock-in measurement of the resistance of a two-dimensional electron gas (2DEG) applying an ac current $I = \sqrt{2} I_0 \sin(ωt)$, the electron temperature $T_e$ oscillates with the angular frequency $2 ω$ due to the Joule heating $\propto I^2$. We have shown that the highest ($T_\mathrm{H}$) and the lowest ($T_\mathrm{L}$) temperatures during a cycle of the oscillations can be deduced, at cryogenic temperatures, exploiting the third-harmonic (3$ω$) component of the voltage drop generated by the ac current $I$ and employing the amplitude of the Shubnikov-de Haas oscillations as the measure of $T_e$. The temperatures $T_\mathrm{H}$ and $T_\mathrm{L}$ thus obtained allow us to roughly evaluate the thermal conductivity $κ_{xx}$ of the 2DEG via the modified 3$ω$ method, in which the method originally devised for bulk materials is modified to be applicable to a 2DEG embedded in a semiconductor wafer. The $κ_{xx}$ thus deduced is found to be consistent with the Wiedemann-Franz law. The method provides a convenient way to access $κ_{xx}$ using only a standard Hall-bar device and the simple experimental setup for the resistance measurement.

preprint2021arXiv

TiEMPO: Open-source time-dependent end-to-end model for simulating ground-based submillimeter astronomical observations

The next technological breakthrough in millimeter-submillimeter astronomy is 3D imaging spectrometry with wide instantaneous spectral bandwidths and wide fields of view. The total optimization of the focal-plane instrument, the telescope, the observing strategy, and the signal-processing software must enable efficient removal of foreground emission from the Earth's atmosphere, which is time-dependent and highly nonlinear in frequency. Here we present TiEMPO: Time-Dependent End-to-End Model for Post-process Optimization of the DESHIMA Spectrometer. TiEMPO utilizes a dynamical model of the atmosphere and parametrized models of the astronomical source, the telescope, the instrument, and the detector. The output of TiEMPO is a time-stream of sky brightness temperature and detected power, which can be analyzed by standard signal-processing software. We first compare TiEMPO simulations with an on-sky measurement by the wideband DESHIMA spectrometer and find good agreement in the noise power spectral density and sensitivity. We then use TiEMPO to simulate the detection of a line emission spectrum of a high-redshift galaxy using the DESHIMA 2.0 spectrometer in development. The TiEMPO model is open source. Its modular and parametrized design enables users to adapt it to design and optimize the end-to-end performance of spectroscopic and photometric instruments on existing and future telescopes.

preprint2020arXiv

DESHIMA on ASTE: On-sky Responsivity Calibration of the Integrated Superconducting Spectrometer

We are developing an ultra-wideband spectroscopic instrument, DESHIMA (DEep Spectroscopic HIgh-redshift MApper), based on the technologies of an on-chip filter-bank and Microwave Kinetic Inductance Detector (MKID) to investigate dusty star-burst galaxies in the distant universe at millimeter and submillimeter wavelength. An on-site experiment of DESHIMA was performed using the ASTE 10-m telescope. We established a responsivity model that converts frequency responses of the MKIDs to line-of-sight brightness temperature. We estimated two parameters of the responsivity model using a set of skydip data taken under various precipitable water vapor (PWV, 0.4-3.0 mm) conditions for each MKID. The line-of-sight brightness temperature of sky is estimated using an atmospheric transmission model and the PWVs. As a result, we obtain an average temperature calibration uncertainty of $1σ=4$%, which is smaller than other photometric biases. In addition, the average forward efficiency of 0.88 in our responsivity model is consistent with the value expected from the geometrical support structure of the telescope. We also estimate line-of-sight PWVs of each skydip observation using the frequency response of MKIDs, and confirm the consistency with PWVs reported by the Atacama Large Millimeter/submillimeter Array.

preprint2020arXiv

Gate controlled unitary operation on flying spin qubits in quantum Hall edge states

Spin and orbital freedoms of electrons traveling on spin-resolved quantum Hall edge states (quantum Hall ferromagnets) are maximally entangled. The unitary operations on these two freedoms are hence equivalent, which means one can manipulate the spins with non-magnetic methods through the orbitals. If one takes the quantization axis of spins along the magnetization axis, the zenith angle is determined by the partition rate of spin-separated edges while the azimuth angle is defined as the phase difference between the edges. Utilizing these properties, we have realized electrically controlled unitary operation on the electron spins on the quantum Hall ferromagnets. The zenith angle of the spin was controlled through the radius of gyration at a corner by means of applying voltage to a thin gate placed at one edge. The subsequent rotation in the azimuth angle was controlled via the distance between the edge channels also by a gate voltage. The combination of the two operations constitutes the first systematic electric operation on spins in the quantum Hall edge channels.