Paper detail

Plate motion in sheared granular fault system

Plate motion near the fault gouge layer, and the elastic interplay between the gouge layer and the plate under stick-slip conditions, is key to understanding the dynamics of sheared granular fault systems. Here, a two-dimensional implementation of the combined finite-discrete element method (FDEM), which merges the finite element method (FEM) and the discrete element method (DEM), is used to explicitly to simulate a sheared granular fault system. We focus on investigating the influence of normal load, driving shear velocity and plate stiffness on the velocities and displacements measured at locations on the upper and lower plates just adjacent to the gouge in the direction parallel to the shear direction (x direction). The simulations show that at slips the plate velocities are proportional to the normal load and may be inversely proportional to the square root of the plate's Young's modulus; whereas the driving shear velocity does not show distinct influence on the plate velocities. During stick phases, the velocities of the upper and lower plates are respectively slightly greater and slightly smaller than the half of the driving shear velocity, and are both in the same direction of shear. The shear strain rate of the gouge is calculated from this velocity difference between the upper and lower plate during stick phases and thus the gouge effective shear modulus can be calculated. The results show that the gouge effective shear modulus increases proportionally with normal load, while the influence of shear velocity and plate stiffness on gouge effective shear modulus is minor. The simulations address the dynamics of a laboratory scale fault gouge system and may help reveal the complexities of earthquake frictional dynamics.