Paper detail

Magnetothermal and magnetorotational instabilities in hot accretion flows

In a hot, dilute, magnetized accretion flow, the electron mean-free path can be much greater than the Larmor radius, thus thermal conduction is anisotropic and along magnetic field lines. In this case, if the temperature decreases outward, the flow may be subject to a buoyancy instability (the magnetothermal instability, or MTI). The MTI amplifies the magnetic field, and aligns field lines with the radial direction. If the accretion flow is differentially rotating, the magnetorotational instability (MRI) may also be present. Using two-dimensional, time-dependent magnetohydrodynamic simulations, we investigate the interaction between these two instabilities. We use global simulations that span over two orders of magnitude in radius, centered on the region around the Bondi radius where the infall time of gas is longer than the growth time of both the MTI and MRI. Significant amplification of the magnetic field is produced by both instabilities, although we find that the MTI primarily amplifies the radial component, and the MRI primarily the toroidal component, of the field, respectively. Most importantly, we find that if the MTI can amplify the magnetic energy by a factor $F_t$, and the MRI by a factor $F_r$, then when the MTI and MRI are both present, the magnetic energy can be amplified by a factor of $F_t \cdot F_r$. We therefore conclude that amplification of the magnetic energy by the MTI and MRI operates independently. We also find that the MTI contributes to the transport of angular momentum, because radial motions induced by the MTI increase the Maxwell (by amplifying the magnetic field) and Reynolds stresses. Finally, we find that thermal conduction decreases the slope of the radial temperature profile. The increased temperature near the Bondi radius decreases the mass accretion rate.