Source author record

Yong-Hang Zhang

Yong-Hang Zhang appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

2works
2topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2020arXiv

Electrically injected GeSn lasers on Si operating up to 100 K

The significant progress of GeSn material development has enabled a feasible solution to the long-desired monolithically integrated lasers on the Si platform. While there are many reports focused on optically pumped lasers, GeSn lasers through electrical injection have not been experimentally achieved yet. In this work, we report the first demonstration of electrically injected GeSn lasers on Si. A GeSn/SiGeSn heterostructure diode grown on a Si substrate was fabricated into ridge waveguide laser devices and tested under pulsed conditions. Special considerations were given for the structure design to ensure effective carrier confinement and optical confinement that lead to lasing. Lasing was observed at temperatures from 10 to 100 K with emission peaks at around 2300 nm. The minimum threshold of 598 A/cm2 was recorded at 10 K and the threshold increased to 842 A/cm2 at 77 K. The spectral linewidth of a single peak was measured as small as 0.13 nm (0.06 meV). The maximum characteristic temperature was extracted as 99 K over the temperature range of 10-77 K.

preprint2019arXiv

Comparative studies of optoelectrical properties of prominent PV materials: Halide Perovskite, CdTe, and GaAs

We compare three representative high performance PV materials: halide perovskite MAPbI3, CdTe, and GaAs, in terms of photoluminescence (PL) efficiency, PL lineshape, carrier diffusion, and surface recombination, over multiple orders of photo-excitation density. An analytic model is used to describe the excitation density dependence of PL intensity and extract the internal PL efficiency and multiple pertinent recombination parameters. A PL imaging technique is used to obtain carrier diffusion length without using a PL quencher, thus, free of unintended influence beyond pure diffusion. Our results show that perovskite samples tend to exhibit lower Shockley-Read-Hall (SRH) recombination rate in both bulk and surface, thus higher PL efficiency than the inorganic counterparts, particularly under low excitation density, even with no or preliminary surface passivation. PL lineshape and diffusion analysis indicate that there is considerable structural disordering in the perovskite materials, and thus photo-generated carriers are not in global thermal equilibrium, which in turn suppresses the nonradiative recombination. This study suggests that relatively low point-defect density, less detrimental surface recombination, and moderate structural disordering contribute to the high PV efficiency in the perovskite. This comparative photovoltaics study provides more insights into the fundamental material science and the search for optimal device designs by learning from different technologies.