Quality factor for zero-bias conductance peaks in Majorana nanowire
Despite recent experimental progress towards observing large zero-bias conductance peaks (ZBCPs) as signatures of Majorana modes, confusion remains about whether Majorana modes have been observed. This is in part due to the theoretical prediction of fine-tuned trivial (i.e., non-topological) zero-bias peaks that occur because of uncontrolled quantum dots or disorder potentials. While many aspects of the topological phase can be somewhat fine-tuned because the topological phase space is often small, the quantized height of the ZBCP associated with a Majorana mode is known to be robust at sufficiently low temperatures even as the tunnel barrier is pinched off to vanishingly small normal-state conductance. The key shortcoming of the existing experimental works is an acute lack of stability of the putative Majorana mode features, indicating the probable absence of a topological phase, and the current paper suggests specific experimentally accessible measures for a careful quantitative analysis of the measured ZBCP stability. In this paper, we study how the counter-intuitive robustness of the ZBCP height to the tunnel barrier strength can be used to distinguish Majorana modes from non-topological ZBCPs. To this end, we introduce a dimensionless quality factor $F$ to quantify the robustness of the ZBCP height based on the range of normal-state (i.e. above-gap) conductance (which depends crucially on the tunnel barrier height) over which the ZBCP height remains within a pre-specified range of quantization. By computing this quality factor $F$ together with the topological characteristics for a wide range of models and parameters, we find that Majoranas are significantly more robust (i.e., have a higher value of $F$) compared with non-topological ZBCPs in the ideal low-temperature limit. Even at a temperature as high as the experimentally used $20$ mK, we find that we can set a threshold value of $F\sim 2.5$ (for $ε=0.1$) so that ZBCPs associated with a quality factor $F>2.5$ are likely topological and $F\ll 2.5$ are topologically trivial. More precisely, the value of $F$ is operationally related to the degree of separation of the Majorana modes in the system, although $F$ uses only the experimentally measured tunnel conductance properties. Finally, we discuss how the quality factor $F$ measured in a transport setup can help estimate the quality of topological qubits made from Majorana modes. In particular, we show that if the induced gap can be enhanced somehow beyond the currently available $\sim 30$ $μ$eV in InAs/Al samples, large (small) values of $F$ could easily distinguish between stable topological (unstable trivial) ZBCPs with the quantum dot induced quasi-Majorana bound states occasionally behaving similar to topological Majorana modes in short wires.