Source author record

Y. -K. Ko

Y. -K. Ko appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

astro-ph.SR astro-ph

Catalog footprint

What is connected

6works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2011arXiv

Transition Region Emission from Solar Flares during the Impulsive Phase

There are relatively few observations of UV emission during the impulsive phases of solar flares, so the nature of that emission is poorly known. Photons produced by solar flares can resonantly scatter off atoms and ions in the corona. Based on off-limb measurements by SOHO/UVCS, we derive the O VI $λ$1032 luminosities for 29 flares during the impulsive phase and the Ly$α$ luminosities of 5 flares, and we compare them with X-ray luminosities from GOES measurements. The upper transition region and lower transition region luminosities of the events observed are comparable. They are also comparable to the luminosity of the X-ray emitting gas at the beginning of the flare, but after 10-15 minutes the X-ray luminosity usually dominates. In some cases we can use Doppler dimming to estimate flow speeds of the O VI emitting gas, and 5 events show speeds in the 40 to 80 $\rm km s^{-1}$ range. The O VI emission could originate in gas evaporating to fill the X-ray flare loops, in heated chromospheric gas at the footpoints, or in heated prominence material in the coronal mass ejection. All three sources may contribute in different events or even in a single event, and the relative timing of UV and X-ray brightness peaks, the flow speeds, and the total O VI luminosity favor each source in one or more events.

preprint2010arXiv

Science Objectives for an X-Ray Microcalorimeter Observing the Sun

We present the science case for a broadband X-ray imager with high-resolution spectroscopy, including simulations of X-ray spectral diagnostics of both active regions and solar flares. This is part of a trilogy of white papers discussing science, instrument (Bandler et al. 2010), and missions (Bookbinder et al. 2010) to exploit major advances recently made in transition-edge sensor (TES) detector technology that enable resolution better than 2 eV in an array that can handle high count rates. Combined with a modest X-ray mirror, this instrument would combine arcsecondscale imaging with high-resolution spectra over a field of view sufficiently large for the study of active regions and flares, enabling a wide range of studies such as the detection of microheating in active regions, ion-resolved velocity flows, and the presence of non-thermal electrons in hot plasmas. It would also enable more direct comparisons between solar and stellar soft X-ray spectra, a waveband in which (unusually) we currently have much better stellar data than we do of the Sun.

preprint2010arXiv

Ultraviolet Coronagraph Spectroscopy: A Key Capability for Understanding the Physics of Solar Wind Acceleration

Understanding the physical processes responsible for accelerating the solar wind requires detailed measurements of the collisionless plasma in the extended solar corona. Some key clues about these processes have come from instruments that combine the power of an ultraviolet (UV) spectrometer with an occulted telescope. This combination enables measurements of ion emission lines far from the bright solar disk, where most of the solar wind acceleration occurs. Although the UVCS instrument on SOHO made several key discoveries, many questions remain unanswered because its capabilities were limited. This white paper summarizes these past achievements and also describes what can be accomplished with next-generation instrumentation of this kind.

preprint2009arXiv

Morphology and density of post-CME current sheets

Eruption of a coronal mass ejection (CME) drags and "opens" the coronal magnetic field, presumably leading to the formation of a large-scale current sheet and the field relaxation by magnetic reconnection. We analyze physical characteristics of ray-like coronal features formed in the aftermath of CMEs, to check if the interpretation of this phenomenon in terms of reconnecting current sheet is consistent with the observations. The study is focused on measurements of the ray width, density excess, and coronal velocity field as a function of the radial distance. The morphology of rays indicates that they occur as a consequence of Petschek-like reconnection in the large scale current sheet formed in the wake of CME. The hypothesis is supported by the flow pattern, often showing outflows along the ray, and sometimes also inflows into the ray. The inferred inflow velocities range from 3 to 30 km s$^{-1}$, consistent with the narrow opening-angle of rays, adding up to a few degrees. The density of rays is an order of magnitude larger than in the ambient corona. The density-excess measurements are compared with the results of the analytical model in which the Petschek-like reconnection geometry is applied to the vertical current sheet, taking into account the decrease of the external coronal density and magnetic field with height. The model results are consistent with the observations, revealing that the main cause of the density excess in rays is a transport of the dense plasma from lower to larger heights by the reconnection outflow.

preprint2008arXiv

Three Dimensional Structure and Energy Balance of a Coronal Mass Ejection

The Ultraviolet Coronagraph Spectrometer (UVCS) observed Doppler shifted material of a partial Halo Coronal Mass Ejection (CME) on December 13 2001. The observed ratio of [O V]/O V] is a reliable density diagnostic important for assessing the state of the plasma. Earlier UVCS observations of CMEs found evidence that the ejected plasma is heated long after the eruption. We have investigated the heating rates, which represent a significant fraction of the CME energy budget. The parameterized heating and radiative and adiabatic cooling have been used to evaluate the temperature evolution of the CME material with a time dependent ionization state model. The functional form of a flux rope model for interplanetary magnetic clouds was also used to parameterize the heating. We find that continuous heating is required to match the UVCS observations. To match the O VI-bright knots, a higher heating rate is required such that the heating energy is greater than the kinetic energy. The temperatures for the knots bright in Ly$α$ and C III emission indicate that smaller heating rates are required for those regions. In the context of the flux rope model, about 75% of the magnetic energy must go into heat in order to match the O VI observations. We derive tighter constraints on the heating than earlier analyses, and we show that thermal conduction with the Spitzer conductivity is not sufficient to account for the heating at large heights.

preprint2007arXiv

Transition Region Emission and Energy Input to Thermal Plasma During the Impulsive Phase of Solar Flares

The energy released in a solar flare is partitioned between thermal and non-thermal particle energy and lost to thermal conduction and radiation over a broad range of wavelengths. It is difficult to determine the conductive losses and the energy radiated at transition region temperatures during the impulsive phases of flares. We use UVCS measurements of O VI photons produced by 5 flares and subsequently scattered by O VI ions in the corona to determine the 5.0 < log T < 6.0 transition region luminosities. We compare them with the rates of increase of thermal energy and the conductive losses deduced from RHESSI and GOES X-ray data using areas from RHESSI images to estimate the loop volumes, cross-sectional areas and scale lengths. The transition region luminosities during the impulsive phase exceed the X-ray luminosities for the first few minutes, but they are smaller than the rates of increase of thermal energy unless the filling factor of the X-ray emitting gas is ~ 0.01. The estimated conductive losses from the hot gas are too large to be balanced by radiative losses or heating of evaporated plasma, and we conclude that the area of the flare magnetic flux tubes is much smaller than the effective area measured by RHESSI during this phase of the flares. For the 2002 July 23 flare, the energy deposited by non-thermal particles exceeds the X-ray and UV energy losses and the rate of increase of the thermal energy.