Source author record

Y. -H. Ma

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

cond-mat.soft cond-mat.dis-nn

Catalog footprint

Research overview

4works

2topics

4close collaborators

Actions

Is this your work?

Open graph Browse papers

preprint2014arXiv

Self-consistent field theoretic simulations of amphiphilic triblock copolymer solutions: Polymer concentration and chain length effects

Using the self-consistent field lattice model, polymer concentration $\barϕ_{P}$ and chain length $N$ (keeping the length ratio of hydrophobic to hydrophilic blocks constant) the effects on temperature-dependent behavior of micelles are studied, in amphiphilic symmetric ABA triblock copolymer solutions. When chain length is increased, at fixed $\barϕ_{P}$ , micelles occur at higher temperature. The variations of average volume fraction of stickers $\barϕ_\textrm{co}^\textrm{s}$ and the lattice site numbers $N_\textrm{co}^\textrm{ls}$ at the micellar cores with temperature are dependent on $N$ and $\barϕ_{P}$ , which demonstrates that the aggregation of micelles depends on $N$ and $\barϕ_{P}$ . Moreover, when $\barϕ_{P}$ is increased, firstly a peak appears on the curve of specific heat $C_V$ for unimer-micelle transition, and then in addition a primary peak, the secondary peak, which results from the remicellization, is observed on the curve of $C_V$ . For a long chain, in intermediate and high concentration regimes, the shape of specific heat peak markedly changes, and the peak tends to be a more broad peak. Finally, the aggregation behavior of micelles is explained by the aggregation way of amphiphilic triblock copolymer. The obtained results are helpful in understanding the micellar aggregation process.

preprint2013arXiv

Effect of polymer concentration and length of hydrophobic end block on the unimer-micelle transition broadness in amphiphilic ABA symmetric triblock copolymer solutions

The effects of the length of each hydrophobic end block N_{st} and polymer concentration \barϕ_{P} on the transition broadness in amphiphilic ABA symmetric triblock copolymer solutions are studied using the self-consistent field lattice model. When the system is cooled, micelles are observed, i.e.,the homogenous solution (unimer)-micelle transition occurs. When N_{st} is increased, at fixed \barϕ_{P}, micelles occur at higher temperature, and the temperature-dependent range of micellar aggregation and half-width of specific heat peak for unimer-micelle transition increase monotonously. Compared with associative polymers, it is found that the magnitude of the transition broadness is determined by the ratio of hydrophobic to hydrophilic blocks, instead of chain length. When \barϕ_{P} is decreased, given a large N_{st}, the temperature-dependent range of micellar aggregation and half-width of specific heat peak initially decease, and then remain nearly constant. It is shown that the transition broadness is concerned with the changes of the relative magnitudes of the eductions of nonstickers and solvents from micellar cores.

preprint2012arXiv

Effect of distribution of stickers along backbone on temperature-dependent structural properties in associative polymer solutions

Effect of distribution of stickers along the backbone on structural properties in associating polymer solutions is studied using self-consistent field lattice model. Only two inhomogeneous morphologies, i.e., microfluctuation homogenous (MFH) and micelle morphologies, are observed. If the system is cooled, the solvent content within the aggregates decreases. When the spacing of stickers along the backbone is increased the temperature-dependent range of aggregation in MFH morphology and half-width of specific heat peak for homogenous solutions-MFH transition increase, and the symmetry of the peak decreases. However, with increasing spacing of stickers, the above three corresponding quantities related to micelles behave differently. It is demonstrated that the broad nature of the observed transitions can be ascribed to the structural changes which accompany the replacement of solvents in aggregates by polymer, which is consistent with the experimental conclusion. It is found that different effect of spacing of stickers on the two transitions can be interpreted in terms of intrachain and interchain associations.

preprint2012arXiv

Effects of polymer concentration and chain length on aggregation in physically associating polymer solutions

The effects of polymer concentration and chain length on aggregation in associative polymer solutions, are studied using self-consistent field lattice model. Only two inhomogenous morphologies, i.e. microfluctuation homogenous (MFH) and micelle morphologies, are observed in the systems with different chain lengths. The temperatures at which the above two inhomogenous morphologies first appear, which are denoted by T_MFH and T_m, respectively, are dependent on polymer concentration and chain length. The variation of the logarithm of critical MFH concentration with the logarithm of chain length fulfils a linear-fitting relationship with a slope equaling -1. Furthermore, the variation of the average volume fraction of stickers at the micellar core (AVFSM) with polymer concentration and chain length is focused in the system at T_m. It is founded by calculations that the above behavior of AVFSM, is explained in terms of intrachain and interchain associations.

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.