Source author record

Tanvir Hussain

Tanvir Hussain appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

astro-ph.GA cond-mat.mtrl-sci physics.app-ph

Catalog footprint

What is connected

4works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2021arXiv

Steam Degradation of Ytterbium Disilicate Environmental Barrier Coatings: Effect of Composition, Microstructure and Temperature

Recession of environmental barrier coatings (EBC) in environments containing steam is a pressing concern that requires further research before their implementation in gas turbine engines can be realized. In this work, free-standing plasma sprayed Yb2Si2O7 coatings were exposed to flowing steam at 1350 °C and 1400 °C for 96 h. Three samples were investigated, one coating with a low porosity level (< 3 %) and 1 wt.% Al2O3 representing traditional EBCs; and two coatings with higher porosity levels (~20 %) representing abradable EBCs. Phase composition and microstructural evolution were studied in order to reveal the underlying mechanism for the interaction between high temperature steam and ytterbium disilicate. The results show depletion of Yb2SiO5 near the surface and formation of ytterbium garnet (Yb3Al5O12) on top of all three coatings due to the reaction with gaseous Al-containing impurities coming from the alumina furnace tubes. The 1 wt.% Al2O3 added to the EBC sample exacerbated the formation of garnet at 1400 °C compared to the abradable samples, which presented lower quantities of garnet. Additionally, inter-splat boundaries were visible after exposure, indicating preferential ingress of gaseous Al-containing impurities through the splat boundaries

preprint2020arXiv

Evolution of Porosity in Suspension Thermal Sprayed YSZ Thermal Barrier Coatings through Neutron Scattering and Image Analysis Techniques

Porosity is a key parameter on thermal barrier coatings, directly influencing thermal conductivity and strain tolerance. Suspension high velocity oxy-fuel (SHVOF) thermal spraying enables the use of sub-micron particles as feedstock, increasing control over porosity and introducing nano-sized pores; these fine-scale porosities being challenging to measure. Neutron scattering represents a non-destructive technique, capable of studying porosity with a pore size range of 1 nm to 10 um, thanks to the combination of small-angle (SANS) and ultra-small-angle neutron scattering (USANS) techniques. Image Analysis (IA) on digital images allows for the study of porosity with a size above ~100 nm. In this work, two yttria-stabilised zirconia (ZrO2 with 8 wt.% Y2O3) suspensions were sprayed and heat treated at 1100, 1200, 1300 and 1400 °C for 72 h. For the first time in SHVOF 8YSZ, pore size distribution, total porosity and pore morphology were studied using SANS & USANS and IA to determine the effects of heat treatment. X-ray diffraction and micro-hardness measurements were performed to study the phase transformation, and its effects on the mechanical properties of the coating. The results show an abundant presence of nano-pores in the as-sprayed coatings, which are eliminated during heat treatment at 1100 °C; a transition from inter-splat lamellar pores to globular pores and the appearance of micro-cracks along with the accumulation of micro-strains associated with the phase transformation from the initial metastable tetragonal into tetragonal and cubic phases at 1200 °C. The phase transformation was completed at 1400 °C, with no presence of monoclinic phase

preprint2016arXiv

Detection of emission lines from z ~ 3 DLAs towards the QSO J2358+0149

Using VLT/X-shooter we searched for emission line galaxies associated to four damped Lyman-$α$ systems (DLAs) and one sub-DLA at 2.73<=z<=3.25 towards QSO J2358+0149. We detect [O III] emission from a "low-cool" DLA at z_abs = 2.9791 (having log N(HI)=21.69+\-0.10, [Zn/H] = -1.83+\-0.18) at an impact parameter of, $ρ$ ~12 kpc. The associated galaxy is compact with a dynamical mass of (1-6)x10^9 M_solar, very high excitation ([O III]/[O II] and [O III]/[H$β$] both greater than 10), 12+[O/H]<=8.5 and moderate star formation rate (SFR <=2 M_solar yr^{-1}). Such properties are typically seen in the low-z extreme blue compact dwarf galaxies. The kinematics of the gas is inconsistent with that of an extended disk and the gas is part of either a large scale wind or cold accretion. We detect Ly$α$ emission from the z_abs = 3.2477 DLA (having log N(HI)=21.12+\-0.10 and [Zn/H]=-0.97+\-0.13).The Ly$α$ emission is redshifted with respect to the metal absorption lines by 320 km s^{-1}, consistent with the location of the red hump expected in radiative transport models. We derive SFR ~0.2-1.7 M_solar yr^{-1} and Ly$α$ escape fraction of >=10 per cent. No other emission line is detected from this system. Because the DLA has a small velocity separation from the quasar (~500 km s^{-1}) and the DLA emission is located within a small projected distance ($ρ<5$ kpc), we also explore the possibility that the Ly$α$ emission is being induced by the QSO itself. QSO induced Ly$α$ fluorescence is possible if the DLA is within a physical separation of 340 kpc to the QSO. Detection of stellar continuum light and/or the oxygen emission lines would disfavor this possibility. We do not detect any emission line from the remaining three systems.

preprint2014arXiv

HST/COS detection of a Ne VIII absorber towards PG 1407+265: An unambiguous tracer of collisionally ionized hot gas?

We report the detection of Ne VIII in a z_abs = 0.59961 absorber towards the QSO PG 1407+265 (z_em = 0.94). Besides Ne VIII, absorption from HI Lyman series lines (HI 1025 - 915), several other low (C II, N II, O II, and S II), intermediate (C III, N III, N IV, O III, S IV, and S V) and high (S VI, O VI, and Ne VIII) ionization metal lines are detected. Disparity in the absorption line kinematics between different ions implies that the absorbing gas comprises of multiple ionization phases. The low and the intermediate ions (except S V) trace a compact (~ 410 pc), metal-rich (Z ~ Z_sun) and over-dense (log n_H ~ -2.6) photoionized region that sustained star-formation for a prolonged period. The high ions, Ne VIII and O VI, can be explained as arising in a low density (-5.3 < log n_H < -5.0), metal-rich (Z > Z_sun) and diffuse (~ 180 kpc) photoionized gas. The S V, S VI and C IV (detected in the FOS spectrum) require an intermediate photoionization phase with -4.2 < log n_H < -3.5. Alternatively, a pure collisional ionization model, as used to explain the previous known Ne VIII absorbers, with 5.65 < log T < 5.72, can reproduce the S VI, O VI, and Ne VIII column densities simultaneously in a single phase. However, even such models require an intermediate phase to reproduce any observable S V and/or C IV. Therefore, we conclude that when multiple phases are present, the presence of Ne VIII is not necessarily an unambiguous indication of collisionally ionized hot gas.