Source author record

Sean S. Lindsay

Sean S. Lindsay appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

astro-ph.EP

Catalog footprint

What is connected

3works

1topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

A new method for deriving composition of S-type asteroids from noisy and incomplete near-infrared spectra

The surface composition of S-type asteroids can be determined using band parameters extracted from their near-infrared (NIR) spectra (0.7-2.50 $μ$m) along with spectral calibrations derived from laboratory samples. In the past, these empirical equations have been obtained by combining NIR spectra of meteorite samples with information about their composition and mineral abundance. For these equations to give accurate results, the characteristics of the laboratory spectra they are derived from should be similar to those of asteroid spectral data (i.e., similar signal-to-noise ratio (S/N) and wavelength range). Here we present new spectral calibrations that can be used to determine the mineral composition of ordinary chondrite-like S-type asteroids. Contrary to previous work, the S/N of the ordinary chondrite spectra used in this study has been decreased to recreate the S/N typically observed among asteroid spectra, allowing us to obtain more realistic results. In addition, the new equations have been derived for five wavelength ranges encompassed between 0.7 and 2.50 $μ$m, making it possible to determine the composition of asteroids with incomplete data. The new spectral calibrations were tested using band parameters measured from the NIR spectrum of asteroid (25143) Itokawa, and comparing the results with laboratory measurements of the returned samples. We found that the spectrally derived olivine and pyroxene chemistry, which are given by the molar contents of fayalite (Fa) and ferrosilite (Fs), are in excellent agreement with the mean values measured from the samples (Fa$_{28.6\pm1.1}$ and Fs$_{23.1\pm2.2}$), with a maximum difference of 0.6 mol\% for Fa and 1.4 mol\% for Fs.

preprint2014arXiv

Composition, Mineralogy, and Porosity of Multiple Asteroid Systems from Visible and Near-infrared Spectral Data

We provide a taxonomic and compositional characterization of Multiple Asteroid Systems (MASs) located in the main belt (MB) using visible and near-infrared (0.45-2.5 um) spectral data of 42 MB MASs. The mineralogical analysis is applied to determine meteorite analogs for the MASs, which, in turn, are applied to the MAS density measurements of Marchis et al. (2012) to estimate the system porosity. The macroporosities are used to evaluate the primary MAS formation hypotheses. The visible observing campaign includes 25 MASs obtained using the SOAR telescope with the Goodman High Throughput Spectrometer. The infrared observing campaign includes 34 MASs obtained using the NASA IRTF with the SpeX spectragraph. The MASs are classified using the Bus-DeMeo taxonomic system. We perform a NIR spectral band parameter analysis using a new analysis routine, the Spectral Analysis Routine for Asteroids (SARA). The SARA routine determines band centers, areas, and depths by utilizing the diagnostic absorption features near 1- and 2-um. The band parameter analysis provides the Gaffey subtype for the S-type MASs; the relative abundance olivine-to-pyroxene ratio; and olivine and pyroxene modal abundances for S-complex and V-type MASs. This mineralogical information is applied to determine meteorite analogs. We determine the H, L, and LL meteorite analogs for 15 MASs with ordinary chondrite-like (OC) mineralogies. We observe an excess (10/15) of LL-like mineralogies. Of the MASs with LL-like mineralogies, seven are consistent with Flora family membership, supporting the hypothesis that the Flora family is a source of LL-like NEAs and LL chondrites on Earth. Using the measured densities of the meteorite analog and the MAS densities from Marchis et al. (2012), we estimate the macroporosity for 13 MASs and find that all estimated macroporosities are in agreement with formation hypotheses.

preprint2013arXiv

Absorption Efficiencies of Forsterite. I: DDA Explorations in Grain Shape and Size

We compute the absorption efficiency (Qabs) of forsterite using the discrete dipole approximation (DDA) in order to identify and describe what characteristics of crystal grain shape and size are important to the shape, peak location, and relative strength of spectral features in the 8-40 μm wavelength range. Using the DDSCAT code, we compute Qabs for non-spherical polyhedral grain shapes with a_eff = 0.1 μm. The shape characteristics identified are: 1) elongation/reduction along one of three crystallographic axes; 2) asymmetry, such that all three crystallographic axes are of different lengths; and 3) the presence of crystalline faces that are not parallel to a specific crystallographic axis, e.g., non-rectangular prisms and (di)pyramids. Elongation/reduction dominates the locations and shapes of spectral features near 10, 11, 16, 23.5, 27, and 33.5 μm, while asymmetry and tips are secondary shape effects. Increasing grain sizes (0.1-1.0 μm) shifts the 10, 11 μm features systematically towards longer wavelengths and relative to the 11 μm feature increases the strengths and slightly broadens the longer wavelength features. Seven spectral shape classes are established for crystallographic a-, b-, and c-axes and include columnar and platelet shapes plus non-elongated or equant grain shapes. The spectral shape classes and the effects of grain size have practical application in identifying or excluding columnar, platelet or equant forsterite grain shapes in astrophysical environs. Identification of the shape characteristics of forsterite from 8-40 μm spectra provides a potential means to probe the temperatures at which forsterite formed.