Researcher profile

S. V. Shchelkunov

S. V. Shchelkunov contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 13 - Baseline
2works
0followers
1topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2015arXiv

Compact Low-Voltage, High-Power, Multi-beam Klystron for ILC: Initial Test Results

Initial test results of an L-band multi-beam klystron with parameters relevant for ILC are presented. The chief distinction of this tube from MBKs already developed for ILC is its low operating voltage of 60 kV, a virtue that implies considerable technological simplifications in the accelerator complex. To demonstrate the concept underlying the tubes design, a six-beamlet quadrant (a 54 inch high one-quarter portion of the full 1.3 GHz tube) was built and recently underwent initial tests, with main goals of demonstrating rated gun perveance, rated gain, and at least one-quarter of the full 10-MW rated power. Our initial three-day conditioning campaign without RF drive (140 microsec pulses @ 60 Hz) was stopped at 53% of full rated duty because of time-limits at the test-site; no signs appeared that would seem to prevent achieving full duty operation (i.e., 1.6 msec pulses @ 10 Hz). The subsequent tests with 10-15 microsec RF pulses confirmed the rated gain, produced output powers of up to 2.86 MW at 60 kV with high efficiency and 56 dB gain, and showed acceptable beam interception. These results suggest that a full version of the tube should be able to produce up to 11.5 MW. Follow-on tests are planned for later in 2015.

preprint2015arXiv

Diagnostic and Detectors for Charging and Damage of Dielectrics in High-gradient Accelerators

The research is aimed to address issues of analysis and mitigation of high repetition rate effects in Dielectric Wakefield Accelerators, and more specifically, to study charging rate and charge distribution in a thin walled dielectric wakefield accelerator from a passing charge bunch and the physics of conductivity and discharge phenomena in dielectric materials useful for such accelerator applications. The issue is the role played by the beam halo and intense wakefields in charging of the dielectric, possibly leading to undesired deflection of charge bunches and degradation of the dielectric material. The detector that was developed is based on measurement of the complex electrical conductivity, which would appear as a transient phenomenon accompanying the passage of one or more charge bunches, by observing the change of complex admittance of a resonant microwave cavity that is fitted around the dielectric tubing. The detector also can detect permanent damage to the material. During initial stage of development, microwave apparatus was built and signal processing was developed for observing time-dependent electronic charging of dielectric surfaces and/or plasmas located on or near the inner surface of a thin-wall hollow dielectric tube. Three frequencies were employed to improve the data handling rate and the signal-to-noise. The test and performance results for a plasma test case will be presented; in particular, the performance of the test unit showed capability to detect small changes ~ 0.1% of a dielectric constant, which would correspond to the scraping-off of only 0.3nC to the walls of the dielectric liner inside the cavity from the passing charge bunch.