Source author record

Patrick Milan

Patrick Milan appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.data-an physics.flu-dyn

Catalog footprint

What is connected

3works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2015arXiv

Langevin power curve analysis for numerical WEC models with new insights on high frequency power performance

Based on the Langevin equation it has been proposed to obtain power curves for wind turbines from high frequency data of wind speed measurements u(t) and power output P (t). The two parts of the Langevin approach, power curve and drift field, give a comprehensive description of the conversion dynamic over the whole operating range of the wind turbine. The method deals with high frequent data instead of 10 min means. It is therefore possible to gain a reliable power curve already from a small amount of data per wind speed. Furthermore, the method is able to visualize multiple fixed points, which is e.g. characteristic for the transition from partial to full load or in case the conversion process deviates from the standard procedures. In order to gain a deeper knowledge it is essential that the method works not only for measured data but also for numerical wind turbine models and synthetic wind fields. Here, we characterize the dynamics of a detailed numerical wind turbine model and calculate the Langevin power curve for different data samplings. We show, how to get reliable results from synthetic data and verify the applicability of the method for field measurements with ultra-sonic, cup and Lidar measurements. The independence of the fixed points on site specific turbulence effects is also confirmed with the numerical model. Furthermore, we demonstrate the potential of the Langevin approach to detect failures in the conversion process and thus show the potential of the Langevin approach for a condition monitoring system.

preprint2015arXiv

Stochastic modeling and performance monitoring of wind farm power production

We present a new stochastic approach to describe and remodel the conversion process of a wind farm at a sampling frequency of 1Hz. When conditioning on various wind direction sectors, the dynamics of the conversion process appear as a fluctuating trajectory around an average IEC-like power curve, see section II. Our approach is to consider the wind farm as a dynamical system that can be described as a stochastic drift/diffusion model, where a drift coefficient describes the attraction towards the power curve and a diffusion coefficient quantifies additional turbulent fluctuations. These stochastic coefficients are inserted into a Langevin equation that, once properly adapted to our particular system, models a synthetic signal of power output for any given wind speed/direction signals, see section III. When combined with a pre-model for turbulent wind fluctuations, the stochastic approach models the power output of the wind farm at a sampling frequency of 1Hz using only ten-minute average values of wind speed and directions. The stochastic signals generated are compared to the measured signal, and show a good statistical agreement, including a proper reproduction of the intermittent, gusty features measured. In parallel, a second application for performance monitoring is introduced in section IV. The drift coefficient can be used as a sensitive measure of the global wind farm performance. When monitoring the wind farm as a whole, the drift coefficient registers some significant deviation from normal operation if one of twelve wind turbines is shut down during less than 4% of the time. Also, intermittent anomalies can be detected more rapidly than when using ten-minute averaging methods. Finally, a probabilistic description of the conversion process is proposed and modeled in appendix A, that can in turn be used to further improve the estimation of the stochastic coefficients.

preprint2012arXiv

Wind Energy and the Turbulent Nature of the Atmospheric Boundary Layer

Wind turbines operate in the atmospheric boundary layer, where they are exposed to the turbulent atmospheric flows. As the response time of wind turbine is typically in the range of seconds, they are affected by the small scale intermittent properties of the turbulent wind. Consequently, basic features which are known for small-scale homogeneous isotropic turbulence, and in particular the well-known intermittency problem, have an important impact on the wind energy conversion process. We report on basic research results concerning the small-scale intermittent properties of atmospheric flows and their impact on the wind energy conversion process. The analysis of wind data shows strongly intermittent statistics of wind fluctuations. To achieve numerical modeling a data-driven superposition model is proposed. For the experimental reproduction and adjustment of intermittent flows a so-called active grid setup is presented. Its ability is shown to generate reproducible properties of atmospheric flows on the smaller scales of the laboratory conditions of a wind tunnel. As an application example the response dynamics of different anemometer types are tested. To achieve a proper understanding of the impact of intermittent turbulent inflow properties on wind turbines we present methods of numerical and stochastic modeling, and compare the results to measurement data. As a summarizing result we find that atmospheric turbulence imposes its intermittent features on the complete wind energy conversion process. Intermittent turbulence features are not only present in atmospheric wind, but are also dominant in the loads on the turbine, i.e. rotor torque and thrust, and in the electrical power output signal. We conclude that profound knowledge of turbulent statistics and the application of suitable numerical as well as experimental methods are necessary to grasp these unique features (...)