Source author record

Manuel Ricardo

Manuel Ricardo appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Networking and Internet Architecture eess.SP

Catalog footprint

What is connected

6works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Energy-aware Relay Positioning in Flying Networks

The ability to move and hover has made rotary-wing Unmanned Aerial Vehicles (UAVs) suitable platforms to act as Flying Communications Relays (FCR), aiming at providing on-demand, temporary wireless connectivity when there is no network infrastructure available or a need to reinforce the capacity of existing networks. However, since UAVs rely on their on-board batteries, which can be drained quickly, they typically need to land frequently for recharging or replacing them, limiting their endurance and the flying network availability. The problem is exacerbated when a single FCR UAV is used. The FCR UAV energy is used for two main tasks: communications and propulsion. The literature has been focused on optimizing both the flying network performance and energy-efficiency from the communications point of view, overlooking the energy spent for the UAV propulsion. Yet, the energy spent for communications is typically negligible when compared with the energy spent for the UAV propulsion. In this article we propose Energy-aware RElay Positioning (EREP), an algorithm for positioning the FCR taking into account the energy spent for the UAV propulsion. Building upon the conclusion that hovering is not the most energy-efficient state, EREP defines the trajectory and speed that minimize the energy spent by the FCR UAV on propulsion, without compromising in practice the Quality of Service offered by the flying network. The EREP algorithm is evaluated using simulations. The obtained results show gains up to 26% in the FCR UAV endurance for negligible throughput and delay degradation.

preprint2022arXiv

Traffic-aware Gateway Placement and Queue Management in Flying Networks

Unmanned Aerial Vehicles (UAVs) have emerged as adequate platforms to carry communications nodes, including Wi-Fi Access Points and cellular Base Stations. This has led to the concept of flying networks composed of UAVs as a flexible and agile solution to provide on-demand wireless connectivity anytime, anywhere. However, state of the art works have been focused on optimizing the placement of the access network providing connectivity to ground users, overlooking the backhaul network design. In order to improve the overall Quality of Service (QoS) offered to ground users, the placement of Flying Gateways (FGWs) and the size of the queues configured in the UAVs need to be carefully defined to meet strict performance requirements. The main contribution of this article is a traffic-aware gateway placement and queue management (GPQM) algorithm for flying networks. GPQM takes advantage of knowing in advance the positions of the UAVs and their traffic demand to determine the FGW position and the queue size of the UAVs, in order to maximize the aggregate throughput and provide stochastic delay guarantees. GPQM is evaluated by means of ns-3 simulations, considering a realistic wireless channel model. The results demonstrate significant gains in the QoS offered when GPQM is used.

preprint2021arXiv

A Fast Gateway Placement Algorithm for Flying Networks

The ability to operate anywhere, anytime, as well as their capability to hover and carry cargo on board make Unmanned Aerial Vehicles (UAVs) suitable platforms to act as Flying Gateways (FGWs) to the Internet. The problem is the optimal placement of the FGWs within the flying network, such that the Quality of Service (QoS) offered is maximized. The literature has been focused on optimizing the placement of the Flying Access Points (FAPs), which establish high-capacity small cells to serve the users on the ground, overlooking the backhaul network design, including the FGW placement. The FGW placement problem is exacerbated in highly dynamic flying networks, where the dynamic traffic demand and the movements of the users may induce frequent changes in the placement of the FAPs. The main contribution of this paper is a fast gateway placement (F-GWP) algorithm for flying networks that determines the optimal position of a FGW. With F-GWP, backhaul communications paths with high enough capacity are established between the FAPs and the FGW, in order to accommodate the traffic demand of the users on the ground. Simulation and experimental results show F-GWP is two orders of magnitude faster than its state of the art counterpart, while ensuring the same flying network performance.

preprint2021arXiv

Traffic-aware Gateway Placement for High-capacity Flying Networks

The ability to operate virtually anywhere and carry payload makes Unmanned Aerial Vehicles (UAVs) perfect platforms to carry communications nodes, including Wi-Fi Access Points (APs) and cellular Base Stations (BSs). This is paving the way to the deployment of flying networks that enable communications to ground users on demand. Still, flying networks impose significant challenges in order to meet the Quality of Experience expectations. State of the art works addressed these challenges, but have been focused on routing and the placement of the UAVs as APs and BSs serving the ground users, overlooking the backhaul network design. The main contribution of this paper is a centralized traffic-aware Gateway UAV Placement (GWP) algorithm for flying networks with controlled topology. GWP takes advantage of the knowledge of the offered traffic and the future topologies of the flying network to enable backhaul communications paths with high enough capacity. The performance achieved using the GWP algorithm is evaluated using ns-3 simulations. The obtained results demonstrate significant gains regarding aggregate throughput and delay.

preprint2020arXiv

On the Reproduction of Real Wireless Channel Occupancy in ns-3

In wireless networking R&D we typically depend on simulation and experimentation to evaluate and validate new networking solutions. While simulations allow full control over the scenario conditions, real-world experiments are influenced by external random phenomena and may produce hardly repeatable and reproducible results, impacting the validation of the solution under evaluation. Previously, we have proposed the Trace-based Simulation (TS) approach to address the problem. TS uses traces of radio link quality and position of nodes to accurately reproduce past experiments in ns-3. Yet, in its current version, the TS approach is not compatible with scenarios where the radio spectrum is shared with concurrent networks, as it does not reproduce their channel occupancy. In this paper, we introduce the InterferencePropagationLossModel and a modified MacLow to allow reproducing the channel occupancy experienced in past experiments. To validate the proposed models, the network throughput was measured in different experiments performed in the w-iLab.t testbed, controlling the channel occupancy introduced by concurrent networks. The experimental results were then compared with the network throughput achieved using the improved TS approach, the legacy TS approach, and pure simulation, validating the new proposed models and confirming their relevance to reproduce experiments previously executed in real environments.

preprint2015arXiv

Power Interference Modeling for CSMA/CA based Networks using Directional Antenna

In IEEE 802.11 based wireless networks adding more access points does not always guarantee an increase of network capacity. In some cases, additional access points may contribute to degrade the aggregated network throughput as more interference is introduced. This paper characterizes the power interference in CSMA/CA based networks consisting of nodes using directional antenna. The severity of the interference is quantized via an improved form of the Attacking Case metric as the original form of this metric was developed for nodes using omnidirectional antenna. The proposed metric is attractive because it considers nodes using directional or omnidirectional antenna, and it enables the quantization of interference in wireless networks using multiple transmission power schemes. The improved Attacking Case metric is useful to study the aggregated throughput of IEEE 802.11 based networks; reducing Attacking Case probably results in an increase of aggregated throughput. This reduction can be implemented using strategies such as directional antenna, transmit power control, or both.