Source author record

Magnus H. Sørby

Magnus H. Sørby appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

2works
1topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2020arXiv

Electron doping of the layered nickelate La$_4$Ni$_3$O$_{10}$ by aluminum substitution: A combined experimental and DFT study

The physical properties of La$_4$Ni$_3$O$_{10}$ with a 2D-like Ruddlesden-Popper-type crystal structure are extraordinarily dependent on temperature and chemical substitution. By introducing Al$^{3+}$ atoms ($x$) randomly at the Ni-sites, the average oxidation state for the two non-equivalent Ni-cations is tuned and adopt values below the average of +2.67 in La$_4$Ni$_3$O$_{10}$. La$_4$Ni$_{3-x}$Al$_x$O$_{10}$ is a solid solution for $x=0.00$ to 1.00, and are prepared by the citric acid method. The samples adopt a slightly distorted monoclinic structure (P21/a), evidenced by peak broadening of the (117) reflection. We report on a remarkable effect on the electronic properties induced by tiny amounts of homogeneously distributed Al-cations, with clear correspondence between resistivity, magnetization, diffraction, and DFT data. DFT shows that electronically there is no significant difference between the non-equivalent Ni atoms and no tendency towards any Ni$^{3+}$/Ni$^{2+}$ charge ordering. The electron doping via Al-substitution has a profound effect on electric and magnetic properties. The resistivity changes from metallic to semiconducting with increasing band-gap at higher Al-levels, consistent with results from DFT. The metal-to-metal transition reported for La$_4$Ni$_3$O$_{10}$, which is often interpreted as a charge density wave, is maintained until $x = 0.15$ Al-level. However, the temperature characteristics of the resistivity change already at very low Al-levels (below 0.03). A coupling of the metal-to-metal transition to the lattice is evidenced by an anomaly in the unit cell dimensions. No long-range magnetic order is detected by powder neutron diffraction. The introduction of the non-magnetic Al$^{3+}$ changes the Ni$^{3+}$/Ni$^{2+}$ ratio and is likely to block double-exchange pathways by means of -Ni-O-Al-O-Ni- fragments into the network of corner shared octahedra with the emergence of possible short-range order in ferromagnetic like islands.

preprint2020arXiv

Pseudo-ternary LiBH4-LiCl-P2S5 system as structurally disordered bulk electrolyte for all-solid-state lithium batteries

The properties of the mixed system LiBH4 LiCl P2S5 are studied with respect to all-solid-state batteries. The studied material undergoes an amorphization upon heating above 601C, accompanied with increased Li+ conductivity beneficial for battery electrolyte applications. The measured ionic conductivity is 10-3 Scm-1 at room temperature with an activation energy of 0.40(2) eV after amorphization. Structural analysis and characterization of the material suggest that BH4 groups and PS4 may belong to the same molecular structure, where Cl ions interplay to accommodate the structural unit. Thanks to its conductivity, ductility and electrochemical stability (up to 5 V, Au vs. Li+/Li), this new electrolyte is successfully tested in battery cells operated with a cathode material (layered TiS2, theo. capacity 239 mAh g-1) and Li anode resulting in 93% capacity retention (10 cycles) and notable cycling stability under the current density 12 mA g-1 (0.05C-rate) at 501C. Further advanced characterisation by means of operando synchrotron X-ray diffraction in transmission mode contributes explicitly to a better understanding of the (de)lithiation processes of solid-state battery electrodes operated at moderate temperatures.