Source author record

M. P. Silveri

M. P. Silveri appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

quant-ph cond-mat.mes-hall

Catalog footprint

What is connected

4works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Implementing and characterizing precise multi-qubit measurements

There are two general requirements to harness the computational power of quantum mechanics: the ability to manipulate the evolution of an isolated system and the ability to faithfully extract information from it. Quantum error correction and simulation often make a more exacting demand: the ability to perform non-destructive measurements of specific correlations within that system. We realize such measurements by employing a protocol adapted from [S. Nigg and S. M. Girvin, Phys. Rev. Lett. 110, 243604 (2013)], enabling real-time selection of arbitrary register-wide Pauli operators. Our implementation consists of a simple circuit quantum electrodynamics (cQED) module of four highly-coherent 3D transmon qubits, collectively coupled to a high-Q superconducting microwave cavity. As a demonstration, we enact all seven nontrivial subset-parity measurements on our three-qubit register. For each we fully characterize the realized measurement by analyzing the detector (observable operators) via quantum detector tomography and by analyzing the quantum back-action via conditioned process tomography. No single quantity completely encapsulates the performance of a measurement, and standard figures of merit have not yet emerged. Accordingly, we consider several new fidelity measures for both the detector and the complete measurement process. We measure all of these quantities and report high fidelities, indicating that we are measuring the desired quantities precisely and that the measurements are highly non-demolition. We further show that both results are improved significantly by an additional error-heralding measurement. The analyses presented here form a useful basis for the future characterization and validation of quantum measurements, anticipating the demands of emerging quantum technologies.

preprint2015arXiv

Stückelberg interference in a superconducting qubit under periodic latching modulation

When the level separation of a qubit is modulated periodically across an avoided crossing, tunneling to the excited state - and consequently Landau-Zener-Stückelberg interference - can occur. The types of modulation studied so far correspond to a continuous change of the level separation. Here we study periodic latching modulation, in which the level separation is switched abruptly between two values and is kept constant otherwise. In this case, the conventional approach based on the asymptotic Landau-Zener (LZ) formula for transition probabilities is not applicable. We develop a novel adiabatic-impulse model for the evolution of the system and derive the resonance conditions. Additionally, we derive analytical results based on the rotating-wave approximation (RWA). The adiabatic-impulse model and the RWA results are compared with those of a full numerical simulation. These theoretical predictions are tested in an experimental setup consisting of a transmon whose flux bias is modulated with a square wave form. A rich spectrum is observed, with distinctive features correspoding to two regimes: slow-modulation and fast-modulation. These experimental results are shown to be in very good agreement with the theoretical models. Also, differences with respect to the well known case of sinusoidal modulation are discussed, both theoretically and experimentally.

preprint2014arXiv

Simulation of motional averaging using a superconducting circuit

The possibility of using a quantum system to simulate another one has been recognized for a long time as an important research direction in quantum information and quantum computing. In Ref. [J. Li et. al, Nat. Commun. 4, 1420 (2013)], a superconducting circuit (a transmon) was employed to simulate a NMR (nuclear magnetic resonance) effect known as motional averaging. In this paper we analyze the results of numerical integration of the time evolution of the density matrix of a qubit with random frequency fluctuations, and compare the results with those obtained by using the method of quantum trajectories. We show that both methods produce equivalent results, although some differences may appear in the range of intermediate modulation frequencies.

preprint2013arXiv

Motional Averaging in a Superconducting Qubit

Superconducting circuits with Josephson junctions are promising candidates for developing future quantum technologies. Of particular interest is to use these circuits to study effects that typically occur in complex condensed-matter systems. Here, we employ a superconducting quantum bit (qubit),a transmon, to carry out an analog simulation of motional averaging, a phenomenon initially observed in nuclear magnetic resonance (NMR) spectroscopy. To realize this effect, the flux bias of the transmon is modulated by a controllable pseudo-random telegraph noise, resulting in stochastic jumping of the energy separation between two discrete values. When the jumping is faster than a dynamical threshold set by the frequency displacement of the levels, the two separated spectral lines merge into a single narrow-width, motional-averaged line. With sinusoidal modulation a complex pattern of additional sidebands is observed. We demonstrate experimentally that the modulated system remains quantum coherent, with modified transition frequencies, Rabi couplings, and dephasing rates. These results represent the first steps towards more advanced quantum simulations using artificial atoms.