Source author record

M. J. A. Stoutimore

M. J. A. Stoutimore appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

4works
4topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2014arXiv

Landau-Zener population control and dipole measurement of a two level system bath

Tunneling two level systems (TLS), present in dielectrics at low temperatures, have been recently studied for fundamental understanding and superconducting device development. According to a recent theory by Burin \textit{et al.}, the TLS bath of any amorphous dielectric experiences a distribution of Landau-Zener transitions if exposed to simultaneous fields. In this experiment we measure amorphous insulating films at millikelvin temperatures with a microwave field and a swept electric field bias using a superconducting resonator. We find that the maximum dielectric loss per microwave photon with the simultaneous fields is approximately the same as that in the equilibrium state, in agreement with the generic material theory. In addition, we find that the loss depends on the fields in a way which allows for the separate extraction of the TLS bath dipole moment and density of states. This method allows for the study of the TLS dipole moment in a diverse set of disordered films, and provides a technique for continuously inverting their population.

preprint2013arXiv

Evidence for hydrogen two-level systems in atomic layer deposition oxides

Two-level system (TLS) defects in dielectrics are known to limit the performance of electronic devices. We study TLS using millikelvin microwave loss measurements of three atomic layer deposited (ALD) oxide films--crystalline BeO ($\rm{c-BeO}$), amorphous $\rm{Al_2O_3}$ ($\rm{a-Al_2O_3}$), and amorphous $\rm{LaAlO_3}$ ($\rm{a-LaAlO_3}$)--and interpret them with room temperature characterization measurements. We find that the bulk loss tangent in the crystalline film is 6 times higher than in the amorphous films. In addition, its power saturation agrees with an amorphous distribution of TLS. Through a comparison of loss tangent data to secondary ion mass spectrometry (SIMS) impurity analysis we find that the dominant loss in all film types is consistent with hydrogen-based TLS. In the amorphous films excess hydrogen is found at the ambient-exposed surface, and we extract the associated hydrogen-based surface loss tangent. Data from films with a factor of 40 difference in carbon impurities revealed that carbon is currently a negligible contributor to TLS loss.

preprint2012arXiv

A Josephson junction defect spectrometer for measuring two-level systems

We have fabricated and measured Josephson junction defect spectrometers (JJDSs), which are frequency-tunable, nearly-harmonic oscillators that probe strongly-coupled two-level systems (TLSs) in the barrier of a Josephson junction (JJ). The JJDSs accommodate a wide range of junction inductances, $L_{J}$, while maintaining a resonance frequency, $f_{0}$, in the range of 4-8 GHz. By applying a magnetic flux bias to tune $f_{0}$, we detect strongly-coupled TLSs in the junction barrier as splittings in the device spectrum. JJDSs fabricated with a via-style Al/thermal AlOx/Al junction and measured at 30 mK with single-photon excitation levels show a density of TLSs in the range $σ_{TLS}h = 0.4-0.5 /GHz μm^2$, and a junction loss tangent of $\tan δ_{J} = 2.9x10^{-3}$.

preprint2012arXiv

An analysis method for asymmetric resonator transmission applied to superconducting devices

We examine the transmission through nonideal microwave resonant circuits. The general analytical resonance line shape is derived for both inductive and capacitive coupling with mismatched input and output transmission impedances, and it is found that for certain non-ideal conditions the line shape is asymmetric. We describe an analysis method for extracting an accurate internal quality factor ($Q_i$), the Diameter Correction Method (DCM), and compare it to the conventional method used for millikelvin resonator measurements, the $ϕ$ Rotation Method ($ϕ$RM). We analytically find that the $ϕ$RM deterministically overestimates $Q_i$ when the asymmetry of the resonance line shape is high, and that this error is eliminated with the DCM. A consistent discrepancy between the two methods is observed when they are used to analyze both simulations from a numerical linear solver and data from asymmetric coplanar superconducting thin-film resonators.