Source author record

M. G. Borselli

M. G. Borselli appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall quant-ph

Catalog footprint

What is connected

3works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

Split-Gate Cavity Coupler for Silicon Circuit Quantum Electrodynamics

Coherent charge-photon and spin-photon coupling has recently been achieved in silicon double quantum dots (DQD). Here we demonstrate a versatile split-gate cavity-coupler that allows more than one DQD to be coupled to the same microwave cavity. Measurements of the cavity transmission as a function of level detuning yield a charge cavity coupling rate $g_c/2π$ = 58 MHz, charge decoherence rate $γ_c/2π$ = 36 MHz, and cavity decay rate $κ/2π$ = 1.2 MHz. The charge cavity coupling rate is in good agreement with device simulations. Our coupling technique can be extended to enable simultaneous coupling of multiple DQDs to the same cavity mode, opening the door to long-range coupling of semiconductor qubits using microwave frequency photons.

preprint2016arXiv

Reduced sensitivity to charge noise in semiconductor spin qubits via symmetric operation

We demonstrate improved operation of exchange-coupled semiconductor quantum dots by substantially reducing the sensitivity of exchange operations to charge noise. The method involves biasing a double-dot symmetrically between the charge-state anti-crossings, where the derivative of the exchange energy with respect to gate voltages is minimized. Exchange remains highly tunable by adjusting the tunnel coupling. We find that this method reduces the dephasing effect of charge noise by more than a factor of five in comparison to operation near a charge-state anti-crossing, increasing the number of observable exchange oscillations in our qubit by a similar factor. Performance also improves with exchange rate, favoring fast quantum operations.

preprint2009arXiv

Single-Gate Accumulation-Mode InGaAs Quantum Dot with a Vertically Integrated Charge Sensor

We report on the fabrication and characterization of a few-electron quantum dot controlled by a single gate electrode. Our device has a double-quantum-well design, in which the doping controls the occupancy of the lower well while the upper well remains empty under the free surface. A small air-bridged gate contacts the surface, and is positively biased to draw laterally confined electrons into the upper well. Electrons tunneling between this accumulation-mode dot and the lower well are detected using a quantum point contact (QPC), located slightly offset from the dot gate. The charge state of the dot is measured by monitoring the differential transconductance of the QPC near pinch-off. Addition spectra starting with N=0 were observed as a function of gate voltage. DC sensitivity to single electrons was determined to be as high as 8.6%, resulting in a signal-to-noise ratio of ~9:1 with an equivalent noise bandwidth of 12.1 kHz. Analysis of random telegraph signals associated with the zero to one electron transition allowed a measurement of the lifetimes for the filled and empty states of the one-electron dot: 0.38 ms and 0.22 ms, respectively, for a device with a 10 nm AlInAs tunnel barrier between the two wells.