Source author record

M. D. Di Benedetto

M. D. Di Benedetto appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

math.OC Systems and Control

Catalog footprint

What is connected

5works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2015arXiv

Co-design of controller and routing redundancy over a wireless network

In this paper we investigate the exploitation of redundancy when routing actuation data to a discrete-time LTI system connected to the controller via a wireless network affected by packet drops. We assume that actuation packets can be delivered from the controller to the actuator via multiple paths, each associated with a delay and a packet loss probability. We show that the joint design of controller gain and routing redundancy exploitation can tremendously improve the control performance. To achieve this goal we set up and solve a LQR problem for a class of systems that extends discrete-time Markov Jump Linear Systems, in that both continuous and discrete control signals can be actuated.

preprint2014arXiv

Modeling, analysis and design of linear systems with switching delays

We consider the modeling, stability analysis and controller design problems for discrete-time LTI systems with state feedback, when the actuation signal is subject to switching propagation delays, due to e.g. the routing in a multi-hop communication network. We show how to model these systems as regular switching linear systems and, as a corollary, we provide an (exponential-time) algorithm for robust stability analysis. We also show that the general stability analysis problem is NP-hard in general. Even though the systems studied here are inherently switching systems, we show that their particular structure allows for analytical understanding of the dynamics, and even efficient algorithms for some problems: for instance, we give an algorithm that computes in a finite number of steps the minimal look-ahead knowledge of the delays necessary to achieve controllability. We finally show that when the switching signal cannot be measured it can be necessary to use nonlinear controllers for stabilizing a linear plant.

preprint2013arXiv

Fault detection and isolation of malicious nodes in MIMO Multi-hop Control Networks

A MIMO Multi-hop Control Network (MCN) consists of a MIMO LTI system where the communication between sensors, actuators and computational units is supported by a (wireless) multi-hop communication network, and data flow is performed using scheduling and routing of sensing and actuation data. We provide necessary and sufficient conditions on the plant dynamics and on the communication protocol configuration such that the Fault Detection and Isolation (FDI) problem of failures and malicious attacks to communication nodes can be solved.

preprint2012arXiv

Optimal co-design of control, scheduling and routing in multi-hop control networks

A Multi-hop Control Network consists of a plant where the communication between sensors, actuators and computational units is supported by a (wireless) multi-hop communication network, and data flow is performed using scheduling and routing of sensing and actuation data. Given a SISO LTI plant, we will address the problem of co-designing a digital controller and the network parameters (scheduling and routing) in order to guarantee stability and maximize a performance metric on the transient response to a step input, with constraints on the control effort, on the output overshoot and on the bandwidth of the communication channel. We show that the above optimization problem is a polynomial optimization problem, which is generally NP-hard. We provide sufficient conditions on the network topology, scheduling and routing such that it is computationally feasible, namely such that it reduces to a convex optimization problem.

preprint2011arXiv

Digital Self Triggered Robust Control of Nonlinear Systems

In this paper we develop novel results on self triggering control of nonlinear systems, subject to perturbations and actuation delays. First, considering an unperturbed nonlinear system with bounded actuation delays, we provide conditions that guarantee the existence of a self triggering control strategy stabilizing the closed--loop system. Then, considering parameter uncertainties, disturbances, and bounded actuation delays, we provide conditions guaranteeing the existence of a self triggering strategy, that keeps the state arbitrarily close to the equilibrium point. In both cases, we provide a methodology for the computation of the next execution time. We show on an example the relevant benefits obtained with this approach, in terms of energy consumption, with respect to control algorithms based on a constant sampling, with a sensible reduction of the average sampling time.