Researcher profile

Karl Smolenski

Karl Smolenski contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

physics.acc-ph

Trust snapshot

Quick read

Trust 13 - Baseline

2works

0followers

1topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2013arXiv

Demonstration of Low Emittance in the Cornell Energy Recovery Linac Injector Prototype

We present a detailed study of the six-dimensional phase space of the electron beam produced by the Cornell Energy Recovery Linac Photoinjector, a high-brightness, high repetition rate (1.3 GHz) DC photoemission source designed to drive a hard x-ray energy recovery linac (ERL). A complete simulation model of the injector has been constructed, verified by measurement, and optimized. Both the horizontal and vertical 2D transverse phase spaces, as well as the time-resolved (sliced) horizontal phase space, were simulated and directly measured at the end of the injector for 19 pC and 77 pC bunches at roughly 8 MeV. These bunch charges were chosen because they correspond to 25 mA and 100 mA average current if operating at the full 1.3 GHz repetition rate. The resulting 90% normalized transverse emittances for 19 (77) pC/bunch were 0.23 +/- 0.02 (0.51 +/- 0.04) microns in the horizontal plane, and 0.14 +/- 0.01 (0.29 +/- 0.02) microns in the vertical plane, respectively. These emittances were measured with a corresponding bunch length of 2.1 +/- 0.1 (3.0 +/- 0.2) ps, respectively. In each case the rms momentum spread was determined to be on the order of 1e-3. Excellent overall agreement between measurement and simulation has been demonstrated. Using the emittances and bunch length measured at 19 pC/bunch, we estimate the electron beam quality in a 1.3 GHz, 5 GeV hard x-ray ERL to be at least a factor of 20 times better than that of existing storage rings when the rms energy spread of each device is considered. These results represent a milestone for the field of high-brightness, high-current photoinjectors.

preprint2011arXiv

Photocathode Behavior During High Current Running in the Cornell ERL Photoinjector

The Cornell University Energy Recovery Linac (ERL) photoinjector has recently demonstrated operation at 20 mA for approximately 8 hours, utilizing a multialkali photocathode deposited on a Si substrate. We describe the recipe for photocathode deposition, and will detail the parameters of the run. Post-run analysis of the photocathode indicates the presence of significant damage to the substrate, perhaps due to ion back-bombardment from the residual beamline gas. While the exact cause of the substrate damage remains unknown, we describe multiple surface characterization techniques (X-ray fluorescence spectroscopy, X-ray diffraction, atomic force and scanning electron microscopy) used to study the interesting morphological and crystallographic features of the photocathode surface after its use for high current beam production. Finally, we present a simple model of crystal damage due to ion back-bombardment, which agrees qualitatively with the distribution of damage on the substrate surface.