Source author record

Josef Redinger

Josef Redinger appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci cond-mat.mes-hall cond-mat.other physics.comp-ph quant-ph

Catalog footprint

What is connected

7works

5topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Impact of lattice dynamics on the phase stability of metamagnetic FeRh: Bulk and thin films

We present phonon dispersions, element-resolved vibrational density of states (VDOS) and corresponding thermodynamic properties obtained by a combination of density functional theory (DFT) and nuclear resonant inelastic X-ray scattering (NRIXS) across the metamagnetic transition of B2 FeRh in the bulk material and thin epitaxial films. We see distinct differences in the VDOS of the antiferromagnetic (AF) and ferromagnetic (FM) phase which provide a microscopic proof of strong spin-phonon coupling in FeRh. The FM VDOS exhibits a particular sensitivity to the slight tetragonal distortions present in epitaxial films, which is not encountered in the AF phase. This results in a notable change in lattice entropy, which is important for the comparison between thin film and bulk results. Our calculations confirm the recently reported lattice instability in the AF phase. The imaginary frequencies at the $X$-point depend critically on the Fe magnetic moment and atomic volume. Analyzing these non vibrational modes leads to the discovery of a stable monoclinic ground state structure which is robustly predicted from DFT but not verified in our thin film experiments. Specific heat, entropy and free energy calculated within the quasiharmonic approximation suggest that the new phase is possibly suppressed because of its relatively smaller lattice entropy. In the bulk phase, lattice degrees of freedom contribute with the same sign and in similar magnitude to the isostructural AF-FM phase transition as the electronic and magnetic subsystems and therefore needs to be included in thermodynamic modeling.

preprint2015arXiv

Ab-initio calculation of the real contact area on the atomic scale

We present a novel approach to determine the onset of contact between a tip and a surface. The real contact area depending on the distance is calculated using Bader's quantum theory of atoms in molecules. The jump to contact, which is often observed in atomic force microscopy experiments, is used as an indicator for the initial point of contact, which in turn is defined by atomic relaxations and thus without the need of external parameters. Within our approach the contact area is estimated by evaluating the zero flux surfaces between the touching Bader-atoms, where the necessary electronic density cutoff for the Bader-partitioning is calculated to depend on the initial point of contact. Our proposed approach is therefore completely ab-initio and we are able to define and calculate the real area of contact without imposing restrictions or free parameters. As a prototype system we choose a tip made of a ten atom tungsten pyramid above a moiré layer of graphene on an fcc iridium (111) substrate. We find that the contact area depends exponentially on the effective distance between the tip apex and the surface atom directly below within the atomically relaxed nanosystem.

preprint2015arXiv

Adhesion and material transfer between contacting Al and TiN surfaces from first principles

A series of density functional theory (DFT) simulations was performed to investigate the approach, contact, and subsequent separation of two atomically flat surfaces consisting of different materials. Aluminum (Al) and titanium nitride (TiN) slabs were chosen as a model system representing a metal-ceramic interface and the interaction between soft and hard materials. The approach and separation were simulated by moving one slab in discrete steps normal to the surfaces allowing for electronic and atomic relaxations after each step. Various configurations were analyzed by considering (001), (011), and (111) surfaces as well as several lateral arrangements of these surfaces at the interface. Several tests were conducted on the computational setup, for example, by changing the system size or using different approximations for the exchange correlation functional. The performed simulations revealed the influences of these aspects on adhesion, equilibrium distance, and material transfer. These interfacial properties depend sensitively on the chosen configuration due to distinct bond situations. Material transfer, in particular, was observed if the absolute value of the adhesion energy for a given configuration is larger than the energy cost to remove surface layers. This result was found to be independent of the employed exchange correlation functional. Furthermore, it was shown that a simple comparison of the surface energies of the slabs is not sufficient to predict the occurrence of material transfer.

preprint2014arXiv

Ab-initio friction forces on the nanoscale: A DFT study of fcc Cu(111)

While there are a number of models that tackle the problem of calculating friction forces on the atomic level, providing a completely parameter-free approach remains a challenge. Here we present a quasi-static model to obtain an approximation to the nanofrictional response of dry, wearless systems based on quantum mechanical all-electron calculations. We propose a mechanism to allow dissipative sliding, which relies on atomic relaxations. We define two different ways of calculating the mean nanofriction force, both leading to an exponential friction-versus-load behavior for all sliding directions. Since our approach does not impose any limits on lengths and directions of the sliding paths, we investigate arbitrary sliding directions for an fcc Cu(111) interface and detect two periodic paths which form the upper and lower bound of nanofriction. For long aperiodic paths the friction force convergences to a value in between these limits. For low loads we retrieve the Derjaguin generalization of Amontons-Coulomb kinetic friction law which appears to be valid all the way down to the nanoscale. We observe a non-vanishing Derjaguin-offset even for atomically flat surfaces in dry contact.

preprint2014arXiv

Effects of van der Waals Interactions in the Adsorption of Isooctane and Ethanol on Fe(100) Surfaces

Van der Waals (vdW) forces play a fundamental role in the structure and behavior of diverse systems. Thanks to development of functionals that include non-local correlation, it is possible to study the effects of vdW interactions in systems of industrial and tribological interest. Here we simulated within the framework of density functional theory (DFT) the adsorption of isooctane (2,2,4-trimethylpentane) and ethanol on a Fe(100) surface, employing various exchange-correlation functionals to take vdW forces into account. In particular, this paper discusses the effect of vdW forces on the magnitude of adsorption energies, equilibrium geometries and their role in the binding mechanism. According to our calculations, vdW interactions increase the adsorption energies and reduce the equilibrium distances. Nevertheless, they do not influence the spatial configuration of the adsorbed molecules. Their effect on the electronic density is a non-isotropic, delocalized accumulation of charge between the molecule and the slab. In conclusion, vdW forces are essential for the adsorption of isooctane and ethanol on a bcc Fe(100) surface.

preprint2013arXiv

The influence of oxygen and hydrogen adsorption on the magnetic structure of the ultrathin iron film on the Ir(001) surface

We present a detailed ab initio study of the electronic structure and magnetic order of an Fe monolayer on the Ir(001) surface covered by adsorbed oxygen and hydrogen. The results are compared to the clean Fe/Ir(001) system, where recent intensive studies indicated a strong tendency towards an antiferromagnetic order and complex magnetic structures. The adsorption of an oxygen overlayer significantly increases interlayer distance between the Fe layer and the Ir substrate, while the effect of hydrogen is much weaker. We show that the adsorption of oxygen (and also of hydrogen) leads to a p(2$\times $1) antiferromagnetic order of the Fe moments, which is also supported by an investigation based on a disordered local moment state. Simulated scanning tunneling images using the simple Tersoff-Hamann model hint that the proposed p(2$\times $1) antiferromagnetic order could be detected even by non-magnetic tips.

preprint2009arXiv

Substrate-induced antiferromagnetism of an Fe monolayer on the Ir(001) surface

We present detailed ab initio study of structural and magnetic stability of a Fe-monolayer on the fcc(001) surface of iridium. The Fe-monolayer has a strong tendency to order antiferromagnetically for the true relaxed geometry. On the contrary an unrelaxed Fe/Ir(001) sample has a ferromagnetic ground state. The antiferromagnetism is thus stabilized by the decreased Fe-Ir layer spacing in striking contrast to the recently experimentally observed antiferromagnetism of the Fe/W(001) system which exists also for an ideal bulk-truncated, unrelaxed geometry. The calculated layer relaxations for Fe/Ir(001) agree reasonably well with recent experimental LEED data. The present study centers around the evaluation of pair exchange interactions between Fe-atoms in the Fe-overlayer as a function of the Fe/Ir interlayer distance which allows for a detailed understanding of the antiferromagnetism of a Fe/Ir(001) overlayer. Furthermore, our calculations indicate that the nature of the true ground state could be more complex and display a spin spiral-like rather than a c(2x2)-antiferromagnetic order. Finally, the magnetic stability of the Fe monolayer on the Ir(001) surface is compared to the closely related Fe/Rh(001) system.