Researcher profile

Jon Richards

Jon Richards contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
2topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2019arXiv

Radio SETI Observations of the Interstellar Object 'Oumuamua

Note: This is a revised version of the paper that _corrects_a_calculation_error in translating observed Jansky units to EIRP in Watts. Mistakes are labeled below. Motivated by the hypothesis that Oumuamua could conceivably be an interstellar probe, we used the Allen Telescope Array to search for radio transmissions that would indicate a non-natural origin for this object. Observations were made at radio frequencies between 1 and 10 GHz using the Array's correlator receiver with a channel bandwidth of 100 kHz. In frequency regions not corrupted by man-made interference, we find no signal flux with frequency-dependent lower limits of 0.01 Jy at 1 GHz and 0.1 Jy at 7 GHz. For a putative isotropic object, these limits correspond to transmitter powers of (was mistakenly 30 mW) 10 W and (was mistakenly 300 mW) 100 W, respectively. In frequency ranges that are heavily utilized for satellite communications, our sensitivity to weak signals is badly impinged, but we can still place an upper limit of (was mistakenly 10 W) 3 kW for a transmitter on the asteroid. For comparison and validation should a transmitter be discovered, contemporaneous measurements were made on the solar system asteroids 2017 UZ and 2017 WC with comparable sensitivities. Because they are closer to Earth, we place upper limits on transmitter power to be 0.1 and 0.001 times the limits for Oumuamua, respectively.

preprint2015arXiv

Optical SETI Observations of the Anomalous Star KIC 8462852

To explore the hypothesis that KIC 8462852's aperiodic dimming is caused by artificial megastructures in orbit (Wright et al. 2015), rather than a natural cause such as cometary fragments in a highly elliptical orbit (Marengo et al. 2015), we searched for electromagnetic signals from KIC 8462852 indicative of extraterrestrial intelligence. The primary observations were in the visible optical regime using the Boquete Optical SETI Observatory in Panama. In addition, as a preparatory exercise for the possible future detection of a candidate signal (Heidmann 1991), three of six observing runs simultaneously searched radio frequencies at the Allen Telescope Array in California. No periodic optical signals greater than 67 photons/m2 within a time frame of 25 ns were seen. This limit corresponds to isotropic optical pulses of 8E22 joules. If, however, any inhabitants of KIC 8462852 were targeting our solar system (Shostak & Villard 2004), the required energy would be reduced greatly. The limits on narrowband radio signals were 180 - 300 Jy Hz at 1 and 8 GHz, respectively, corresponding to a transmitter with an effective isotropic radiated power of 4E15 W (and 7E15 W) at the distance of KIC 8462852. While these powers requirements are high, even modest targeting could - just as for optical signals - lower these numbers substantially.

preprint2010arXiv

Commensal observing with the Allen Telescope array: software command and control

The Allen Telescope Array (ATA) is a Large-Number-Small-Diameter radio telescope array currently with 42 individual antennas and 5 independent back-end science systems (2 imaging FX correlators and 3 time domain beam formers) located at the Hat Creek Radio Observatory (HCRO). The goal of the ATA is to run multiple back-ends simultaneously, supporting multiple science projects commensally. The primary software control systems are based on a combination of Java, JRuby and Ruby on Rails. The primary control API is simplified to provide easy integration with new back-end systems while the lower layers of the software stack are handled by a master observing system. Scheduling observations for the ATA is based on finding a union between the science needs of multiple projects and automatically determining an efficient path to operating the various sub-components to meet those needs. When completed, the ATA is expected to be a world-class radio telescope, combining dedicated SETI projects with numerous radio astronomy science projects.