Source author record

John F. Rudge

John F. Rudge appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.geo-ph physics.flu-dyn

Catalog footprint

What is connected

4works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

A Re-examination of Ellipticity Corrections for Seismic Phases

The Earth's ellipticity of figure has an effect on the travel times of seismic waves over teleseismic distances. Tables of ellipticity corrections and coefficients have been used by seismologists for several decades, however due to the increasing variety and complexity of seismic phases in use, current tables of ellipticity coefficients are now outmoded and incomplete. We present a Python package, EllipticiPy, for the calculation of ellipticity corrections that removes the dependence on pre-calculated coefficients at discrete source depths and epicentral distances. EllipticiPy also facilitates the calculation of ellipticity corrections on other planetary bodies. When applied to both Earth and Mars, the magnitudes of ellipticity corrections are on the order of single seconds and are significant for some seismic studies on Earth but remain negligible on Mars due to other greater sources of uncertainty.

preprint2020arXiv

Fast magma ascent, revised estimates from the deglaciation of Iceland

Partial melting of asthenospheric mantle generates magma that supplies volcanic systems. The timescale of melt extraction from the mantle has been hotly debated. Microstructural measurements of permeability typically suggest relatively slow melt extraction (1 m/yr) whereas geochemical (Uranium-decay series) and geophysical observations suggest much faster melt extraction (100 m/yr). The deglaciation of Iceland triggered additional mantle melting and magma flux at the surface. The rapid response has been used to argue for relatively rapid melt extraction. However, this episode must, at least to some extent, be unrepresentative, because the rates of magma eruption at the surface increased about thirty-fold relative to the steady state. Our goal is to quantify this unrepresentativeness. We develop a one-dimensional, time-dependent and nonlinear (far from steady-state), model forced by the most recent, and best mapped, Icelandic deglaciation. We find that 30 m/yr is the best estimate of the steady-state maximum melt velocity. This is a factor of about 3 smaller than previously claimed, but still relatively fast. We translate these estimates to other mid-ocean ridges accounting for differences in passive and active upwelling and degree of melting. We find that fast melt extraction greater than about 10 m/yr prevails globally.

preprint2020arXiv

Gravity, topography, and melt generation rates from simple 3D models of mantle convection

Convection in fluid layers at high Rayleigh number (Ra $\sim 10^6$) have a spoke pattern planform. Instabilities in the bottom thermal boundary layer develop into hot rising sheets of fluid, with a component of radial flow towards a central upwelling plume. The sheets form the "spokes" of the pattern, and the plumes the "hubs". Such a pattern of flow is expected to occur beneath plate interiors on Earth, but it remains a challenge to use observations to place constraints on the convective planform of the mantle. Here we present predictions of key surface observables (gravity, topography, and rates of melt generation) from simple 3D numerical models of convection in a fluid layer. These models demonstrate that gravity and topography have only limited sensitivity to the spokes, and mostly reflect the hubs (the rising and sinking plumes). By contrast, patterns of melt generation are more sensitive to short wavelength features in the flow. There is the potential to have melt generation along the spokes, but at a rate which is relatively small compared with that at the hubs. Such melting of spokes can only occur when the lithosphere is sufficiently thin ($\lesssim 80$ km) and mantle water contents are sufficiently high ($\gtrsim 100$ ppm). The distribution of volcanism across the Middle East, Arabia and Africa north of equator suggests that it results from such spoke pattern convection.

preprint2015arXiv

Torsion of a cylinder of partially molten rock with a spherical inclusion: theory and simulation

The processes that are involved in migration and extraction of melt from the mantle are not yet fully understood. Gaining a better understanding of material properties of partially molten rock could help shed light on the behavior of melt on larger scales in the mantle. In this study, we simulate three-dimensional torsional deformation of a partially molten rock that contains a rigid, spherical inclusion. We compare the computed porosity patterns to those found in recent laboratory experiments. The laboratory experiments show emergence of melt-rich bands throughout the rock sample, and pressure shadows around the inclusion. The numerical model displays similar melt-rich bands only for a small bulk-to-shear-viscosity ratio (five or less). The results are consistent with earlier two-dimensional numerical simulations; however, we show that it is easier to form melt-rich bands in three dimensions compared to two. The addition of strain-rate dependence of the viscosity causes a distinct change in the shape of pressure shadows around the inclusion. This change in shape presents an opportunity for experimentalists to identify the strain-rate dependence and therefore the dominant deformation mechanism in torsion experiments with inclusions.