Source author record

Jim N. McElwaine

Jim N. McElwaine appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

3works
2topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2021arXiv

Entrainment into particle-laden turbulent plumes

We use laboratory experiments to investigate the entrainment of ambient fluid into an axisymmetric turbulent plume that contains dense particles with a settling velocity that is considerably smaller than the plume velocity. We consider the effect of particle size, particle concentration, and the orientation of the plume buoyancy flux - either in the same or opposite direction to the particle buoyancy flux. When the plume buoyancy flux is in the opposite direction to the particle buoyancy flux, entrainment into the plume increases by up to 40%. The rate of entrainment increases linearly with the ratio of particle buoyancy flux to fluid buoyancy flux but does not depend on the particle size. In contrast, when the plume buoyancy flux is in the same direction as the particle buoyancy flux, entrainment into the plume is unaffected by the addition of particles. The observed increase in entrainment, when the plume and particle buoyancy fluxes are in opposite directions, is consistent with inertial clustering whereby particles are ejected from regions of relatively high vorticity and accumulate in regions of relatively high strain rate within the turbulent flow field. Regions with high particle concentration can then experience convective instabilities that affect the entrainment of ambient fluid into the plume. The differing behaviour observed based on the plume buoyancy flux orientation is also consistent with the above mechanism. Finally, based on the laboratory findings, we propose a new expression for the entrainment coefficient to take into account the effect of suspended particles of opposing buoyancy flux to the plume buoyancy flux.

preprint2020arXiv

Surface expression of a wall fountain: application to subglacial discharge plumes

We use laboratory experiments and theoretical modeling to investigate the surface expression of a subglacial discharge plume, as occurs at many fjords around Greenland. The experiments consider a fountain that is released vertically into a homogeneous fluid, adjacent either to a vertical or a sloping wall, that then spreads horizontally at the free surface before sinking back to the bottom. We present a model that separates the fountain into two separate regions: a vertical fountain and a horizontal, negatively buoyant jet. The model is compared to laboratory experiments that are conducted over a range of volume fluxes, density differences, and ambient fluid depths. It is shown that the non-dimensionalised length, width, and aspect ratio of the surface expression are dependent on the Froude number, calculated at the start of the negatively buoyant jet. The model is applied to observations of the surface expression from a Greenland subglacial discharge plume. In the case where the discharge plume reaches the surface with negative buoyancy the model can be used to estimate the discharge properties at the base of the glacier.

preprint2011arXiv

Lift and drag forces on an inclined plow moving over a granular surface

We studied the drag and lift forces acting on an inclined plate while it is dragged on the surface of a granular media, both in experiment and numerical simulation. In particular, we investigated the influence of the horizontal velocity of the plate and its angle of attack. We show that a steady wedge of grains is moved in front of the plow and that the lift and drag forces are proportional to the weight of this wedge. These constants of proportionality vary with the angle of attack but not (or only weakly) on the velocity. We found a universal effective friction law which accounts for the dependence on all the above-mentioned parameters. The stress and velocity fields are calculated from the numerical simulations and show the existence of a shear band under the wedge and that the pressure is non-hydrostatic. The strongest gradients in stress and shear occur at the base of the plow where the dissipation rate is therefore highest.