Source author record

J. T. Robinson

J. T. Robinson appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.mtrl-sci

Catalog footprint

What is connected

6works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2014arXiv

Carrier Heating and Negative Photoconductivity in Graphene

We investigated negative photoconductivity in graphene using ultrafast terahertz techniques. Infrared transmission was used to determine the Fermi energy, carrier density and mobility of p-type CVD graphene samples. Time-resolved terahertz photoconductivity measurements using a tunable mid-infrared pump probed these samples at photon energies between 0.35eV to 1.55eV, approximately one half to three times the Fermi energy of the samples. Although interband optical transitions in graphene are blocked for pump photon energies less than twice the Fermi energy, we observe negative photoconductivity at all pump photon energies investigated, indicating that interband excitation is not required to observe this effect. Our results are consistent with a thermalized free carrier population that cools by electron-phonon scattering, but inconsistent with models of negative photoconductivity based on population inversion.

preprint2014arXiv

Ultrafast THz Faraday Rotation in Graphene

Terahertz (THz) Faraday rotation measurements were performed to investigate carrier dynamics in p-type CVD graphene. We used static and time-resolved polarization-sensitive THz transmission measurements in a magnetic field to probe free carriers in GaAs, InP and Graphene. Static measurements probe the equilibrium carrier density and momentum scattering rate. Time-resolved (optical pump/THz probe) measurements probe the change in these quantities following photoexcitation. In a typical CVD graphene sample we found that 0.5ps following photoexcitation with 1*10^13 photons/cm2 pulses at 800nm the effective hole scattering time decreased from 37fs to 34.5fs, while the carrier concentration increased from 2.0*10^12/cm2 to 2.04*10^12/cm2, leading to a transient decrease in the conductivity of the film.

preprint2013arXiv

Low-energy Electron Reflectivity from Graphene

Low-energy reflectivity of electrons from single- and multi-layer graphene is examined both theoretically and experimentally. A series of minima in the reflectivity over the energy range of 0 - 8 eV are found, with the number of minima depending on the number of graphene layers. Using first-principles computations, it is demonstrated that a free standing n-layer graphene slab produces n-1 reflectivity minima. This same result is also found experimentally for graphene supported on SiO2. For graphene bonded onto other substrates it is argued that a similar series of reflectivity minima is expected, although in certain cases an additional minimum occurs, at an energy that depends on the graphene-substrate separation and the effective potential in that space.

preprint2011arXiv

Low Energy Electron Point Projection Microscopy of Suspended Graphene, the Ultimate "Microscope Slide"

Point Projection Microscopy (PPM) is used to image suspended graphene using low-energy electrons (100-200eV). Because of the low energies used, the graphene is neither damaged or contaminated by the electron beam. The transparency of graphene is measured to be 74%, equivalent to electron transmission through a sheet as thick as twice the covalent radius of sp^2-bonded carbon. Also observed is rippling in the structure of the suspended graphene, with a wavelength of approximately 26 nm. The interference of the electron beam due to the diffraction off the edge of a graphene knife edge is observed and used to calculate a virtual source size of 4.7 +/- 0.6 Angstroms for the electron emitter. It is demonstrated that graphene can be used as both anode and substrate in PPM in order to avoid distortions due to strong field gradients around nano-scale objects. Graphene can be used to image objects suspended on the sheet using PPM, and in the future, electron holography.

preprint2009arXiv

Instability of two dimensional graphene: Breaking sp2 bonds with soft X-rays

We study the stability of various kinds of graphene samples under soft X-ray irradiation. Our results show that in single layer exfoliated graphene (a closer analogue to two dimensional material), the in-plane carbon-carbon bonds are unstable under X-ray irradiation, resulting in nanocrystalline structures. As the interaction along the third dimension increases by increasing the number of graphene layers or through the interaction with the substrate (epitaxial graphene), the effect of X-ray irradiation decreases and eventually becomes negligible for graphite and epitaxial graphene. Our results demonstrate the importance of the interaction along the third dimension in stabilizing the long range in-plane carbon-carbon bonding, and suggest the possibility of using X-ray to pattern graphene nanostructures in exfoliated graphene.

preprint2007arXiv

Chemical nanomachining of silicon by gold-catalyzed oxidation

A chemical nanomachining process for the rapid, scalable production of nanostructure assemblies from silicon-on-insulator is demonstrated. The process is based on the spontaneous, local oxidation of Si induced by Au, which is selectively evaporated onto the Si surface. The Au-catalyzed oxide forms a pattern that serves as a robust mask for the underlying Si, enabling the use of simple wet chemistry to sculpt arrays of nanostructures of diverse shapes including rings, pillars, wires, and nanopores. The remarkable simplicity of this chemical nanomachining process makes it widely accessible as an enabling technique for applications from photonics to biotechnology.