Researcher profile

J. Nielsen

J. Nielsen contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - UnverifiedVerification L1Unclaimed author
6works
0followers
3topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Identity and collaboration

How to connect with this researcher

Claiming links this public author record to a researcher profile and unlocks direct collaboration workflows.

Log in to claim

Direct collaboration

Open a focused conversation when the fit is right

Claim this author entity first to unlock direct invitations.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

6 published item(s)

preprint2020arXiv

In-Orbit Aerodynamic Coefficient Measurements using SOAR (Satellite for Orbital Aerodynamics Research)

The Satellite for Orbital Aerodynamics Research (SOAR) is a CubeSat mission, due to be launched in 2021, to investigate the interaction between different materials and the atmospheric flow regime in very low Earth orbits (VLEO). Improving knowledge of the gas-surface interactions at these altitudes and identification of novel materials that can minimise drag or improve aerodynamic control are important for the design of future spacecraft that can operate in lower altitude orbits. Such satellites may be smaller and cheaper to develop or can provide improved Earth observation data or communications link-budgets and latency. Using precise orbit and attitude determination information and the measured atmospheric flow characteristics the forces and torques experienced by the satellite in orbit can be studied and estimates of the aerodynamic coefficients calculated. This paper presents the scientific concept and design of the SOAR mission. The methodology for recovery of the aerodynamic coefficients from the measured orbit, attitude, and in-situ atmospheric data using a least-squares orbit determination and free-parameter fitting process is described and the experimental uncertainty of the resolved aerodynamic coefficients is estimated. The presented results indicate that the combination of the satellite design and experimental methodology are capable of clearly illustrating the variation of drag and lift coefficient for differing surface incidence angle. The lowest uncertainties for the drag coefficient measurement are found at approximately 300 km, whilst the measurement of lift coefficient improves for reducing orbital altitude to 200 km.

preprint2020arXiv

RF Helicon-based Inductive Plasma Thruster (IPT) Design for an Atmosphere-Breathing Electric Propulsion system (ABEP)

Challenging space missions include those at very low altitudes, where the atmosphere is source of aerodynamic drag on the spacecraft. To extend such missions lifetime, an efficient propulsion system is required. One solution is Atmosphere-Breathing Electric Propulsion (ABEP). It collects atmospheric particles to be used as propellant for an electric thruster. The system would minimize the requirement of limited propellant availability and can also be applied to any planet with atmosphere, enabling new mission at low altitude ranges for longer times. Challenging is also the presence of reactive chemical species, such as atomic oxygen in Earth orbit. Such species cause erosion of (not only) propulsion system components, i.e. acceleration grids, electrodes, and discharge channels of conventional EP systems. IRS is developing within the DISCOVERER project, an intake and a thruster for an ABEP system. The paper describes the design and implementation of the RF helicon-based inductive plasma thruster (IPT). This paper deals in particular with the design and implementation of a novel antenna called the birdcage antenna, a device well known in magnetic resonance imaging (MRI), and also lately employed for helicon-wave based plasma sources in fusion research. The IPT is based on RF electrodeless operation aided by an externally applied static magnetic field. The IPT is composed by an antenna, a discharge channel, a movable injector, and a solenoid. By changing the operational parameters along with the novel antenna design, the aim is to minimize losses in the RF circuit, and accelerate a quasi-neutral plasma plume. This is also to be aided by the formation of helicon waves within the plasma that are to improve the overall efficiency and achieve higher exhaust velocities. Finally, the designed IPT with a particular focus on the birdcage antenna design procedure is presented

preprint2020arXiv

The Benefits of Very Low Earth Orbit for Earth Observation Missions

Very low Earth orbits (VLEO), typically classified as orbits below approximately 450 km in altitude, have the potential to provide significant benefits to spacecraft over those that operate in higher altitude orbits. This paper provides a comprehensive review and analysis of these benefits to spacecraft operations in VLEO, with parametric investigation of those which apply specifically to Earth observation missions. The most significant benefit for optical imaging systems is that a reduction in orbital altitude improves spatial resolution for a similar payload specification. Alternatively mass and volume savings can be made whilst maintaining a given performance. Similarly, for radar and lidar systems, the signal-to-noise ratio can be improved. Additional benefits include improved geospatial position accuracy, improvements in communications link-budgets, and greater launch vehicle insertion capability. The collision risk with orbital debris and radiation environment can be shown to be improved in lower altitude orbits, whilst compliance with IADC guidelines for spacecraft post-mission lifetime and deorbit is also assisted. Finally, VLEO offers opportunities to exploit novel atmosphere-breathing electric propulsion systems and aerodynamic attitude and orbit control methods. However, key challenges associated with our understanding of the lower thermosphere, aerodynamic drag, the requirement to provide a meaningful orbital lifetime whilst minimising spacecraft mass and complexity, and atomic oxygen erosion still require further research. Given the scope for significant commercial, societal, and environmental impact which can be realised with higher performing Earth observation platforms, renewed research efforts to address the challenges associated with VLEO operations are required.

preprint2012arXiv

Measurement of Bs0 --> Ds(*)+ Ds(*)- Branching Ratios

The decays Bs0 --> Ds(*)+ Ds(*)- are reconstructed in a data sample corresponding to an integrated luminosity of 6.8 fb-1 collected by the CDF II detector at the Tevatron p\bar{p} collider. All decay modes are observed with a significance of more than 10 sigma, and we measure the Bs0 production rate times Bs0 --> Ds(*)+ Ds(*)- branching ratios relative to the normalization mode B0 --> Ds+ D- to be $0.183 \pm 0.021 \pm 0.017$ for Bs0 --> Ds+ Ds-, $0.424 \pm 0.046 \pm 0.035$ for Bs0 --> Ds*+- Ds-+, $0.654 \pm 0.072 \pm 0.065$ for Bs0 --> Ds*+ Ds*-, and $1.261 \pm 0.095 \pm 0.112$ for the inclusive decay Bs0 --> Ds(*)+ Ds(*)-, where the uncertainties are statistical and systematic. These results are the most precise single measurements to date and provide important constraints for indirect searches for non-standard model physics in Bs0 mixing.

preprint2012arXiv

Search for the Higgs boson in the all-hadronic final state using the full CDF data set

This paper reports the result of a search for the standard model Higgs boson in events containing four reconstructed jets associated with quarks. For masses below 135GeV/c2, Higgs boson decays to bottom-antibottom quark pairs are dominant and result primarily in two hadronic jets. An additional two jets can be produced in the hadronic decay of a W or Z boson produced in association with the Higgs boson, or from the incoming quarks that produced the Higgs boson through the vector-boson fusion process. The search is performed using a sample of \sqrt{s} = 1.96 TeV proton-antiproton collisions corresponding to an integrated luminosity of 9.45 fb-1 recorded by the CDF II detector. The data are in agreement with the background model and 95% credibility level upper limits on Higgs boson production are set as a function of the Higgs boson mass. The median expected (observed) limit for a 125GeV/c2 Higgs boson is 11.0 (9.0) times the predicted standard model rate.

preprint2011arXiv

Search for new phenomena in events with two $Z$ bosons and missing transverse momentum in $p\bar{p}$ collisions at $\sqrt{s}=1.96$ TeV

We present a search for new phenomena in events with two reconstructed $Z$ bosons and large missing transverse momentum, sensitive to processes $p\bar{p}\rightarrow X_2X_2 \rightarrow Z Z X_1 X_1$, where $X_2$ is an unstable particle decaying as $X_2\rightarrow ZX_1$ and $X_1$ is undetected. The particles $X_1$ and $X_2$ may be, among other possibilities, fourth generation neutrinos or supersymmetric particles. We study the final state in which one $Z$ boson decays to two charged leptons and the second decays hadronically. In data corresponding to an integrated luminosity of 4.2 fb$^{-1}$ from proton-antiproton collisions recorded by the CDF II detector at the Tevatron, with center-of-mass energy of 1.96 TeV, we find agreement between data and standard-model backgrounds. We calculate 95% confidence level upper limits on the cross section of the process $p\bar{p}\rightarrow X_2X_2 \rightarrow Z Z X_1 X_1$ ranging from 50 fb to 1 pb, depending on the masses of $X_1$ and $X_2$.