Source author record

J. Dietrich

J. Dietrich appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

10works
6topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

10 published item(s)

preprint2022arXiv

Dark Energy Survey Year 3 results: imprints of cosmic voids and superclusters in the Planck CMB lensing map

The CMB lensing signal from cosmic voids and superclusters probes the growth of structure in the low-redshift cosmic web. In this analysis, we cross-correlated the Planck CMB lensing map with voids detected in the Dark Energy Survey Year 3 (Y3) data set ($\sim$5,000 deg$^{2}$), expanding on previous measurements that used Y1 catalogues ($\sim$1,300 deg$^{2}$). Given the increased statistical power compared to Y1 data, we report a $6.6σ$ detection of negative CMB convergence ($κ$) imprints using approximately 3,600 voids detected from a redMaGiC luminous red galaxy sample. However, the measured signal is lower than expected from the MICE N-body simulation that is based on the $Λ$CDM model (parameters $Ω_{\rm m} = 0.25$, $σ_8 = 0.8$), and the discrepancy is associated mostly with the void centre region. Considering the full void lensing profile, we fit an amplitude $A_κ=κ_{\rm DES}/κ_{\rm MICE}$ to a simulation-based template with fixed shape and found a moderate $2σ$ deviation in the signal with $A_κ\approx0.79\pm0.12$. We also examined the WebSky simulation that is based on a Planck 2018 $Λ$CDM cosmology, but the results were even less consistent given the slightly higher matter density fluctuations than in MICE. We then identified superclusters in the DES and the MICE catalogues, and detected their imprints at the $8.4σ$ level; again with a lower-than-expected $A_κ=0.84\pm0.10$ amplitude. The combination of voids and superclusters yields a $10.3σ$ detection with an $A_κ=0.82\pm0.08$ constraint on the CMB lensing amplitude, thus the overall signal is $2.3σ$ weaker than expected from MICE.

preprint2022arXiv

Dark Energy Survey Year 3 results: Marginalisation over redshift distribution uncertainties using ranking of discrete realisations

Cosmological information from weak lensing surveys is maximised by dividing source galaxies into tomographic sub-samples for which the redshift distributions are estimated. Uncertainties on these redshift distributions must be correctly propagated into the cosmological results. We present hyperrank, a new method for marginalising over redshift distribution uncertainties in cosmological analyses, using discrete samples from the space of all possible redshift distributions. This is demonstrated in contrast to previous highly simplified parametric models of the redshift distribution uncertainty. In hyperrank the set of proposed redshift distributions is ranked according to a small (in this work between one and four) number of summary values, which are then sampled along with other nuisance parameters and cosmological parameters in the Monte Carlo chain used for inference. This can be regarded as a general method for marginalising over discrete realisations of data vector variation with nuisance parameters, which can consequently be sampled separately to the main parameters of interest, allowing for increased computational efficiency. We focus on the case of weak lensing cosmic shear analyses and demonstrate our method using simulations made for the Dark Energy Survey (DES). We show the method can correctly and efficiently marginalise over a range of models for the redshift distribution uncertainty. Finally, we compare hyperrank to the common mean-shifting method of marginalising over redshift uncertainty, validating that this simpler model is sufficient for use in the DES Year 3 cosmology results presented in companion papers.

preprint2021arXiv

Dark Energy Survey Year 3 results: Cosmology with peaks using an emulator approach

We constrain the matter density $Ω_{\mathrm{m}}$ and the amplitude of density fluctuations $σ_8$ within the $Λ$CDM cosmological model with shear peak statistics and angular convergence power spectra using mass maps constructed from the first three years of data of the Dark Energy Survey (DES Y3). We use tomographic shear peak statistics, including cross-peaks: peak counts calculated on maps created by taking a harmonic space product of the convergence of two tomographic redshift bins. Our analysis follows a forward-modelling scheme to create a likelihood of these statistics using N-body simulations, using a Gaussian process emulator. We include the following lensing systematics: multiplicative shear bias, photometric redshift uncertainty, and galaxy intrinsic alignment. Stringent scale cuts are applied to avoid biases from unmodelled baryonic physics. We find that the additional non-Gaussian information leads to a tightening of the constraints on the structure growth parameter yielding $S_8~\equiv~σ_8\sqrt{Ω_{\mathrm{m}}/0.3}~=~0.797_{-0.013}^{+0.015}$ (68% confidence limits), with a precision of 1.8%, an improvement of ~38% compared to the angular power spectra only case. The results obtained with the angular power spectra and peak counts are found to be in agreement with each other and no significant difference in $S_8$ is recorded. We find a mild tension of $1.5 \thinspace σ$ between our study and the results from Planck 2018, with our analysis yielding a lower $S_8$. Furthermore, we observe that the combination of angular power spectra and tomographic peak counts breaks the degeneracy between galaxy intrinsic alignment $A_{\mathrm{IA}}$ and $S_8$, improving cosmological constraints. We run a suite of tests concluding that our results are robust and consistent with the results from other studies using DES Y3 data.

preprint2015arXiv

A facility to Search for Hidden Particles (SHiP) at the CERN SPS

A new general purpose fixed target facility is proposed at the CERN SPS accelerator which is aimed at exploring the domain of hidden particles and make measurements with tau neutrinos. Hidden particles are predicted by a large number of models beyond the Standard Model. The high intensity of the SPS 400~GeV beam allows probing a wide variety of models containing light long-lived exotic particles with masses below ${\cal O}$(10)~GeV/c$^2$, including very weakly interacting low-energy SUSY states. The experimental programme of the proposed facility is capable of being extended in the future, e.g. to include direct searches for Dark Matter and Lepton Flavour Violation.

preprint2014arXiv

Measuring the Polarization of a Rapidly Precessing Deuteron Beam

This paper describes a time-marking system that enables a measurement of the in-plane (horizontal) polarization of a 0.97-GeV/c deuteron beam circulating in the Cooler Synchrotron (COSY) at the Forschungszentrum Jülich. The clock time of each polarimeter event is used to unfold the 120-kHz spin precession and assign events to bins according to the direction of the horizontal polarization. After accumulation for one or more seconds, the down-up scattering asymmetry can be calculated for each direction and matched to a sinusoidal function whose magnitude is proportional to the horizontal polarization. This requires prior knowledge of the spin tune or polarization precession rate. An initial estimate is refined by re-sorting the events as the spin tune is adjusted across a narrow range and searching for the maximum polarization magnitude. The result is biased toward polarization values that are too large, in part because of statistical fluctuations but also because sinusoidal fits to even random data will produce sizeable magnitudes when the phase is left free to vary. An analysis procedure is described that matches the time dependence of the horizontal polarization to templates based on emittance-driven polarization loss while correcting for the positive bias. This information will be used to study ways to extend the horizontal polarization lifetime by correcting spin tune spread using ring sextupole fields and thereby to support the feasibility of searching for an intrinsic electric dipole moment using polarized beams in a storage ring. This paper is a combined effort of the Storage Ring EDM Collaboration and the JEDI Collaboration.

preprint2012arXiv

The pK0Σ+ final state in proton-proton collisions

This paper reports results from a study of the reaction pp->pK0Σ+ at beam momenta of p_{beam} = 2950, 3059, and 3200 MeV/c (excess energies of ε= 126, 161, and 206 MeV). Total cross sections were determined for all energies; a set of differential cross sections (Dalitz plots; invariant mass spectra of all two-body subsystems; angular distributions of all final state particles; distributions in helicity and Jackson frames) are presented for ε= 161 MeV. The total cross sections are proportional to the volume of available three-body phase-space indicating that the transition matrix element does not change significantly in this range of excess energies. It is concluded from the differential data that the reaction proceeds dominantly via the N(1710)P_{11} and/or N(1720)P_{13} resonance(s); N(1650)S_{11} and Δ(1600)P_{33} could also contribute.

preprint2011arXiv

Present Performance of Electron Cooling at Cosy-Jülich

At COSY, electron cooling is used after stripping injection of H- or D- ions in order to prepare phase-space-dense ion beams before acceleration to a requested energy. The electron-cooled beam has been successfully applied for specific external experiments. The achievable beam intensity is limited by instabilities during the cooling process. Besides initial losses after injection, as long as the beam has still large emittances, the self-excitation of coherent betatron oscillations is the dominating beam loss mechanism. Perspectives for possible improvements are briefly addressed.

preprint2010arXiv

Influence of N*-resonances on hyperon production in the channel pp->K+ Lambda p at 2.95, 3.20 and 3.30 GeV/c beam momentum

Hyperon production in the threshold region was studied in the reaction pp -> K+Lp using the time-of-flight spectrometer COSY-TOF. Exclusive data, covering the full phase-space, were taken at the three different beam momenta of p_beam=2.95, 3.20 and 3.30 GeV/c, corresponding to excess energies of epsilon=204, 285 and 316 MeV, respectively. Total cross-sections were deduced for the three beam momenta to be 23.9+/-0.8 +/-2.0 ub, 28.4+/-1.3 +/-2.2 ub and 35.0+/-1.3 +/-3.0 ub. Differential observables including Dalitz plots were obtained. The analysis of the Dalitz plots reveals a strong influence of the N(1650)-resonance at p_beam=2.95 GeV/c, whereas for the higher momenta an increasing relative contribution of the N(1710)- and/or of the N(1720)-resonance was observed. In addition, the pL-final-state interaction turned out to have a significant influence on the Dalitz plot distribution.

preprint2010arXiv

Production of Lambda and Sigma^0 hyperons in proton-proton collisions

This paper reports results on simultaneous measurements of the reaction channels pp -> pK+Λand pp -> pK+Σ^0 at excess energies of 204, 239, and 284 MeV (Λ) and 127, 162, and 207 MeV (Σ^0). Total and differential cross sections are given for both reactions. It is concluded from the measured total cross sections that the high energy limit of the cross section ratio is almost reached at an excess energy of only about 200 MeV. From the differential distributions observed in the overall CMS as well as in the Jackson and helicity frames, a significant contribution of interfering nucleon resonances to the Λproduction mechanism is concluded while resonant Σ^0-production seems to be of lesser importance and takes place only through specific partial waves of the entrance channel. The data also indicate that kaon exchange plays a minor role in the case of Λ- but an important role for Σ^0-production. Thus the peculiar energy dependence of the Λ-to-Σ^0 cross section ratio appears in a new light as its explanation requires more than mere differences between the pΛand the pΣ^0 final state interaction. The data provide a benchmark for theoretical models already available or yet to come.

preprint2010arXiv

Systematic study of the pp -> pp omega reaction

A systematic study of the production of omega-mesons in proton-proton-collisions was carried out in a kinematically complete experiment at three excess energies(epsilon= 92, 128, 173MeV). Both protons were detected using the large-acceptance COSY-TOF spectrometer at an external beam line at the Cooler Synchrotron COSY at Forschungszentrum Jülich. The total cross section, angular distributions of both omega-mesons and protons were measured and presented in various reference frames such as the overall CMS, helicity and Jackson frame. In addition, the orientation of the omega-spin and invariant mass spectra were determined. We observe omega-production to take place dominantly in Ss and Sp final states at epsilon = 92, 128 MeV and, additionally, in Sd at epsilon= 173 MeV. No obvious indication of resonant omega-production via N^*-resonances was found, as proton angular distributions are almost isotropic and invariant mass spectra are compatible with phase space distributions. A dominant role of ^3P_1 and ^1S_0 initial partial waves for omega-production was concluded from the orientation of the decay plane of the omega-meson. Although the Jackson angle distributions in the omega-p-Jackson frame are anisotropic we argue that this is not an indication of a resonance but rather a kinematical effect reflecting the anisotropy of the omega angular distribution. The helicity angle distribution in the omega-p-helicity frame shows an anisotropy which probably reflects effects of the omega angular momenta in the final state; this observable may be, in addition to the orientation of the omega decay plane, the most sensitive one to judge the validity of theoretical descriptions of the production process.