Source author record

Hyuncheol Park

Hyuncheol Park appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

4works
4topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2020arXiv

Design of QAM-FBMC Waveforms Considering MMSE Receiver

Due to its high spectral confinement characteristics and spectral efficiency, QAM-FBMC is considered a candidate waveform to replace CP-OFDM. QAM-FBMC has inevitable non-orthogonality both in time and frequency, and the system and filter must be well-designed to minimize the interferences. However, existing QAM-FBMC studies utilize a matched filter as the receiver filter, which is not suitable for a non-orthogonal system. Therefore, in this paper, we design the prototype filters considering the MMSE criterion, and propose a system providing the highest SINR in QAM-FBMC which cannot avoid non-orthogonality. In addition, we confirm that the proposed filters show best performance at target SNR than the reference filters.

preprint2016arXiv

Beamforming Design for Full-Duplex Two-Way Amplify-and-Forward MIMO Relay

We consider the full-duplex (FD) two-way amplify-and-forward relay system with imperfect cancelation of loopback self-interference (SI) and investigate joint design of relay and receive beamforming for minimizing the mean square error under a relay transmit power constraint. Due to loopback channel estimation error and limitation of analog-to-digital converter, the loopback SI cannot be completely canceled. Multiple antennas at the relay can help loopback SI suppression but beamforming is required to balance between the residual SI suppression and the desired signal transmission. Moreover, the relay beamforming matrix should be updated every time slot because the residual SI in the previous time slot is amplified by the current beamforming matrix and added to the received signals from the two sources in the current time slot. We derive the optimally balanced relay beamforming and receive beamforming matrices in closed form based on minimum mean square error, taking into account the propagation of the residual loopback SI from the first to the current time slot. We also propose beamforming design using only the channels of the m latest time slots, not from the first time slot. Based on our numerical results, we also identify when FD is beneficial and propose selection between FD and half-duplex according to signal-to-noise ratio and interference-to-noise ratio.

preprint2016arXiv

Beamforming for Full-Duplex Multiuser MIMO Systems

We solve a sum rate maximization problem of full-duplex (FD) multiuser multiple-input multiple-output (MU-MIMO) systems. Since additional self-interference (SI) in the uplink channel and co-channel interference (CCI) in the downlink channel are coupled in FD communication, the downlink and uplink multiuser beamforming vectors are required to be jointly designed. However, the joint optimization problem is non-convex and hard to solve due to the coupled effect. To properly address the coupled design issue, we reformulate the problem into an equivalent uplink channel problem, using the uplink and downlink channel duality known as MAC-BC duality. Then, using minorization maximization (MM) algorithm based on an affine approximation, we obtain a solution for the reformulated problem. In addition, without any approximation and thus performance degradation, we develop an alternating algorithm based on iterative water-filling (IWF) to solve the non-convex problem. The proposed algorithms warrant fast convergence and low computational complexity.

preprint2015arXiv

Optimal Fronthaul Compression for Synchronization in the Uplink of Cloud Radio Access Networks

A key problem in the design of cloud radio access networks (CRANs) is that of devising effective baseband compression strategies for transmission on the fronthaul links connecting a remote radio head (RRH) to the managing central unit (CU). Most theoretical works on the subject implicitly assume that the RRHs, and hence the CU, are able to perfectly recover time synchronization from the baseband signals received in the uplink, and focus on the compression of the data fields. This paper instead dose not assume a priori synchronization of RRHs and CU, and considers the problem of fronthaul compression design at the RRHs with the aim of enhancing the performance of time and phase synchronization at the CU. The problem is tackled by analyzing the impact of the synchronization error on the performance of the link and by adopting information and estimationtheoretic performance metrics such as the rate-distortion function and the Cramer-Rao bound (CRB). The proposed algorithm is based on the Charnes-Cooper transformation and on the Difference of Convex (DC) approach, and is shown via numerical results to outperform conventional solutions.