STEM investigation of exsolution lamellae and "c" reflections in Ca-rich dolomite from the Platteville Formation, western Wisconsin
Dolomite crystals in partially dolomitized limestone from the Platteville Formation are both compositionally and microstructurally heterogeneous. A single dolomite crystal usually contains three phases: the host Ca-rich dolomite [Ca1.14Mg0.86(CO3)2], an Fe-bearing dolomite [Ca1.06Mg0.80Fe0.14(CO3)2], and calcite inclusions. These three phases show similar orientations. The Ca-rich dolomite exhibits modulated microstructures with wavelength ranging from 7 to 30 nm. The modulated microstructures are not evident in Fe-bearing dolomite. Modulations in the Ca-rich dolomite have three predominant orientation ranges in the studied sample: from (205) to (104), from (001) to (-101), and ~(110), which are consistent with previous studies. Bright-field (BF) and high-angle annular dark-field (HAADF) images confirm that these modulations are due to chemical variation rather than strain or diffraction contrast. The Ca-rich lamellae are Mg-rich calcite with compositions ranging from Ca0.85Mg0.15CO3 to Ca0.70Mg0.30CO3. The observed results indicate that these Ca-rich exsolution lamellae formed during diagenesis. In this study, three kinds of "c"-reflections, which are weak spots in the halfway position between the principal reflections along the (104)*, (112)*, and (110)* directions, have been found in the diffraction patterns of some Ca-rich dolomite. Mg-Ca ordering in x-y planes was not observed directly in Z-contrast images. FFT patterns from the Z-contrast images do not show "c"-reflections. STEM images confirm that the "c"-reflections could result from multiple diffraction between the host dolomite and twinned Mg-calcite nano-lamellae under TEM imaging and diffraction modes.