Source author record

H. Haas

H. Haas appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

2works
4topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2014arXiv

Inductive measurement of optically hyperpolarized phosphorous donor nuclei in an isotopically-enriched silicon-28 crystal

We experimentally demonstrate the inductive readout of optically hyperpolarized phosphorus-31 donor nuclear spins in an isotopically enriched silicon-28 crystal. The concentration of phosphorus donors in the crystal was 1.5 x 10$^{15}$ cm$^{-3}$, three orders of magnitude lower than has previously been detected via direct inductive detection. The signal-to-noise ratio measured in a single free induction decay from a 1 cm$^3$ sample ($\approx 10^{15}$ spins) was 113. By transferring the sample to an X-band ESR spectrometer, we were able to obtain a lower bound for the nuclear spin polarization at 1.7 K of 64 %. The $^{31}$P-T$_{2}$ measured with a Hahn echo sequence was 420 ms at 1.7 K, which was extended to 1.2 s with a Carr Purcell cycle. The T$_1$ of the $^{31}$P nuclear spins at 1.7 K is extremely long and could not be determined, as no decay was observed even on a timescale of 4.5 hours. Optical excitation was performed with a 1047 nm laser, which provided above bandgap excitation of the silicon. The build-up of the hyperpolarization at 4.2 K followed a single exponential with a characteristic time of 577 s, while the build-up at 1.7 K showed bi-exponential behavior with characteristic time constants of 578 s and 5670 s.

preprint2013arXiv

Practical Implementation of Spatial Modulation

In this work we seek to characterise the performance of spatial modulation (SM) and spatial multiplexing (SMX) with an experimental test bed. Two National Instruments (NI)-PXIe devices are used for the system testing, one for the transmitter and one for the receiver. The digital signal processing that formats the information data in preparation of transmission is described along with the digital signal processing that recovers the information data. In addition, the hardware limitations of the system are also analysed. The average bit error ratio (ABER) of the system is validated through both theoretical analysis and simulation results for SM and SMX under line of sight (LoS) channel conditions.