Source author record

Florent Dalmas

Florent Dalmas appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.soft cond-mat.mtrl-sci

Catalog footprint

What is connected

3works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Optimization of the magnetic properties of aligned Co nanowires/polymer composites for the fabrication of permanent magnets

We aim at combining high coercivity magnetic nanowires in a polymer matrix in a view to fabricate rare--earth free bonded magnets. In particular, our aim is to fabricate anisotropic materials by aligning the wires in the polymer matrix. We have explored the different parameters of the fabrication process in order to produce a material with the best possible magnetic properties. We show that the choice of a proper solvent allows obtaining stable nanowire suspensions. The length and the type of the polymer chains play also an important role. Smaller chains ($M_w < 10000$) provide better magnetization results. The magnetic field applied during the casting of the material plays also a role and should be of the order of a fraction of a tesla. The local order of the nanowires in the matrix has been characterized by TEM and Small Angle Neutron Scattering. The correlation between the local order of the wires and the magnetic properties is discussed. Materials with coercivity $μ_0 H_c$ up to 0.70 $T$ at room temperature have been obtained.

preprint2011arXiv

Tuning the Mechanical Properties in Model Nanocomposites: Influence of the Polymer-Filler Interfacial Interactions

This paper presents a study of the polymer-filler interfacial effects on filler dispersion and mechanical reinforcement in Polystyrene (PS) / silica nanocomposites by direct comparison of two model systems: un-grafted and PS-grafted silica dispersed in PS matrix. The structure of nanoparticles has been investigated by combining Small Angle Neutron Scattering (SANS) measurements and Transmission Electronic Microscopic (TEM) images. The mechanical properties were studied over a wide range of deformation by plate/plate rheology and uni-axial stretching. At low silica volume fraction, the particles arrange, for both systems, in small finite size non-connected aggregates and the materials exhibit a solid-like behavior independent of the local polymer/fillers interactions suggesting that reinforcement is dominated by additional long range effects. At high silica volume fraction, a continuous connected network is created leading to a fast increase of reinforcement whose amplitude is then directly dependent on the strength of the local particle/particle interactions and lower with grafting likely due to deformation of grafted polymer.

preprint2010arXiv

"Wet-to-Dry" Conformational Transition of Polymer Layers Grafted to Nanoparticles in Nanocomposite

The present communication reports the first direct measurement of the conformation of a polymer corona grafted around silica nano-particles dispersed inside a nanocomposite, a matrix of the same polymer. This measurement constitutes an experimental breakthrough based on a refined combination of chemical synthesis, which permits to match the contribution of the neutron silica signal inside the composite, and the use of complementary scattering methods SANS and SAXS to extract the grafted polymer layer form factor from the inter-particles silica structure factor. The modelization of the signal of the grafted polymer on nanoparticles inside the matrix and the direct comparison with the form factor of the same particles in solution show a clear-cut change of the polymer conformation from bulk to the nanocomposite: a transition from a stretched and swollen form in solution to a Gaussian conformation in the matrix followed with a compression of a factor two of the grafted corona. In the probed range, increasing the interactions between the grafted particles (by increasing the particle volume fraction) or between the grafted and the free matrix chains (decreasing the grafted-free chain length ratio) does not influence the amplitude of the grafted brush compression. This is the first direct observation of the wet-to-dry conformational transition theoretically expected to minimize the free energy of swelling of grafted chains in interaction with free matrix chains, illustrating the competition between the mixing entropy of grafted and free chains, and the elastic deformation of the grafted chains. In addition to the experimental validation of the theoretical prediction, this result constitutes a new insight for the nderstanding of the general problem of dispersion of nanoparticles inside a polymer matrix for the design of new nanocomposites materials.