Source author record

Fangze Liu

Fangze Liu appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci physics.app-ph

Catalog footprint

What is connected

2works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2019arXiv

Quantum efficiency enhancement of bialkali photocathodes by an atomically thin layer on substrates

We report quantum efficiency (QE) enhancements in accelerator technology relevant antimonide photocathodes (K2CsSb) by interfacing them with atomically thin two-dimensional (2D) crystal layers. The enhancement occurs in a reflection mode, when a 2D crystal is placed in between the photocathodes and optically reflective substrates. Specifically, the peak QE at 405 nm (3.1 eV) increases by a relative 10 percent, while the long wavelength response at 633 nm (2.0 eV) increases by a relative 36 percent on average and up to 80 percent at localized hot spot regions when photocathodes are deposited onto graphene coated stainless steel. There is a similar effect for photocathodes deposited on hexagonal boron nitride monolayer coatings using nickel substrates. The enhancement does not occur when reflective substrates are replaced with optically transparent sapphire. Optical transmission, X-ray diffraction (XRD) and X-ray fluorescence (XRF) revealed that thickness, crystal orientation, quality and elemental stoichiometry of photocathodes do not appreciably change due to 2D crystal coatings. These results suggest optical interactions are responsible for the QE enhancements when 2D crystal sublayers are present on reflective substrates, and provide a pathway toward a simple method of QE enhancement in semiconductor photocathodes by an atomically thin 2D crystal on substrates.

preprint2015arXiv

Chemical Vapor Deposition Synthesized Atomically Thin Molybdenum Disulfide with Optoelectronic-Grade Crystalline Quality

The ability to synthesize high-quality samples over large areas and at low cost is one of the biggest challenges during the developmental stage of any novel material. While chemical vapor deposition (CVD) methods provide a promising low-cost route for CMOS compatible, large-scale growth of materials, it often falls short of the high-quality demands in nanoelectronics and optoelectronics. We present large-scale CVD synthesis of single- and few- layered MoS2 using direct vapor-phase sulfurization of MoO2, which enables us to obtain extremely high-quality single-crystal monolayer MoS2 samples with field-effect mobility exceeding 30 cm2/Vs in monolayers. These samples can be readily synthesized on a variety of substrates, and demonstrate a high-degree of optoelectronic uniformity in Raman and photoluminescence mapping over entire crystals with areas exceeding hundreds of square micrometers. Owing to their high crystalline quality, Raman spectroscopy on these samples reveal a range of multi-phonon processes through peaks with equal or better clarity compared to past reports on mechanically exfoliated samples. This enables us to investigate the layer thickness- and substrate-dependence of the extremely weak phonon processes at 285 cm-1 and 487 cm-1 in 2D MoS2. The ultra-high, optoelectronic-grade crystalline quality of these samples could be further established through photocurrent spectroscopy, which clearly reveal excitonic states at room temperature, a feat that has been previously demonstrated only on device fabricated with mechanically exfoliated that were artificially suspended across trenches. Our method reflects a big step in the development of atomically thin, 2D MoS2 for scalable, high-quality optoelectronics.