Researcher profile

E. García-Melendo

E. García-Melendo contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
3topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2014arXiv

The EBLM project. II. A very hot, low-mass M dwarf in an eccentric and long period eclipsing binary system from SuperWASP

In this paper, we derive the fundamental properties of 1SWASPJ011351.29+314909.7 (J0113+31), a metal-poor (-0.40 +/- 0.04 dex), eclipsing binary in an eccentric orbit (~0.3) with an orbital period of ~14.277 d. Eclipsing M dwarfs orbiting solar-type stars (EBLMs), like J0113+31, have been identified from WASP light curves and follow-up spectroscopy in the course of the transiting planet search. We present the first binary of the EBLM sample to be fully analysed, and thus, define here the methodology. The primary component with a mass of 0.945 +/- 0.045 Msun has a large radius (1.378 +/- 0.058 Rsun) indicating that the system is quite old, ~9.5 Gyr. The M-dwarf secondary mass of 0.186 +/- 0.010 Msun and radius of 0.209 +/- 0.011 Rsun are fully consistent with stellar evolutionary models. However, from the near-infrared secondary eclipse light curve, the M dwarf is found to have an effective temperature of 3922 +/- 42 K, which is ~600 K hotter than predicted by theoretical models. We discuss different scenarios to explain this temperature discrepancy. The case of J0113+31 for which we can measure mass, radius, temperature and metallicity, highlights the importance of deriving mass, radius and temperature as a function of metallicity for M dwarfs to better understand the lowest mass stars. The EBLM Project will define the relationship between mass, radius, temperature and metallicity for M dwarfs providing important empirical constraints at the bottom of the main sequence.

preprint2010arXiv

The impact of a large object with Jupiter in July 2009

On 2009 July 19, we observed a single, large impact on Jupiter at a planetocentric latitude of 55^{\circ}S. This and the Shoemaker-Levy 9 (SL9) impacts on Jupiter in 1994 are the only planetary-scale impacts ever observed. The 2009 impact had an entry trajectory opposite and with a lower incidence angle than that of SL9. Comparison of the initial aerosol cloud debris properties, spanning 4,800 km east-west and 2,500 km north-south, with those produced by the SL9 fragments, and dynamical calculations of pre-impact orbit, indicate that the impactor was most probably an icy body with a size of 0.5-1 km. The collision rate of events of this magnitude may be five to ten times more frequent than previously thought. The search for unpredicted impacts, such as the current one, could be best performed in 890-nm and K (2.03-2.36 μm) filters in strong gaseous absorption, where the high-altitude aerosols are more reflective than Jupiter's primary cloud.

preprint2005arXiv

Detection of a classical Delta Scuti star in the new eclipsing binary system HIP 7666

HIP 7666 is a variable star newly discovered during the Hipparcos mission and classified as of unknown type (ESA 1997). During 23 nights between July 2000 and November 2000, over 2300 CCD observations in the V band were obtained from Hostalets de Pierola and Monegrillo observatories in Spain. These data show that the new variable is a detached eclipsing binary system with an orbital period of 2.37229 days. In addition, one of the components undergoes very short-period oscillations with a main pulsation frequency of 24.46 or 25.47 c/d. HIP 7666 is therefore a new member of the presently very few known detached eclipsing binary systems with a Delta Scuti type component.