Source author record

Dayne E. Fratanduono

Dayne E. Fratanduono appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci hep-ex physics.app-ph physics.comp-ph physics.geo-ph physics.plasm-ph

Catalog footprint

What is connected

4works

6topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Development of slurry targets for high repetition-rate XFEL experiments

Combining an x-ray free electron laser (XFEL) with high power laser drivers enables the study of phase transitions, equation-of-state, grain growth, strength, and transformation pathways as a function of pressure to 100s GPa along different thermodynamic compression paths. Future high-repetition rate laser operation will enable data to be accumulated at >1 Hz which poses a number of experimental challenges including the need to rapidly replenish the target. Here, we present a combined shock-compression and X-ray diffraction study on vol% epoxy(50)-crystalline grains(50) (slurry) targets, which can be fashioned into extruded ribbons for high repetition-rate operation. For shock-loaded NaCl-slurry samples, we observe pressure, density and temperature states within the embedded NaCl grains consistent with observations for shock-compressed single-crystal NaCl.

preprint2021arXiv

Quantitative analysis of diffraction by liquids using a pink-spectrum X-ray source

We describes a new approach for performing quantitative structure-factor analysis and density measurements of liquids using x-ray diffraction with a pink-spectrum x-ray source. The methodology corrects for the pink beam effect by performing a Taylor series expansion of the diffraction signal. The mean density, background scale factor, peak x-ray energy about which the expansion is performed, and the cutoff radius for density measurement are estimated using the derivative-free optimization scheme. The formalism is demonstrated for a simulated radial distribution function for tin. Finally, the proposed methodology is applied to experimental data on shock compressed tin recorded at the Dynamic Compression Sector at the Advanced Photon Source, with derived densities comparing favorably to other experimental results and the equations of state of tin.

preprint2018arXiv

Non-Iterative Characteristics Analysis for High-Pressure Ramp Loading

In the canonical ramp compression experiment, a smoothly-increasing load is applied to the surface of the sample, and the particle velocity history is measured at two or more different distances into the sample, at interfaces where the surface of the sample can be probed. The velocity histories are used to deduce a stress-density relation, usually using iterative Lagrangian analysis to account for the perturbing effect of the impedance mismatch at the interface. In that technique, a stress- density relation is assumed in order to correct for the perturbation, and is adjusted until it becomes consistent with the deduced stress-density relation. This process is subject to the usual difficulties of nonlinear optimization, such as the existence of local minima (sensitivity to the initial guess), possible failure to converge, and relatively large computational effort. We show that, by considering the interaction of successive characteristics reaching the interfaces, the stress-density relation can be deduced directly by recursion rather than iteration. This calculation is orders of magnitude faster than iterative analysis, and does not require an initial guess. Direct recursion may be less suitable for very noisy data, but it was robust when applied to trial data. The stress-density relation deduced was identical to the result from iterative Lagrangian analysis.

preprint2015arXiv

Analysis of laser shock experiments on precompressed samples using a quartz reference and application to warm dense hydrogen and helium

Megabar (1 Mbar = 100 GPa) laser shocks on precompressed samples allow reaching unprecedented high densities and moderately high 10000-100000K temperatures. We describe here a complete analysis framework for the velocimetry (VISAR) and pyrometry (SOP) data produced in these experiments. Since the precompression increases the initial density of both the sample of interest and the quartz reference for pressure-density, reflectivity and temperature measurements, we describe analytical corrections based on available experimental data on warm dense silica and density-functional-theory based molecular dynamics computer simulations. Using our improved analysis framework we report a re-analysis of previously published data on warm dense hydrogen and helium, compare the newly inferred pressure, density and temperature data with most advanced equation of state models and provide updated reflectivity values.