Source author record

Christian Ligoure

Christian Ligoure appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.soft physics.flu-dyn cond-mat.mtrl-sci

Catalog footprint

What is connected

10works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

Biaxial extensional viscous dissipation in sheets expansion formed by impact of drops of Newtonian and non-Newtonian fluids

We investigate freely expanding liquid sheets made of either simple Newtonian fluids or solutions of high molecular water-soluble polymer chains. A sheet is produced by the impact of a drop on a quartz plate covered with a thin layer of liquid nitrogen that suppresses shear viscous dissipation thanks to an inverse Leidenfrost effect. The sheet expands radially until reaching a maximum diameter and subsequently recedes. Experiments indicate the presence of two expansion regimes: the capillary regime, where the maximum expansion is controlled by surface tension forces and does not depend on the viscosity, and the viscous regime, where the expansion is reduced with increasing viscosity. In the viscous regime, the sheet expansion for polymeric samples is strongly enhanced as compared to that of Newtonian samples with comparable zero-shear viscosity. We show that data for Newtonian and non-Newtonian fluids collapse on a unique master curve where the maximum expansion factor is plotted against the relevant effective biaxial extensional Ohnesorge number that depends on fluid density, surface tension and the biaxial extensional viscosity. For Newtonian fluids, this biaxial extensional viscosity is six times the shear viscosity. By contrast, for the non- Newtonian fluids, a characteristic Weissenberg number-dependent biaxial extensional viscosity is identified, which is in quantitative agreement with experimental and theoretical results reported in the literature for biaxial extensional flows of polymeric liquids.

preprint2020arXiv

Spinning elastic beads: a route for simultaneous measurements of shear modulus and interfacial energy of soft materials

Large deformations of soft elastic beads spinning at high angular velocity in a denser background fluid are investigated theoretically, numerically, and experimentally using millimeter-size polyacrylamide hydrogel particles introduced in a spinning drop tensiometer. We determine the equilibrium shapes of the beads from the competition between the centrifugal force and the restoring elastic and surface forces. Considering the beads as neo-Hookean up to large deformations, we show that their elastic modulus and surface energy constant can be simultaneously deduced from their equilibrium shape. Also, our results provide further support to the scenario in which surface energy and surface tension coincide for amorphous polymer gels.

preprint2017arXiv

Interplay between viscosity and elasticity in freely expanding liquid sheets

We investigate the dynamics of freely expanding liquid sheets prepared with fluids with different rheological properties, (i) viscous fluids with a zero-shear viscosity $η_0$ in the range $(1-1000) \, \mathrm{mPa.s}$ and (ii) viscoelastic Maxwell fluids whose elastic modulus, $G_0$, characteristic relaxation time, $τ$, and zero-shear viscosity, $η_0=G_0 τ$, can be tuned over several orders of magnitude. The sheets are produced by impacting a drop of fluid on a small cylindrical solid target. For viscoelastic fluids, we show that, when $τ$ is shorter than the typical lifetime of the sheet ($\sim 10$ ms), the dynamics of the sheet is similar to that of Newtonian viscous liquids with equal zero-shear viscosity. In that case, for little viscous samples ($η_0 <\sim 30$ mPa.s), the maximal expansion of the sheet, $d_{\rm{max}}$, is independent of $η_0$, whereas for more viscous samples, $d_{\rm{max}}$ decreases as $η_0$ increases. We provide a simple model to account for the dependence of the maximal expansion of the sheet with the viscosity that is based on an energy balance between inertia, surface tension and viscous shear dissipation on the solid target, and which accounts well for our experimental data. By contrast, when $τ$ is longer than the typical lifetime of the sheet, the behavior drastically differs. The sheet expansion is strongly enhanced as compared to that of viscous samples with comparable zero-shear viscosity, but is heterogeneous with the occurrence of cracks, revealing the elastic nature of the viscoelastic fluid.

preprint2016arXiv

Rearrangement zone around a crack tip in a double self-assembled transient network

We investigate the nucleation and propagation of cracks in self-assembled viscoelastic fluids, which are made of surfactant micelles reversibly linked by telechelic polymers. The morphology of the micelles can be continuously tuned, from spherical to rod-like to wormlike, thus producing transient double networks when the micelles are sufficiently long and entangled, and transient single networks otherwise. For a single network, we show that cracks nucleate when the sample deformation rate involved is comparable to the relaxation time scale of the network. For a double network, by contrast, significant rearrangements of the micelles occur as a crack nucleates and propagates. We show that birefringence develops at the crack tip over a finite length, $ξ$, which corresponds to the length scale over which micelles alignment occur. We find that $ξ$ is larger for slower cracks, suggesting an increase of ductility.

preprint2015arXiv

Bursting of Dilute Emulsion-Based Liquid Sheets Driven by a Marangoni Effect

We study the destabilization mechanism of thin liquid sheets expanding in air and show that dilute oil-in-water emulsion-based sheets disintegrate through the nucleation and growth of holes that perforate the sheet. The velocity and thickness fields of the sheet outside the holes are not perturbed by holes and hole opening follows a Taylor-Culick law. We find that a pre-hole, which widens and thins out the sheet with time, systematically precedes the hole nucleation. The growth dynamics of the pre-hole follows the law theoretically predicted for a liquid spreading on another liquid of higher surface tension due to Marangoni stresses. Classical Marangoni spreading experiments quantitatively corroborate our findings.

preprint2014arXiv

Free radially expanding liquid sheet in air: time- and space-resolved measurement of the thickness field

The collision of a liquid drop against a small target results in the formation of a thin liquid sheet that extends radially until it reaches a maximum diameter. The subsequent retraction is due to the air-liquid surface tension. We have used a time- and space-resolved technique to measure the thickness field of this class of liquid sheet, based on the grey level measurement of the image of a dyed liquid sheet recorded using a fast camera. This method enables a precise measurement of the thickness in the range $(10-450) \, \mathrm{μm}$, with a temporal resolution equal to that of the camera. We have measured the evolution with time since impact, $t$, and radial position, $r$, of the thickness, $h(r,t)$, for various drop volumes and impact velocities. Two asymptotic regimes for the expansion of the sheet are evidenced. The scalings of the thickness with $t$ and $r$ measured in the two regimes are those that were predicted in \citet{Rozhkov2004} fort the short-time regime and \citet{Villermaux2011} for the long time regime, but never experimentally measured before. Interestingly, our experimental data also evidence the existence of a maximum of the film thickness $h_{\rm{max}}(r)$ at a radial position $r_{\rm{h_{max}}}(t)$ corresponding to the crossover of these two asymptotic regimes. The maximum moves with a constant velocity of the order of the drop impact velocity, as expected theoretically. Thanks to our visualization technique, we also evidence an azimuthal thickness modulation of the liquid sheets.

preprint2013arXiv

Fingering to fracturing transition in a transient gel

Fracture processes are ubiquitous in soft materials, even in complex fluids, subjected to stresses. To investigate these processes in a simple geometry, we use a model self-assembled transient gel and study the instability patterns obtained in a radial Hele-Shaw cell when a low viscosity oil pushes the more viscous transient gel. Thanks to an analysis of the morphology of the patterns, we find a discontinuous transition between the standard Saffman-Taylor fingering instability and a fracturing instability as the oil injection rate increases. Our data suggest that the flow properties of the gel ahead of the finger tip controls the transition towards fracturing. By analyzing the displacement field of the gel in the vicinity of the fingers and cracks, we show that in the fingering regime, the oil gently pushes the gel, whereas in the fracturing regime, the crack tears apart the gel, resulting in a strong drop of the gel velocity ahead of the crack tip as compared to the tip velocity. We find a unique behavior for the whole displacement field of a gel around a crack, which is drastically different from that around a finger, and reveals the solid-like behavior of the gel at short time. Our experiments and analysis provide quantitative yet simple tools to unambiguously discriminate a finger from a crack in a visco-elastic material.

preprint2013arXiv

Fractures in complex fluids: the case of transient networks

We present a comprehensive review of the current state of fracture phenomena in transient networks, a wide class of viscoelastic fluids. We will first define what is a fracture in a complex fluid, and recall the main structural and rheological properties of transient networks. Secondly, we review experimental reports on fractures of transient networks in several configurations: shear-induced fractures, fractures in Hele-Shaw cells and fracture in extensional geometries (filament stretching rheometry and pendant drop experiments), including fracture propagation. The tentative extension of the concepts of brittleness and ductility to the fracture mechanisms in transient networks is also discussed. Finally, the different and apparently contradictory theoretical approaches developed to interpret fracture nucleation will be addressed and confronted to experimental results. Rationalized criteria to discriminate the relevance of these different models will be proposed.

preprint2012arXiv

Structural Signature of a Brittle-to-Ductile Transition in Self-Assembled Networks

We study the nonlinear rheology of a novel class of transient networks, made of surfactant micelles of tunable morphology reversibly linked by block copolymers. We couple rheology and time-resolved structural measurements, using synchrotron radiation, to characterize the highly nonlinear viscoelastic regime. We propose the fluctuations of the degree of alignment of the micelles under shear as a probe to identify a fracture process. We show a clear signature of a brittle-to-ductile transition in transient gels, as the morphology of the micelles varies, and provide a parallel between the fracture of solids and the fracture under shear of viscoelastic fluids.

preprint2001arXiv

Inwardly curved polymer brushes : Concave is not like Convex

Inwardly curved polymer brushes are present in cylindrical and spherical micelles or in membranes tubes and vesicles decorated with anchored polymers, and influence their stability. We consider such polymer brushes in good solvent and show that previous works, based on a self-similar concentric structure of the brush, are physically inconsistent. We use scaling laws to derive very simply the leading term of the free energy in the high curvature limit, where the osmotic pressure is the relevant physical ingredient. We also derive the complete conformation at all curvatures using a self-consistent field approach. The free energy is computed therefrom using a local scaling description.