Researcher profile

Carlos L. Garrido Alzar

Carlos L. Garrido Alzar contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

quant-ph cond-mat.other physics.atom-ph

Trust snapshot

Quick read

Trust 17 - Baseline

4works

0followers

3topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Cold-atom Inertial Sensor without Deadtime

We report the operation of a cold-atom inertial sensor in a joint interrogation scheme, where we simultaneously prepare a cold-atom source and operate an atom interferometer in order to eliminate dead times. Noise aliasing and dead times are consequences of the sequential operation which is intrinsic to cold-atom atom interferometers. Both phenomena have deleterious effects on the performance of these sensors. We show that our continuous operation improves the short-term sensitivity of atom interferometers, by demonstrating a record rotation sensitivity of $100$ nrad.s$^{-1}/\sqrt{\rm Hz}$ in a cold-atom gyroscope of $11$ cm$^2$ Sagnac area. We also demonstrate a rotation stability of $1$ nrad.s$^{-1}$ after $10^4$ s of integration, improving previous results by an order of magnitude. We expect that the continuous operation will allow cold-atom inertial sensors with long interrogation time to reach their full sensitivity, determined by the quantum noise limit.

preprint2010arXiv

Limitation of the modulation method to smooth wire guide roughness

It was recently demonstrated that wire guide roughness can be suppressed by modulating the wire currents so that the atoms experience a time-averaged potential without roughness. We theoretically study the limitations of this technique. At low modulation frequency, we show that the longitudinal potential modulation produces a heating of the cloud and we compute the heating rate. We also give a quantum derivation of the rough conservative potential associated with the micro-motion of the atoms. At large modulation frequency, we compute the loss rate due to non adiabatic spin flip and show it presents resonnances at multiple modulation frequencies. These studies show that the modulation technique works for a wide range of experimental parameters. We also give conditions to realise radio-frequency evaporative cooling in such a modulated trap.

preprint2007arXiv

Continuous transfer and laser guiding between two cold atom traps

We have demonstrated and modeled a simple and efficient method to transfer atoms from a first Magneto-Optical Trap (MOT) to a second one. Two independent setups, with cesium and rubidium atoms respectively, have shown that a high power and slightly diverging laser beam optimizes the transfer between the two traps when its frequency is red-detuned from the atomic transition. This pushing laser extracts a continuous beam of slow and cold atoms out of the first MOT and also provides a guiding to the second one through the dipolar force. In order to optimize the transfer efficiency, the dependence of the atomic flux on the pushing laser parameters (power, detuning, divergence and waist) is investigated. The atomic flux is found to be proportional to the first MOT loading rate. Experimentally, the transfer efficiency reaches 70%, corresponding to a transfer rate up to 2.7x10^8 atoms/s with a final velocity of 5.5 m/s. We present a simple analysis of the atomic motion inside the pushing-guiding laser, in good agreement with the experimental data.

preprint2006arXiv

Non-destructive interferometric characterization of an optical dipole trap

A method for non-destructive characterization of a dipole trapped atomic sample is presented. It relies on a measurement of the phase-shift imposed by cold atoms on an optical pulse that propagates through a free space Mach-Zehnder interferometer. Using this technique we are able to determine, with very good accuracy, relevant trap parameters such as the atomic sample temperature, trap oscillation frequencies and loss rates. Another important feature is that our method is faster than conventional absorption or fluorescence techniques, allowing the combination of high-dynamical range measurements and a reduced number of spontaneous emission events per atom.