Importance of strain reduction in improvement of optical transmission and conductance in Si4+ doped ZnO: a probable new moisture resistant Transparent Conductive Oxide
Si doped ZnO has been reported to be a better conductor than pure ZnO. It is reported that carrier density increases and hence conductivity increases. However, the effect on optical transmission is yet not clear until our recent report [1]. Zn1-xSixO for x= 0, 0.013, 0.020 and 0.027 have been synthesized using sol-gel method (a citric acid-glycerol route) followed by solid state sintering. We found that there is a decrease in defect states due to Si doping. The correlation of strain to the decrement in vacancy sites is discussed in this report. In modern electronics and solar cell fabrication, transparent conductive oxides (TCOs) are important components which conduct electrically without absorbing visible light. Known TCOs are extremely costly and are composed of non-abundant elements. Search for new ecofriendly, cheap and sustainable TCOs has been a recent research of attraction. Keeping in mind that most solar cells are exposed to natural conditions, the humidity tolerance becomes a determining factor. We report that sensitivity to moisture decreases drastically while the conductivity and optical transparency increases with doping. The reduction of strain and improvement of transport properties results in increased conductivity of Si doped ZnO pellets, tempting us to envisage this material as a probable alternate TCO.