Researcher profile

Anthony H. Minter

Anthony H. Minter contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 17 - Baseline
4works
0followers
4topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2015arXiv

The structure function of Galactic \HI opacity fluctuations on AU scales based on MERLIN, VLA and VLBA data

We use MERLIN, VLA and VLBA observations of Galactic \HI absorption towards 3C~138 to estimate the structure function of the \HI opacity fluctuations at AU scales. Using Monte Carlo simulations, we show that there is likely to be a significant bias in the estimated structure function at signal-to-noise ratios characteristic of our observations, if the structure function is constructed in the manner most commonly used in the literature. We develop a new estimator that is free from this bias and use it to estimate the true underlying structure function slope on length scales ranging $5$ to $40$~AU. From a power law fit to the structure function, we derive a slope of $0.81^{+0.14}_{-0.13}$, i.e. similar to the value observed at parsec scales. The estimated upper limit for the amplitude of the structure function is also consistent with the measurements carried out at parsec scales. Our measurements are hence consistent with the \HI opacity fluctuation in the Galaxy being characterized by a power law structure function over length scales that span six orders of magnitude. This result implies that the dissipation scale has to be smaller than a few AU if the fluctuations are produced by turbulence. This inferred smaller dissipation scale implies that the dissipation occurs either in (i) regions with densities $\gtrsim 10^3 $cm$^-3$ (i.e. similar to that inferred for "tiny scale" atomic clouds or (ii) regions with a mix of ionized and atomic gas (i.e. the observed structure in the atomic gas has a magneto-hydrodynamic origin).

preprint2012arXiv

RRI-GBT Multi-Band Receiver: Motivation, Design & Development

We report the design and development of a self-contained multi-band receiver (MBR) system, intended for use with a single large aperture to facilitate sensitive & high time-resolution observations simultaneously in 10 discrete frequency bands sampling a wide spectral span (100-1500 MHz) in a nearly log-periodic fashion. The development of this system was primarily motivated by need for tomographic studies of pulsar polar emission regions. Although the system design is optimized for the primary goal, it is also suited for several other interesting astronomical investigations. The system consists of a dual-polarization multi-band feed (with discrete responses corresponding to the 10 bands pre-selected as relatively RFI-free), a common wide-band RF front-end, and independent back-end receiver chains for the 10 individual sub-bands. The raw voltage time-sequences corresponding to 16 MHz bandwidth each for the two linear polarization channels and the 10 bands, are recorded at the Nyquist rate simultaneously. We present the preliminary results from the tests and pulsar observations carried out with the Green Bank Telescope using this receiver. The system performance implied by these results, and possible improvements are also briefly discussed.

preprint2012arXiv

Tiny scale opacity fluctuations from VLBA, MERLIN and VLA observations of HI absorption toward 3C 138

The structure function of opacity fluctuations is a useful statistical tool to study tiny scale structures of neutral hydrogen. Here we present high resolution observation of HI absorption towards 3C 138, and estimate the structure function of opacity fluctuations from the combined VLA, MERLIN and VLBA data. The angular scales probed in this work are ~ 10-200 milliarcsec (about 5-100 AU). The structure function in this range is found to be well represented by a power law S_tau(x) ~ x^{beta} with index beta ~ 0.33 +/- 0.07 corresponding to a power spectrum P_tau(U) ~ U^{-2.33}. This is slightly shallower than the earlier reported power law index of ~ 2.5-3.0 at ~ 1000 AU to few pc scales. The amplitude of the derived structure function is a factor of ~ 20-60 times higher than the extrapolated amplitude from observation of Cas A at larger scales. On the other hand, extrapolating the AU scale structure function for 3C 138 predicts the observed structure function for Cas A at the pc scale correctly. These results clearly establish that the atomic gas has significantly more structures in AU scales than expected from earlier pc scale observations. Some plausible reasons are identified and discussed here to explain these results. The observational evidence of a shallower slope and the presence of rich small scale structures may have implications for the current understanding of the interstellar turbulence.

preprint2005arXiv

Limits on Turbulent HI Fluctuations Towards PSR B0329+54 On Scales Between 0.0025 and 12.5 AU

We have measured the HI absorption towards pulsar B0329+54 using the Green Bank Telescope during 18 epochs between 2002 June 30 and 2003 October 10. Three observing epochs consisted of a continuous period of 20 hours each, while fifteen epochs were 1-2 hours each. We calculate the structure function of HI absorption variations toward the pulsar on time scales of 10 minutes to 16 months which, using the proper motion of 95 km/s and the parallactic distance of 1.03 kpc measured towards B0329+54 (Brisken et al. 2002), corresponds to angular scales of 0.37 micro-arcseconds to 23.8 milli-arseconds and samples structures between 0.0025-12.5 AU assuming HI gas half way to the pulsar and ignoring scintillation effects. We find no evidence for any turbulent HI absorption fluctuations towards B0329+54, with the following upper limits on the change in opacity for various absorption features: 0.026 at -31, -21, -18, and +4 km/s, 0.12 at -11 km/s, and 0.055 at -1 km/s.