Source author record

Anderson Caproni

Anderson Caproni appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

astro-ph.GA astro-ph.CO astro-ph.HE astro-ph astro-ph.IM astro-ph.SR gr-qc

Catalog footprint

What is connected

9works

7topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Parameterizing the Outflow from a Central Black Hole in Dwarf Spheroidal Galaxies: A 3D Hydrodynamic Simulation

Large galaxies harbor massive central black holes and their feedback causes a substantial impact in their evolution. Recently, observations suggested that dwarf galaxies might host black holes in their centers, but with lower masses (intermediate-mass black holes - IMBH). The impact of such IMBHs on the evolution of the dwarf spheroidal galaxies (dSphs), however, has not been so far properly analysed. In this work, we investigate the effects of an outflow from an IMBH on the gas dynamics in dSph galaxies by means of non-cosmological, three-dimensional hydrodynamic simulations, letting the galactic gas distribution evolve over 3 Gyr under the influence of the IMBH's outflow and supernova feedback. All simulations have a numerical resolution of 20.0 pc cell$^{-1}$. Two scenarios are considered to infer the differences in the propagation of the outflow, one with a homogeneous ISM and another one with inhomogeneities caused by supernovae feedback. A minimal initial speed and a minimal initial density are required for the outflow to propagate, with the values depending on the conditions of the medium. In an unperturbed medium, the outflow propagates freely in both directions with the same velocity (lower than the initial one), removing a small fraction of the gas from the galaxy (the exact fraction depends on the initial physical conditions of the outflow). However, in an inhomogeneous ISM, the impact of the outflow is substantially reduced, and its contribution to the removal of gas from the galaxy is almost negligible.

preprint2022arXiv

Simulating nearly edge-on sloshing in the galaxy cluster Abell 2199

Off-axis collisions between galaxy clusters may induce the phenomenon of sloshing, causing dense gas to be dragged from the cool core of a cluster, resulting in a spiral of enhanced X-ray emission. Abell 2199 displays signatures of sloshing in its core and it is possible that the orbital plane of the collision is seen nearly edge-on. We aim to evaluate whether the features of Abell 2199 can be explained by a sloshing spiral seen under a large inclination angle. To address this, we perform tailored hydrodynamical $N$-body simulations of a non-frontal collision with a galaxy group of $M_{200}=1.6\times10^{13}\,{\rm M_{\odot}}$. We obtain a suitable scenario in which the group passed by the main cluster core 0.8 Gyr ago, with a pericentric separation of 292 kpc. Good agreement is obtained from the temperature maps as well as the residuals from a $β$-model fit to the simulated X-ray emission. We find that under an inclination of $i=70^{\circ}$ the simulation results remain consistent with the observations.

preprint2015arXiv

Three-dimensional hydrodynamical simulations of the supernovae-driven gas loss in the dwarf spheroidal galaxy Ursa Minor

As is usual in dwarf spheroidal galaxies, today the Local Group galaxy Ursa Minor is depleted of its gas content. How this galaxy lost its gas is still a matter of debate. To study the history of gas loss in Ursa Minor, we conducted the first three-dimensional hydrodynamical simulations of this object, assuming that the gas loss was driven by galactic winds powered only by type II supernovae (SNe II). The initial gas setup and supernova (SN) rates used in our simulations are mainly constrained by the inferred star formation history and the observed velocity dispersion of Ursa Minor. After 3 Gyr of evolution, we found that the gas removal efficiency is higher when the SN rate is increased, and also when the initial mean gas density is lowered. The derived mass-loss rates are systematically higher in the central regions (<300 pc), even though such a relationship has not been strictly linear in time and in terms of the galactic radius. The filamentary structures induced by Rayleigh-Taylor instabilities and the concentric shells related to the acoustic waves driven by SNe can account for the inferred mass losses from the simulations. Our results suggest that SNe II are able to transfer most of the gas from the central region outward to the galactic halo. However, other physical mechanisms must be considered in order to completely remove the gas at larger radii.

preprint2014arXiv

ALiCCE: Atomic Lines Calibration using the Cross-Entropy Algorithm

Atomic line opacities play a crucial role in stellar astrophysics. They strongly modify the radiative transfer in stars, therefore impacting their physical structure. Ultimately, most of our knowledge of stellar population systems (stars, clusters, galaxies, etc.) relies on the accuracy with which we understand and reproduce the stellar spectra. With such a wide impact on Astronomy, it would be ideal to have access to a complete, accurate and precise list of atomic transitions. This, unfortunately, is not the case. Few atomic transitions had their parameters actually measured in the laboratory, and for most of the lines the parameters were calculated with low precision atomic energy levels. Only a small fraction of the lines were calibrated empirically. For the purpose of computing a stellar spectral grid with a complete coverage of spectral types and luminosity classes, this situation is rather limiting. We have implemented an innovative method to perform a robust calibration of atomic line lists used by spectral synthesis codes called ALiCCE: Atomic Lines Calibration using the Cross-Entropy algorithm. Here we describe the implementation and validation of the method, using synthetic spectra which simulates the signal-to-noise, spectral resolution and rotational velocities typical of high quality observed spectra. We conclude that the method is efficient for calibrating atomic line lists.

preprint2014arXiv

Kinematic study of the parsec-scale jet of the quasar PKS 1741--03

We present 23 interferometric images of parsec-scale jet of the quasar PKS 1741--03 at 15, 24 and 43 GHz spanning about 13 yr. We model the images as a superposition of discrete two--dimensional elliptical Gaussian components, with parameters determined by the cross--entropy technique. All the images present a spatially unresolved component (core) and usually two or three components receding from it. The same components were found in simultaneous 24 and 43 GHz maps, showing the robustness of our model-fitting. The core-shift opacity effect between these frequencies is weak. We have identified seven components moving along straight lines at constant apparent superluminal speeds ($3.5\leβ_\mathrm{obs}\le 6.1$), with different sky position angles ($-186°\le η\le -125°$). The core flux density tracks quite well the fluctuations seen in the historical single-dish light curve at 14.5 GHz, with no measurable delay. The total flux density from the moving jet components is delayed $\sim$2 yr in relation to the core light curve, roughly the same as the lag between the ejection epoch and the maximum flux density in the light curves of the jet components. We propose that there are three non-exclusive mechanisms for producing these delays. From the kinematics of the most robust jet components and the core brightness temperature, we determined the bulk Lorentz factor ($4.8\leγ\le 24.5$) and the jet viewing angle ($0.°35 \le θ\le 4.°2$); these values agree with previous estimates from the spectral energy distribution of PKS 1741--03 and its radio variability.

preprint2012arXiv

Parsec-scale jet precession in BL Lacertae (2200+420)

BL Lacertae is the prototype of the BL Lac class of active galactic nuclei, exhibiting intensive activity on parsec (pc) scales, such as intense core variability and multiple ejections of jet components. In particular, in previous works the existence of precession motions in the pc-scale jet of BL Lacertae has been suggested. In this work we revisit this issue, investigating temporal changes of the observed right ascension and declination offsets of the jet knots in terms of our relativistic jet-precession model. The seven free parameters of our precession model were optimized via a heuristic cross-entropy method, comparing the projected precession helix with the positions of the jet components on the plane of the sky and imposing constraints on their maximum and minimum superluminal velocities. Our optimized best model is compatible with a jet having a bulk velocity of 0.9824c, which is precessing with a period of about 12.1 yr in the observer's reference frame and changing its orientation in relation to the line of sight between 4 and 5 degrees, approximately. Assuming that the jet precession has its origin in a supermassive binary black hole system, we show that the 2.3-yr periodic variation in the structural position angle of the very-long-baseline interferometry (VLBI) core of BL Lacertae reported by Stirling et al. is compatible with a nutation phenomenon if the secondary black hole has a mass higher than about six times that of the primary black hole.

preprint2012arXiv

The mass loss process in dwarf galaxies from 3D hydrodynamical simulations: the role of dark matter and starbursts

Theoretical $Λ$CDM cosmological models predict a much larger number of low mass dark matter haloes than has been observed in the Local Group of galaxies. One possible explanation is the increased difficulty of detecting these haloes if most of the visible matter is lost at early evolutionary phases through galactic winds. In this work we study the current models of triggering galactic winds in dwarf spheroidal galaxies (dSph) from supernovae, and study, based on 3D hydrodynamic numerical simulations, the correlation of the mass loss rates and important physical parameters as the dark matter halo mass and its radial profile, and the star formation rate. We find that the existence of winds is ubiquitous, independent on the gravitational potential. Our simulations revealed that the Rayleigh-Taylor Instability (RTI) may play a major role on pushing matter out of these systems, even for very massive haloes. The instability is responsible for 5 - 40% of the mass loss during the early evolution of the galaxy, being less relevant at $t > 200$Myrs. There is no significant difference in the mass loss rates obtained for the different dark matter profiles studied (NFW and logarithmic). We have also found a correlation between the mass loss rate and both the halo mass and the rate of supernovae, as already reported in previous works. Besides, the epoch in which most of the baryon galactic matter is removed from the galaxy varies depending on the SN rate and gravitational potential. The later, combined to the importance of the RTI in each model, may change our understanding about the chemical evolution of dwarf galaxies, as well as in the heavy element contamination of the intergalactic medium at high redshifts.

preprint2011arXiv

Modeling very long baseline interferometric images with the cross-entropy global optimization technique

We present a new technique for obtaining model fittings to VLBI images of astrophysical jets. The method minimizes a performance function proportional to the sum of the squared difference between the model and observed images. The model image is constructed by summing elliptical Gaussian sources characterized by six parameters: two-dimensional peak position, peak intensity, eccentricity, amplitude and orientation angle of the major axis. We present results for the fitting of two main benchmark jets: the first, constructed from three individual Gaussian sources, the second formed by five Gaussian sources. Both jets were analyzed by our cross-entropy technique in finite and infinite signal-to-noise regimes, the background noise chosen to mimic that found in interferometric radio maps. We show that our technique is capable of recovering the parameters of the sources with a similar accuracy to that obtained from the traditional AIPS task IMFIT when the image is relatively simple (e.g., few components). For more complex maps, our method displays superior performance in recovering the parameters of the jet components. Our methodology is also able to show quantitatively the number of individual components present in an image. An additional application of the cross-entropy technique to a real image of a BL Lac object is shown and discussed. Our results indicate that our cross-entropy technique must be used in situations involving the analysis of complex emission regions having more than three sources, even though it is substantially slower than current model fitting tasks (at least 10,000 times slower for a single processor, depending on the number of sources to be optimized). As in the case of any model fitting performed in the image plane, caution is required in analyzing images constructed from a poorly sampled (u,v) plane.

preprint2004arXiv

Observational evidence of spin-induced precession in active galactic nuclei

We show that it is possible to explain the physical origin of jet precession in active galactic nuclei (AGNs) through the misalignment between the rotation axes of the accretion disk and of the Kerr black hole. We apply this scenario to quasars, Seyfert galaxies and also to the Galactic Center black hole Sgr A*, for which signatures of either jet or disk precession have been found. The formalism adopted is parameterized by the ratio of the precession period to the black hole mass and can be used to put constraints to the physical properties of the accretion disk as well as to the black hole spin in those systems.